5.1out of 10
Our verdict
Buy with caution
- More complaints than 31% of 2001 vehicles
- Most reported problem: engine & cooling (39% of complaints)
- 1 safety recall
How we score
Most reported 2001 GMC Yukon XL 2500 problems
Owner complaints filed with NHTSA, grouped by problem area. One complaint can mention several areas.
Fuel & propulsion system2 (11%)
When owners reported problems
42006
22007
22008
42009
12012
12014
32015
12017
Complaints by the year they were filed.
Recent owner complaints
Feb 6, 2017service brakes
Accelerated rigid brake line corrosion resulted in brake line failure and complete loss of vehicle stopping ability. Brake lines are inspected regularly and did not appear rusted. Vehicle was in motion traveling at approximately 20 MPH when operator stepped on brake to slow and stop vehicle. Brake pedal felt soft and then pressed completely to floor without any braking… Read more
Accelerated rigid brake line corrosion resulted in brake line failure and complete loss of vehicle stopping ability. Brake lines are inspected regularly and did not appear rusted. Vehicle was in motion traveling at approximately 20 MPH when operator stepped on brake to slow and stop vehicle. Brake pedal felt soft and then pressed completely to floor without any braking action. Operator used emergency brake to slow and stop vehicle. Vehicle required immediate towing as it was not road worthy and was unsafe to drive without braking ability.
NHTSA complaint #10949709
Dec 24, 2015service brakes
While on a hill holding the vehicle with the brakes activated, a large amount of white smoke came billowing out of the engine compartment. I was able to determine that the fluid was clear and dripping on the hot exhaust manifold. The brake reservoir dropped with successive brake applications. After having the vehicle towed to a repair facility, it was determined that… Read more
While on a hill holding the vehicle with the brakes activated, a large amount of white smoke came billowing out of the engine compartment. I was able to determine that the fluid was clear and dripping on the hot exhaust manifold. The brake reservoir dropped with successive brake applications. After having the vehicle towed to a repair facility, it was determined that multiple fixed metal brake lines were corroding and one had enough to corrosion to cause a failure of the metal causing a leaking break line. All fixed metal brake lies were replace at a very high expense due to the labor to install the new lines. Part were only a fraction of the labor to install new brake lines along the body framing. Ironically, the repair shop owner had a 2500 series GM pickup truck which experience the same brake line failures just months before. In all my years of vehicle ownership, I have never experienced a complete failure of a fixed metal brake line. They are usually make of materials which prevent corrosion of the metal and therefore remain useful for stopping the vehicle throughout the vehicle useful life.
NHTSA complaint #10812011
Dec 24, 2015engine
While traveling at highway speeds the engine stopped working / stalled. Shifting to neutral and trying to start the vehicle was not successful. The vehicle without the assistance of power steering or power brakes had to be carefully stopped . This was extremely dangerous! After looking at an on-line forum, the vehicle with the 8.1 liter engin had some vehicles recalled… Read more
While traveling at highway speeds the engine stopped working / stalled. Shifting to neutral and trying to start the vehicle was not successful. The vehicle without the assistance of power steering or power brakes had to be carefully stopped . This was extremely dangerous! After looking at an on-line forum, the vehicle with the 8.1 liter engin had some vehicles recalled with a cam lobe sensor fault which causes this to happen. After contacting the dealer, they told me that my vehicle was not in this recall. However, when the vehicle was new, they had already replace the same part when the vehicle was 3-5 months old. I questioned them as to the replacement part as the first part only caused the check engine light, not completely disabling the engine. It may be they replace the factory original part with a part which was defective and covered by the recall. In eather case, a engine on heavy duty vehicle which quits and disables the normal brakes and steering is extremely dangerous.
