CarProblemsDB

2012 Mercedes-Benz E350 transmission problems

10 owners reported transmission & powertrain problems — 5% of all 217 complaints about the 2012 Mercedes-Benz E350.

Transmission & powertrain complaints by Mercedes-Benz E350 year

20201
20165
20151
201415
20137
201210
20116
201014
20092
20085
200721
200637
20031

What owners report

Aug 25, 2025steering, power train
The contact owned a 2012 Mercedes-Benz E350. The contact stated that while attempting to shift to drive(d), the gear shifter detached from the steering column. No warning light was illuminated. Neither a dealer nor an independent mechanic was contacted. The vehicle was not taken to a dealer or independent mechanic to be diagnosed. The vehicle was not repaired. The vehicle was… Read more

The contact owned a 2012 Mercedes-Benz E350. The contact stated that while attempting to shift to drive(d), the gear shifter detached from the steering column. No warning light was illuminated. Neither a dealer nor an independent mechanic was contacted. The vehicle was not taken to a dealer or independent mechanic to be diagnosed. The vehicle was not repaired. The vehicle was towed to the residence by aaa. The manufacturer was not notified of the failure. The failure mileage was 420,000.

NHTSA complaint #11682880
Feb 13, 2023power train

Car won't go forward or reverse smoothly. It acts like a dead pedal then lurches. I traded pain with a safety barrier backing up when it suddenly went backwards. Also sometimes when entering the highway or passing a car it will go into limp mode. Can only be cleared by restarting car. Very dangerous.

NHTSA complaint #11507034
Dec 15, 2021power train, electrical system
The camshaft position sensors leak oil into wiring harness. The oil circulates to other engine sensors and the ecu(engine control computer). Oil in the other sensors and the ecu causes the car to stop operating or operate erratically while driving. A real problem. This is a safety issue there should not be oil leaking into the ecu! The mercedes dealer replaced the leaking… Read more

The camshaft position sensors leak oil into wiring harness. The oil circulates to other engine sensors and the ecu(engine control computer). Oil in the other sensors and the ecu causes the car to stop operating or operate erratically while driving. A real problem. This is a safety issue there should not be oil leaking into the ecu! The mercedes dealer replaced the leaking camshaft position sensors and confirmed oil had leaked into the ecu and wiring harness on december 13,2021. They recommended replacing the wiring harness and ecu at cost of $6500. I have the replaced bad sensors. Mercedes says they have no culpability in this or a fix. The mercedes complaint number is #23264730932. The previous mercedes engine generation had the same problem and mercedes did a recall on that engine.

NHTSA complaint #11443918
Sep 8, 2021power train, electrical system

My vehicle when coming to a stop throws itself in the park around 5 MPH. I have almost gotten hit by vehicles behind me several times.

NHTSA complaint #11432168
Oct 3, 2014power train, engineCrash1 injured
Tl* the contact owns a 2012 mercedes benz E350. While the vehicle was parked and the key was removed from the ignition, the vehicle jerked and rolled backwards before stopping independently. In addition, the contact heard an abnormal noise and the vehicle veered to the left when reversing. The dealer was unable to diagnose the failure but made the following repairs: the cover… Read more

Tl* the contact owns a 2012 mercedes benz E350. While the vehicle was parked and the key was removed from the ignition, the vehicle jerked and rolled backwards before stopping independently. In addition, the contact heard an abnormal noise and the vehicle veered to the left when reversing. The dealer was unable to diagnose the failure but made the following repairs: the cover on the front passenger side cylinder head, removed/installed a seal, non-return valve, chain tensioner, sealant mb, flange gasket, hexalobular bolt, the cover on the front driver side cylinder head, removed/installed a seal, left and right secondary drive chain tensioners, front cover cylinder, and the check valve. On another occasion, the vehicle rolled in reverse and crashed into the bumper of another vehicle. The door of the vehicle bruised the contact and medical attention was required. The vehicle was towed to the dealer. A police report was not filed. The dealer was not able to diagnose the failure and the vehicle remained at the dealer. The manufacturer was notified of the failure. The approximate failure mileage was 5,597.

NHTSA complaint #10641320
Sep 30, 2014power trainCrash1 injured
Tl* the contact owns a 2012 mercedes benz E350. The contact stated that the vehicle was secured with the engine turned off when the vehicle rolled away in reverse independently and as the contact was exiting the front driver's side door. The contact was knocked to the ground by the open door, which then crashed into the rear fender of an unoccupied and parked vehicle. The… Read more

Tl* the contact owns a 2012 mercedes benz E350. The contact stated that the vehicle was secured with the engine turned off when the vehicle rolled away in reverse independently and as the contact was exiting the front driver's side door. The contact was knocked to the ground by the open door, which then crashed into the rear fender of an unoccupied and parked vehicle. The vehicle continued to roll away and came to a stop when encountering a nearby curb. The contact sustained bruises all over the body and required medical attention. A police report was not filed of the incident. The vehicle was towed to an authorized dealer. The manufacturer was notified of the failure. The approximate failure mileage was 6,000.

NHTSA complaint #10640109
Apr 26, 2014power train, engineCrash
While driving on an express way in dallas, texas my GPS made an error concerning an exit and I was required to divert quickly to the left to make exit lane .time was 6:00 pm ,heavy traffic conditions and road and weather conditions were excellent and dry. My mercedes pre activated a skid mode and there was approximately a 70% cut back in engine power .a yellow engine light… Read more

While driving on an express way in dallas, texas my GPS made an error concerning an exit and I was required to divert quickly to the left to make exit lane .time was 6:00 pm ,heavy traffic conditions and road and weather conditions were excellent and dry. My mercedes pre activated a skid mode and there was approximately a 70% cut back in engine power .a yellow engine light came on and skid mode came on operator screen but there was no skidding taking place. I was helpless with no power to keep up with the 50-60 MPH traffic while trying to get into lane .consequently a semi tractor struck my left rear fender /bumper causing damage to my mercedes. There was no damage to the tractor. According to mercedes the vehicle was supposed to do this as a safety feature. If this is true then they actually in my opinion while developing safety features created another un safe condition where as the semi could have run over my wife and I killing us both. This was truly a near miss and we are very much concerned about it happening again to us or some one else, resulting in a fatal accident, not just a fender bender. Mercedes is in denial concerning any un safe condition and refused to take any responsibility for any damage that this car caused. Please review this vehicle for possible call back before some one does get seriously injured. Perhaps skid mode or traction control may be helpful but engine cut back and power loss needs to be left to the operator not the vehicle controlling it'

NHTSA complaint #10585027
← All 2012 Mercedes-Benz E350 problems & recalls