The contact owns a 2025 Mazda Mazda3. The contact stated that while driving, the vehicle lost motive power. The vehicle was towed to the dealer and was diagnosed with transmission clutch failure. The contact was informed that the transmission clutch needed to be replaced. The vehicle was repaired. The manufacturer was contacted and made aware of the failure. The failure mileage was approximately 25,000.
2025 Mazda Mazda3 problems, recalls & MPG
NHTSA has received 10 complaints from owners of the 2025 Mazda Mazda3, most often about the forward collision avoidance. There is 1 safety recall for this model year.
- More complaints than 41% of 2025 vehicles
- Most reported problem: forward collision avoidance (20% of complaints)
- 1 safety recall
- 2 crashes, 1 injury reported
Most reported 2025 Mazda Mazda3 problems
Owner complaints filed with NHTSA, grouped by problem area. One complaint can mention several areas.
When owners reported problems
Complaints by the year they were filed.
Recent owner complaints
Three times, last time 3 days after expensive rebuild, clutch hydraulic! Llnkage failed, burning out clutch. Clutch master cylinder also controls braking, very bad design. Most have separate master cylinders. Braking impacts clutch! State lemon law should apply.
My car started displaying a telematic malfunction. The service paperwork also says u0198:00-03 cmu communication error with emergency call unit. The Mazda dealerships maintenance department says this is currently unrepairable. According to them if I have an accident the car will not communicate that through the emergency call unit. The car was purchased new and has had no… Read more
My car started displaying a telematic malfunction. The service paperwork also says u0198:00-03 cmu communication error with emergency call unit. The Mazda dealerships maintenance department says this is currently unrepairable. According to them if I have an accident the car will not communicate that through the emergency call unit. The car was purchased new and has had no accidents. I have taken it to the dealership 4 separate times to repair this problem.
When turning a corner in my neighborhood, as I got around the corner (slow speed (10 MPH?). The car gradually sped up on it's own without pushing the gas pedal. No cruise on and no floor mat problem. While in cruise control "on", the engine "reved up. Took the vehicle to the dealer, they could not find a problem.
The vehicle was involved in a rear and side impact collision and the car was totaled on 5/14/2026. The air bags did not deploy. There was a recall on the air bag system immediately after purchase 6/28/2025 and it was taken in july of 2025 to Mazda of columbia, sc and it was “repaired.” the airbags of the truck that collided with the Mazda did deploy.
I am reporting a catastrophic failure of the rear seatbelt restraint system in my 2025 Mazda 3. The rear seatbelt guide geometry is badly designed, allowing the webbing to bunch and jam during normal operation. This physical obstruction prevents the seatbelt from retracting, leading to three severe safety hazards: 1) total failure to restrain occupants. 2) structural damage… Read more
I am reporting a catastrophic failure of the rear seatbelt restraint system in my 2025 Mazda 3. The rear seatbelt guide geometry is badly designed, allowing the webbing to bunch and jam during normal operation. This physical obstruction prevents the seatbelt from retracting, leading to three severe safety hazards: 1) total failure to restrain occupants. 2) structural damage to the vehicle's safety cell. 3) public hazard where the obstructed door rebounded open into oncoming traffic. Restraint failure: on multiple occasions, the rear seatbelt jammed in the guide clip while in use. Due to the lack of retraction, a 200lb adult passenger was able to fully exit the vehicle while the belt remained buckled. Most alarmingly, the vehicle's safety logic failed to trigger any occupancy warning alarms. The system remained "satisfied" because the buckle was engaged, despite providing zero tension or restraint to the occupant. Structural damage & public hazard: because the belt failed to retract, it remained loose and obstructed the rear door's closing path. The door rebounded off the slack belt into oncoming traffic, resulting in a significant structural dent to the c-pillar (door jamb) immediately adjacent to the striker. This deformation occurred in a critical area for side-impact protection. Efforts to resolve: the vehicle was inspected by a dealer, who claimed the system was functioning normally despite being shown the jamming. I escalated this to the Mazda north american op
January 10, 2025, at low city speed, I struck a small pothole. The entire car felt like it had been in an accident—a violent jolt—followed by immediate vibration and a pull. Inspection showed one oem 18" rim was bent. I contacted Mazda after diagnosing and was offered a slight discount on the replacement rim, not a warranty repair or full diagnosis. I have the bent rim in my… Read more
January 10, 2025, at low city speed, I struck a small pothole. The entire car felt like it had been in an accident—a violent jolt—followed by immediate vibration and a pull. Inspection showed one oem 18" rim was bent. I contacted Mazda after diagnosing and was offered a slight discount on the replacement rim, not a warranty repair or full diagnosis. I have the bent rim in my possession. July 2025, at low speed, I barely contacted another small pothole and immediately felt the same drivability issues. A second rim was found damaged. This was only 4,500 miles after the first incident. I called the dealership manager; he said he would get back to me but never did. I later sent a letter that went unanswered. My subsequent research shows innumerable similar owner complaints for 2020–2025 Mazda 3s experiencing rim deformation from ordinary road irregularities. Why this is a safety issue (technical points): bead-seat deformation & air loss: a bent alloy rim can distort the bead seat, causing slow leaks or sudden deflation, especially after heat cycles—creating a loss-of-control risk. Dynamic instability: a rim that’s even slightly out-of-round produces high-frequency vibration, steering pull, and reduced traction in turns or under braking; it can trigger ABS/ESC interventions and increase stopping distance. Load path & suspension stress: the 18" low-profile package leaves little sidewall cushion. On normal bumps/potholes, impact energy transfers directly to the wheel. Repeate
I found out about this recall today. Mazda doesn’t have a fix to this recall yet. I am scared to drive my car in the event of a crash, due to the fact that my airbags won’t go off due to the recall. Mazda said to just “be aware until we have a fix” I cannot just “be aware” if I get into an accident and my airbags don’t go off.
2025 Mazda Mazda3 recalls (1)
Mazda north american operations is recalling certain 2024-2025 Mazda3 and cx30 vehicles. The sophisticated air bag sensor (sas) units may set an error code and deactivate the air bags, due to a low battery condition.
Risk: Air bags that do not deploy in the event of a crash increase the risk of injury.
Remedy: Dealers will reprogram the sas unit with improved software or replace the unit, free of charge. Owner notification letters were mailed july 24, 2025. Mazda's number for this recall is 7525e.
Other Mazda Mazda3 years
Frequently asked questions
Is the 2025 Mazda Mazda3 a reliable car?
Our score for the 2025 Mazda Mazda3 is 5.7/10 (average). It is based on 10 owner complaints and 1 recall compared with other 2025 vehicles and other Mazda Mazda3 years.
What are the most common problems with the 2025 Mazda Mazda3?
Owners most often report problems with forward collision avoidance (2 complaints), other / unknown (2 complaints), transmission & powertrain (2 complaints).
How many recalls does the 2025 Mazda Mazda3 have?
1 recall is on file with NHTSA, including: 25V357000 (air bags: air bag/restraint control module:software).
Source: NHTSA complaints & recalls, EPA fueleconomy.gov. Data updated November 18, 2026. Complaints are unverified reports by owners.