Brakes lines failed under truck do to rusted out lines
2004 GMC Sierra 2500 brakes problems
19 owners reported brakes problems — 38% of all 50 complaints about the 2004 GMC Sierra 2500.
Brakes complaints by GMC Sierra 2500 year
What owners report
Emergency brakes don't engage
I was traveling south on I-75 highway about 70 MPH, in motion, in northern michigan and had to stop fast when an accident occurred in front of me. I slammed/mashed my foot on the brake pedal only to feel it fall to the floor, the metal hydraulic line failed and I now have no brakes at all!! I began to press on the parking brake and down shift the transmission to assist in the… Read more
I was traveling south on I-75 highway about 70 MPH, in motion, in northern michigan and had to stop fast when an accident occurred in front of me. I slammed/mashed my foot on the brake pedal only to feel it fall to the floor, the metal hydraulic line failed and I now have no brakes at all!! I began to press on the parking brake and down shift the transmission to assist in the slowing of the vehicle. I also steered around the stopped cars into the side and ditch of the road. I luckily had the right reactions but not all people do or cannot act as fast. This is a dangerous issue with this GMC sierra 2004. Please have it recalled. I had to have the repair shop replace all the metal brake lines as they were corroded. I have never had a vehicle fail its brake lines like this. My vehicle only has 48,000 miles on it and is garage kept super clean.
In the past three months the fuel lines needed replacement as they had rusted so badly that a leak formed. Yesterday while pulling my 10,000 pound boat, my brakes suddenly failed because of a leak in the line between the ABS box and the right front wheel. The catastrophic failure nearly caused me to lose control of my vehicle and boat. I was able to downshift and… Read more
In the past three months the fuel lines needed replacement as they had rusted so badly that a leak formed. Yesterday while pulling my 10,000 pound boat, my brakes suddenly failed because of a leak in the line between the ABS box and the right front wheel. The catastrophic failure nearly caused me to lose control of my vehicle and boat. I was able to downshift and use by emergency brake to bring the rig to a stop.
I live in south east ma. Were sault is use always and it has rotted my brake lines at the ABS controll a line let go on my truck with family and my grand babies I am a heavy truck operator with a cdl so I know not to panic I got my truck stopped without a crash but if my wife was driveing or my young daughter they wouldnt be so lucky we in the saulting states should have… Read more
I live in south east ma. Were sault is use always and it has rotted my brake lines at the ABS controll a line let go on my truck with family and my grand babies I am a heavy truck operator with a cdl so I know not to panic I got my truck stopped without a crash but if my wife was driveing or my young daughter they wouldnt be so lucky we in the saulting states should have staneless steal for safty cant be to much to ask for young lifes at stake or people who panic what should I do at the time I was in the city of taunton I was coming to a heavily traveled street in rush hour trafic the brake line to rear brakes falled because of rot on inspion I see they are all rotting and need to be repaired I dont have body rot or frame rot of any kind always car wash after storms on nice days.
Tl* the contact owns a 2004 GMC 2500. The contact stated that the emergency brake was inoperable. The contact mentioned that the parking brake was depressed and an abnormal noise emitted from the under carriage of the vehicle. The contact believed that the parking brake cable was fractured. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 197,000.
Tl* the contact owns a 2004 GMC Sierra 2500. The contact stated that the brake failed to engage while attempting to apply the brake pedal while driving 35 MPH. The vehicle was towed to a local mechanic for inspection that confirmed that the brake lines were corroded. The vehicle was not repaired. The VIN was not available. The manufacturer was not made aware of the failure.… Read more
Tl* the contact owns a 2004 GMC Sierra 2500. The contact stated that the brake failed to engage while attempting to apply the brake pedal while driving 35 MPH. The vehicle was towed to a local mechanic for inspection that confirmed that the brake lines were corroded. The vehicle was not repaired. The VIN was not available. The manufacturer was not made aware of the failure. The failure and current mileage was 98,000.
