CarProblemsDB

2003 GMC Yukon XL 2500 problems, recalls & MPG

NHTSA has received 9 complaints from owners of the 2003 GMC Yukon XL 2500, most often about the electrical system. There is 1 safety recall for this model year.

6.3out of 10
Our verdict
Average
  • More complaints than 18% of 2003 vehicles
  • Most reported problem: electrical system (56% of complaints)
  • 1 safety recall
  • 1 crash reported
How we score
Complaints9
Recalls1
MPG combined—
Safety—

Most reported 2003 GMC Yukon XL 2500 problems

Owner complaints filed with NHTSA, grouped by problem area. One complaint can mention several areas.

Electrical system5 (56%)
Brakes4 (44%)
Engine & cooling2 (22%)
Equipment1 (11%)
Transmission & powertrain1 (11%)

When owners reported problems

12007
22008
22010
12011
12014
22015

Complaints by the year they were filed.

Recent owner complaints

Jun 15, 2015power train, electrical system, engine
While sitting idle my vehicle suddenly went into reduced engine power mode. I was able to get over and pull off the road and shut off the car. 5 minutes later the car started like there was no problem. Over the next few days the rep warning would show up and my car would suddenly lose power. I was crossing the road during one incident. However, when I would shut off the car… Read more

While sitting idle my vehicle suddenly went into reduced engine power mode. I was able to get over and pull off the road and shut off the car. 5 minutes later the car started like there was no problem. Over the next few days the rep warning would show up and my car would suddenly lose power. I was crossing the road during one incident. However, when I would shut off the car and restart the check engine light would go away as would the rep warning. After a quick review online it is easy to find hundreds of people who have a similar issue. GM will only diagnose and if the light is off when you get there there is nothing for them to do except take your money and say good luck.

NHTSA complaint #10725348
Jan 26, 2015service brakes, hydraulicCrash
In december 2013 my wife and I were driving our 2003 GMC Yukon XL 2500 4x4 outside of cooperstown, new york. The brakes failed on route 26 coming down the hill towards route 28. It was snowing and about 11:30 at night. We slid sideways down the hill and across route 28. The only thing that stopped us from rolling over an embankment was the new metal guardrail that was recently… Read more

In december 2013 my wife and I were driving our 2003 GMC Yukon XL 2500 4x4 outside of cooperstown, new york. The brakes failed on route 26 coming down the hill towards route 28. It was snowing and about 11:30 at night. We slid sideways down the hill and across route 28. The only thing that stopped us from rolling over an embankment was the new metal guardrail that was recently installed along route 28. Fortunately, we were not injured, and there was no one else on the road. I experienced immediate and complete brake failure. My brake pedal went completely to the floor. It was not a slow process. Our yukon is well maintained and has only 89,000 miles on it. 1 - my local dealer, where I bought the vehicle brand new, and who inspected my vehicle brake line failure and quoted the repairs, denied a backup system in the event of a brake line failure. 2 - a different repair shop said that all five of my brake lines had failed and were leaking fluid during a test to locate the problem. 3 - I have had the vehicle inspected by four different repair shops, within one weeks time, and they all confirm failure of the brake fluid lines due to rust. I did not yet have the brakes repaired yet because the quotes were so high. Many new yorkers may have already experienced this brake line failure , or are still at risk of a serious, or fatal accident. My concern is that there may have already been serious injuries and possibly deaths around the country and this brake line failure may have bee

NHTSA complaint #10678811
Aug 6, 2014service brakes, hydraulic, parking brake
Tl* the contact owns a 2003 GMC Yukon XL 2500. While driving approximately 70 MPH, the brakes failed. When the contact attempted to apply the emergency brake to slow down the vehicle, it also failed. The contact was able to downshift enough to stop the vehicle. There were no warning indicators illuminated on the instrument panel. An independent mechanic stated that the brake… Read more

Tl* the contact owns a 2003 GMC Yukon XL 2500. While driving approximately 70 MPH, the brakes failed. When the contact attempted to apply the emergency brake to slow down the vehicle, it also failed. The contact was able to downshift enough to stop the vehicle. There were no warning indicators illuminated on the instrument panel. An independent mechanic stated that the brake lines were corroded and one of the lines was severed. In addition, brake fluid was leaking from the vehicle. The vehicle was not repaired and the manufacturer was notified. The approximate failure mileage was 166,000.

