CarProblemsDB

2006 Mitsubishi Lancer Evolution problems, recalls & MPG

NHTSA has received 24 complaints from owners of the 2006 Mitsubishi Lancer Evolution, most often about the engine & cooling. There are 2 safety recalls for this model year. The EPA rates it at about 19 MPG combined.

6.6out of 10
Our verdict
Average
  • More complaints than 33% of 2006 vehicles
  • Most reported problem: engine & cooling (54% of complaints)
  • 2 safety recalls
How we score
Complaints24
Recalls2
MPG combined19
Safety—

Most reported 2006 Mitsubishi Lancer Evolution problems

Owner complaints filed with NHTSA, grouped by problem area. One complaint can mention several areas.

Brakes3 (13%)
Suspension3 (13%)
Transmission & powertrain3 (13%)
Body & structure2 (8%)
Electrical system2 (8%)
Other / unknown1 (4%)
Speed control (cruise, throttle)1 (4%)
Steering1 (4%)

When owners reported problems

102009
52010
52014
22016
22018

Complaints by the year they were filed.

Recent owner complaints

Oct 14, 2018suspension, structure

Rear subframe where the rear differential and suspension bolts onto is rusted, just like the front subframe . Many owners 2003-2006 Mitsubishi Lancer Evolution owners are having this same issue. Mitsubishi recently issued a recall on the front subframe due to rust. The rear subframe is also a concern and is worst than the front.

NHTSA complaint #11140222
Mar 26, 2018suspension
The rear subframe of my vehicle exhibits significant corrosion perforation where the rear axle and suspension mounts to the body. The rust is so bad, that I'm worried if I hit a pothole the entire rear subframe assembly / control arms could detach, resulting in an accident. The vehicle has been incredibly well maintained, has always been washed throughout the winter months… Read more

The rear subframe of my vehicle exhibits significant corrosion perforation where the rear axle and suspension mounts to the body. The rust is so bad, that I'm worried if I hit a pothole the entire rear subframe assembly / control arms could detach, resulting in an accident. The vehicle has been incredibly well maintained, has always been washed throughout the winter months (undercarriage), and the body does not show any rust. I have not been involved in any loss of control, etc ... Just concerned this could happen. My vehicle had the front subframe replaced last year (recall) due to rust perforation and lack of corrosion protection from the factory and the potential for the front control arms to detach resulting in an unsafe condition. I see the same potential for the rear. Also please note, the photos I'm attaching are not from my vehicle, but they are nearly identical to the areas of concern on my vehicle (and are from the exact make / model vehicle). I'd be happy to attach similar photos from my vehicle if needed, but again, they show the same amount of rust in the exact same areas.

NHTSA complaint #11081338
Oct 21, 2016structure
I have a recall on my 2006 Mitsubishi for corrosion on subframe, I called my local dealer, they checked the car and ordered the cross member, so we made an appoint to take car into dealer for replacement, left the car with the dealer for the day, later that day I gotten a call stating they cannot get the bolts loose due to corrosion and I have to pay to remove it, I find it… Read more

I have a recall on my 2006 Mitsubishi for corrosion on subframe, I called my local dealer, they checked the car and ordered the cross member, so we made an appoint to take car into dealer for replacement, left the car with the dealer for the day, later that day I gotten a call stating they cannot get the bolts loose due to corrosion and I have to pay to remove it, I find it strange that theres a recall on a part due to corrosion and now the bolt is seized due to the same corrosion, and I have to pay 392.00 to remove cross member bolt so they can change a part that they recalled, I taught that a big company like this would recall a part and then take care of the issue, and not charge the customer for the repair. This is the worst recall I ever heard of.

NHTSA complaint #10917930
May 25, 2016power train, service brakes
I was heading to a class when I noticed my clutch pedal went almost all the way to the floor. The clutch was still disengaging/engaging when I shifted so I made it to my destination. I was worried about driving it but I decided to try and see if it was still doing it, so I tried to back out of a spot but it would no longer go into gear and the clutch pedal was all the way to… Read more

I was heading to a class when I noticed my clutch pedal went almost all the way to the floor. The clutch was still disengaging/engaging when I shifted so I made it to my destination. I was worried about driving it but I decided to try and see if it was still doing it, so I tried to back out of a spot but it would no longer go into gear and the clutch pedal was all the way to the floor. Turned out my brake master cylinder was faulty and I learned through online forums and friends that it was a common issue with the Lancer Evolution. I was surprised at that and wondered why Mitsubishi would not issue a recall for faulty brake master cylinders. It dawned on me that most people with this type of car are the "do it yourself" kind of person and more than likely were fixed by the owners of the cars, therefor never reported through mechanics or dealerships. After the master cylinder was replaced, the throw out bearing retaining clip came loose and damaged the pressure plate. So now it is being replaced, and I believe it was all caused by the master cylinder. Had it worked properly, I never would have had these problems and spending all this money. What I am hoping is that more owners come forward with the same issue and report them, and that it doesn't happen to someone while they're driving on the freeway or stuck in traffic. They could potentially lose hydraulic power to the clutch system and brakes, resulting in a hazardous situation that could damage to property or cause injury o