NHTSA complaint #10812010
Apr 26, 2015service brakes
While traveling on the expressway, brakes were applied to exit the expressway and the pedal went to the floor. Found ruptured line on rear axle. Date of first incident 2/5 20011 most recent 4/26/2015...ruptured line under vehicle ( drivers seat location) all lines require replacement. *tr
NHTSA complaint #10712953
Jun 16, 2014electrical system
Was driving down a stretch of straight road in warrenton, virginia when I went to press the button that changes the display near the odometer from "odometer," "trip 1" miles, and "trip 2" miles. When I reached my hand bumped the ignition switch and everything in the vehicle shut off including the engine, power steering, and brakes. I had no control of the vehicle and it rolled… Read more
Was driving down a stretch of straight road in warrenton, virginia when I went to press the button that changes the display near the odometer from "odometer," "trip 1" miles, and "trip 2" miles. When I reached my hand bumped the ignition switch and everything in the vehicle shut off including the engine, power steering, and brakes. I had no control of the vehicle and it rolled to complete stop down the road we were driving on. Once it came to a complete stop, I restarted the vehicle and everything seemed alright so continued driving, had it looked at, and was told everything was fine. I believe that the ignition switch issues affect the 2001 Yukon XL 2500 and that it should be looked into further. *tr
NHTSA complaint #10598507
Oct 26, 2012steering, service brakes
Tl*the contact owns a 2001 GMC yukon 2500. The contact stated while starting the vehicle after it had been sitting 4 days it became apparent that the brakes and power steering had failed. The vehicle was towed to dealer where the failure could not be replicated. The vehicle was not repaired. The manufacturer was contacted about the issue. The failure and current mileage was 62,000. The VIN was not available.
NHTSA complaint #10482312
Dec 28, 2009engine and engine cooling
GMC Yukon XL 2500, 8.1l engine... Purchased truck (2nd owner) 8/2005 from GMC dealer. Noticed first occasion of stalling app. 10/05 or 11/05. Dealer said "couldn't reproduce complaint" and released the vehicle. Truck drove ok for awhile and began stalling again, this time GM dealer said "fuel pump" ($900+). Truck continued to stall on and off for years, each time no one… Read more
GMC Yukon XL 2500, 8.1l engine... Purchased truck (2nd owner) 8/2005 from GMC dealer. Noticed first occasion of stalling app. 10/05 or 11/05. Dealer said "couldn't reproduce complaint" and released the vehicle. Truck drove ok for awhile and began stalling again, this time GM dealer said "fuel pump" ($900+). Truck continued to stall on and off for years, each time no one could find problem.. Recently, summer of 09, it has become worse (more frequent and longer time to re-start) and after two independent diagnostic tests by two separate certified mechanics, it was determined to be the crank positioning sensor. I had already heard about this problem but since my VIN wasn't included in the recall (even though its the same year, model and engine) I am being told that the dealership will not cover!!! I don't know what else to do.. I cant drive this vehicle any longer because it stalls much more often and without any warning meaning loss of power steering, etc and risk of crash. I have called GM as recent as today (12/09) and they are still singing the same tune.."your vehicle VIN# isn't included in the recall". Next stop media outlets!! *tr
NHTSA complaint #10297154
Dec 3, 2009engine and engine cooling
Tl*the contact owns a 2001 GMC Yukon XL 2500. The crank case position sensor shuts on and off intermittently which caused the engine to stall and it may not restart immediately. The failure is related to NHTSA#07v521000 and GM recall# 06083, engine and engine cooling. The dealer advised the contact that there were no recalls. A different authorized dealer performed a… Read more
Tl*the contact owns a 2001 GMC Yukon XL 2500. The crank case position sensor shuts on and off intermittently which caused the engine to stall and it may not restart immediately. The failure is related to NHTSA#07v521000 and GM recall# 06083, engine and engine cooling. The dealer advised the contact that there were no recalls. A different authorized dealer performed a diagnostic test and stated that the crank shaft position sensor needed to be replaced. The dealer also stated that the repair cost was $800 and if the failure affected the transmission additional fees would be included. A local mechanic repaired the transmission at for less than $800. The dealer and the manufacturer advised the contact that there were no related recalls for her VIN. The failure mileage was 67,315 and the current mileage was 80,000.
NHTSA complaint #10294373
2001 GMC Yukon XL 2500 recalls (1)
Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.
Risk: This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Remedy: Honeywell will notify owners and replace the fuel filters free of charge. The recall began on october 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).
Other GMC Yukon XL 2500 years
Frequently asked questions
Is the 2001 GMC Yukon XL 2500 a reliable car?
Our score for the 2001 GMC Yukon XL 2500 is 5.1/10 (buy with caution). It is based on 18 owner complaints and 1 recall compared with other 2001 vehicles and other GMC Yukon XL 2500 years.
What are the most common problems with the 2001 GMC Yukon XL 2500?
Owners most often report problems with engine & cooling (7 complaints), brakes (5 complaints), electrical system (2 complaints).
How many recalls does the 2001 GMC Yukon XL 2500 have?
1 recall is on file with NHTSA, including: 06E043000 (fuel system, gasoline).
Source: NHTSA complaints & recalls, EPA fueleconomy.gov. Data updated November 18, 2026. Complaints are unverified reports by owners.