NHTSA complaint #10619286
Jul 20, 2011service brakes, hydraulic
2003 GMC Yukon XL 2500 sudden brake failure. While decelerating to enter a residential driveway, brake failure occurred. Due to low speed (<20 MPH) at the time, I was able to stop the vehicle using the parking brake. Had this occurred moments earlier while decelerating from the freeway into a busy intersection, there could have been fatalities. While stopping, smoke was seen… Read more

2003 GMC Yukon XL 2500 sudden brake failure. While decelerating to enter a residential driveway, brake failure occurred. Due to low speed (<20 MPH) at the time, I was able to stop the vehicle using the parking brake. Had this occurred moments earlier while decelerating from the freeway into a busy intersection, there could have been fatalities. While stopping, smoke was seen coming from the front and left wheel well of the vehicle. After stopping, I examined the vehicle and found the metal brake line had ruptured where it crosses over the frame rail leading to the front left brake. There was brake fluid sprayed around the left side of the engine bay, and the exhaust header was still smoking. Luckily the exhaust header temperature was low enough to avoid ignition of the brake fluid and initiation of fire. A large portion of brake fluid in the master brake reservoir had leaked out leaving a trail of fluid behind the vehicle along the left side. An extreme level of corrosion and flaking metal was evident along all the metal brakes lines from front to rear. Incidentally, the power steering lines were in similar condition. The brake line wall thickness in the rupture area was so thin that it could be bent and crushed with pressure applied by thumbnail. The vehicle is now at the local GMC dealership for repairs. Based on the consistent and excessive corrosion throughout, I opted to have all the brake lines and power steering lines replaced at once. Brakes are the most safety critic

NHTSA complaint #10413771
Jun 14, 2010electrical system

June 8, 2010 all dash lights went out. The defective part was replaced in 2006 and has failed again. *tr

NHTSA complaint #10336277
Mar 10, 2010engine and engine cooling, equipment
Since november 2008, my 2003 GMC Yukon XL 2500 has had episodes where the service engine light comes on and the engine goes into reduced power mode. In this reduced power mode, the vehicle will reach a top speed of around 25mph. I have taken it to numerous GM dealers to fix the problem, and they have replaced the throttle body assemble and wiring harness multiple times and… Read more

Since november 2008, my 2003 GMC Yukon XL 2500 has had episodes where the service engine light comes on and the engine goes into reduced power mode. In this reduced power mode, the vehicle will reach a top speed of around 25mph. I have taken it to numerous GM dealers to fix the problem, and they have replaced the throttle body assemble and wiring harness multiple times and the problem keeps recurring. I have bought a scanner which I can erase the codes because it is very dangerous to be driving 65mph with semitrucks on your tail when you suddenly for no reason lose power and can't get over to the side of the road. There have been many close episodes where we were almost in an accident. After the throttle body was replaced in dec 08, the reduced engine power didn't come back until april 2009. Dealer then rewired the harness and it stopped until the fall of 2009. Since fall 2009, the service engine light and reduced power mode come on sporadically. In february 2010, the problem reappeared, but now the truck stalls when the engine light comes on and reduced engine power is enabled. This is very dangerous, as during the stall, all power steering and braking is lost. I have been driving down the road, turning, crossing traffic, and the light comes on and the truck stalls. This is very dangerous and scary. The truck has been in the GM dealership service dept for the last 3 weeks. Everytime they say it has to be the throttle body, they replace it, I bring it home and a

NHTSA complaint #10318423
Feb 4, 2008electrical system

Speedometer reading as much as 50mph over actual speed, causing safety issue. Other gauges occasionally showing incorrect values (fuel, alternator, etc). *tr

NHTSA complaint #10216871
Jan 20, 2008electrical system

(1) there were no events leading up to the failure. (2) rpm gauge gets stuck on an rpm and will stay there and speedometer wont go to 0 lowest it goes is 10mph (3) haven't had a chance to correct this problem. *tr

NHTSA complaint #10215486

2003 GMC Yukon XL 2500 recalls (1)

Recall 06E043000Fuel system, gasoline

Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.

Risk: This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.

Remedy: Honeywell will notify owners and replace the fuel filters free of charge. The recall began on october 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).

Other GMC Yukon XL 2500 years

Frequently asked questions

Is the 2003 GMC Yukon XL 2500 a reliable car?

Our score for the 2003 GMC Yukon XL 2500 is 6.3/10 (average). It is based on 9 owner complaints and 1 recall compared with other 2003 vehicles and other GMC Yukon XL 2500 years.

What are the most common problems with the 2003 GMC Yukon XL 2500?

Owners most often report problems with electrical system (5 complaints), brakes (4 complaints), engine & cooling (2 complaints).

How many recalls does the 2003 GMC Yukon XL 2500 have?

1 recall is on file with NHTSA, including: 06E043000 (fuel system, gasoline).

Source: NHTSA complaints & recalls, EPA fueleconomy.gov. Data updated November 18, 2026. Complaints are unverified reports by owners.