NHTSA complaint #10870878
Sep 14, 2014power train, engine
There is an active center differential pump failure that is becoming common in all lancer evolutions of this year. Mine went out last year and I have been having to drive with it for a year now not knowing whether the differential is corroding at an accelerated rate of not. I did this because after I had my vehicle assessed they told it would be $2500 to replace. I researched… Read more

There is an active center differential pump failure that is becoming common in all lancer evolutions of this year. Mine went out last year and I have been having to drive with it for a year now not knowing whether the differential is corroding at an accelerated rate of not. I did this because after I had my vehicle assessed they told it would be $2500 to replace. I researched online and found that this is a very common problem and can be dangerous therefore causing me to have to pay this absurd amount even with knowing that almost 60% of evo drivers have to deal with this same issue. *tr

NHTSA complaint #10633068
Aug 19, 2014suspension

Spring seat broke at weld joint to shock tube. Spring translated in the z direction until it was in direct contact with the tire. Upon breakage vehicle had extensive spring rubbing against tire. *tr

NHTSA complaint #10626474
Apr 10, 2014engine

This is a very well documented and known issue amongst evolution gen 9 owners. The oem timing belt bracket tensioner was made incorrect and causes the timing belt to rub against metal. There has already been a replacement bracket made that corrects the issue but I think this needs to be a recall. Mitsubishi needs to own this one and make it right, it's a faulty part, initiate the recall. *tr

NHTSA complaint #10578944
Mar 8, 2014steering, power train, vehicle speed control

Mitsubishi Lancer Evolution 9 rs model acd pump failure while driving under normal operating conditions. *tr

NHTSA complaint #10567977

2006 Mitsubishi Lancer Evolution recalls (2)

Recall 16V4580002016Suspension:front:control arm:lower arm

Mitsubishi motors north america, inc. (mmna) is recalling certain model year 2002-2007 lancer, 2004 lancer wagon, 2003-2006 Lancer Evolution, 2003-2006 outlander and 2007-2013 outlander v-6 vehicles originally sold in, or ever registered in, connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virginia, wisconsin and the district of columbia. In the affected vehicles, the front lower control arms may detach due to the front cross member corroding from salt water exposure such as from road salt use.

Risk: A detached front control arm can result in the loss of control of the vehicle, increasing the risk of a crash.

Remedy: Mmna will notify owners, and dealers will inspect the front cross members. Depending on the level of existing corrosion, either a sealing/anti-corrosion agent will be applied or the front cross member will be replaced with a new one that has a sealing/anti-corrosion agent applied to it. These repairs will be performed free of charge. The recall began january 2017. Owners may contact mmna customer service at 1-888-648-7820. Mmna's number for this recall is sr-16-003.

Recall 16V3340002016Air bags:frontal:passenger side:inflator module

Mitsubishi motors north america, inc. (mmna) is recalling certain model year 2006-2007 lancer and Lancer Evolution vehicles manufactured june 29, 2005, to june 19, 2007, equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating air bag deployment, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Risk: An inflator rupture may result in metal fragments striking the vehicle occupants resulting in serious injury or death.

Remedy: Mmna will notify owners, and dealers will replace the passenger frontal air bag inflator, free of charge. The recall began on july 19, 2016. Owners may contact mmna customer service at 1-888-648-7820. Mmna's number for this recall is sr-16-002.

Fuel economy (EPA)

EngineTransmissionDriveCityHwyComb.
2.0L 4-cylManual 5-spd4-Wheel or All-Wheel Drive172319
2.0L 4-cylManual 6-spd4-Wheel or All-Wheel Drive162218

Crash-test ratings (NHTSA)

VersionOverallFrontalSideRollover
2006 Mitsubishi Lancer Evolution 4-DR————

Other Mitsubishi Lancer Evolution years

Frequently asked questions

Is the 2006 Mitsubishi Lancer Evolution a reliable car?

Our score for the 2006 Mitsubishi Lancer Evolution is 6.6/10 (average). It is based on 24 owner complaints and 2 recalls compared with other 2006 vehicles and other Mitsubishi Lancer Evolution years.

What are the most common problems with the 2006 Mitsubishi Lancer Evolution?

Owners most often report problems with engine & cooling (13 complaints), brakes (3 complaints), suspension (3 complaints).

How many recalls does the 2006 Mitsubishi Lancer Evolution have?

2 recalls are on file with NHTSA, including: 16V458000 (suspension:front:control arm:lower arm); 16V334000 (air bags:frontal:passenger side:inflator module).

What gas mileage does the 2006 Mitsubishi Lancer Evolution get?

The EPA rates the 2006 Mitsubishi Lancer Evolution at about 17 MPG city, 23 MPG highway and 19 MPG combined, depending on engine and drivetrain.

Source: NHTSA complaints & recalls, EPA fueleconomy.gov. Data updated November 18, 2026. Complaints are unverified reports by owners.