When attempting to stop, the truck began to stop and then all of a sudden the brake pedal went to the floor. At this point there were no brakes at all. Thankfully no one was in front of me so I was able to coast until the vehicle slowed, and then use the e-brake to slow down enough to turn. Upon further inspection, a brake line had broken. *tr
Experienced a complete loss of service brakes. Fortunately this occured after completing a trip while towing a trailer. Had this happened during the trip serious injuries and multiple deaths could have been the result. Investigation of the problem indicated premture rusting through of the steel brake line to the right front disc brake. The brake line to the left front… Read more
Experienced a complete loss of service brakes. Fortunately this occured after completing a trip while towing a trailer. Had this happened during the trip serious injuries and multiple deaths could have been the result. Investigation of the problem indicated premture rusting through of the steel brake line to the right front disc brake. The brake line to the left front caliper is also badly rusted. The brake lines from the master cylinder are mildly rusted as well.
Got in vehicle, started it,put in gear,applied brake and pedal depressed farther than usual, hit again they went almost to floor.got out and saw brake fluid on frame where line had rusted in through.upon inspection all lines are terribly rusted and will need replaced. *tr
I was approaching a one lane covered bridge on the way home from work and another approaching vehicle failed to yield. I made an emergency stop by pressing firmly on the brakes. Brake pedal went right to the floor. I had to quickly use my foot operated emergency/parking brake to stop from having a head on collision. I had to pay close to $1200 to have the entire brake line… Read more
I was approaching a one lane covered bridge on the way home from work and another approaching vehicle failed to yield. I made an emergency stop by pressing firmly on the brakes. Brake pedal went right to the floor. I had to quickly use my foot operated emergency/parking brake to stop from having a head on collision. I had to pay close to $1200 to have the entire brake line system replaced due to severe rust of the brake lines. I am very fortunate that this turned out the way it did. My life and the lives of others are being endangered by GM not using a material that is resistant to corrosion. *tr
Brake lines rusted through. All brake fluid leaked out. No brake system including emergency brake failed. Had to stop vehicle against curb system. *tr
Brake lines all rotted away near ABS module mounted in frame. I had to take to a shop to get all line replace from ABS module forward. This truck has never been near salt ever. 100,000 miles and already relining the truck! Fuel lines look like they only have a few months left. This is a danger and a huge waste of money for a buyer I have had other GM cars that are 30 years old… Read more
Brake lines all rotted away near ABS module mounted in frame. I had to take to a shop to get all line replace from ABS module forward. This truck has never been near salt ever. 100,000 miles and already relining the truck! Fuel lines look like they only have a few months left. This is a danger and a huge waste of money for a buyer I have had other GM cars that are 30 years old with 350,000 miles with factory brake and fuel lines. *tr
Leaving small rural road. Brake pedal went to floor and vehicle rolled through stop sign. No oncoming traffic. Upon inspection, left forward brake line had ruptured due to corrosion. Only matter of time before other brake lines will fail. *tr
Second brake problem, second of three brake line problems from rusty brake lines and brake line failure while stopping and lose of brakes, needing to use emergency brake to stop. All remaining brake lines are completely rusted and need to be replaced for safe driving. This is completely unacceptable and are unsafe driving conditions. Brake lines should never fail from rust, period. *js
Both front hydraulic brake lines corroded on drivers side, with loss of braking, on chassis top rear of front wheel. It appears that there is a large wiring loom (1 1/2" o.d.) clipped on top of hydraulic lines, one to lf and rf wheels. Corrosion on both lines are at the contact of the loom and lines. Vibration may have caused the loom and lines to rub and allowed moisture to corrode the brake lines. *tr
When coming to a stop the pedal went to floor and had no brakes. Luckily I was able to swerve and miss the vehicle in from of me. But had to run through the four way stop and was blessed to have no other vehicles in way. The brake fluid was leaking from under the driver side about where the seat is. Upon investigation, the lines are all corroded and rusting. Obviously it only… Read more
When coming to a stop the pedal went to floor and had no brakes. Luckily I was able to swerve and miss the vehicle in from of me. But had to run through the four way stop and was blessed to have no other vehicles in way. The brake fluid was leaking from under the driver side about where the seat is. Upon investigation, the lines are all corroded and rusting. Obviously it only takes one to leak but all need to be replaced. This is such a surprise because this truck sits in the garage most of the time and has very few miles on it. *tt
Tl*the contact owns a 2004 GMC Sierra 2500. While the contact attempted to move the vehicle, the brakes failed. He inspected the vehicle and found a leak, and noticed that the brake lines were corroded and leaking brake fluid. The vehicle was towed to the dealership who stated that the main brake lines were also corroded. The vehicle was repaired. The manufacturer will be… Read more
Tl*the contact owns a 2004 GMC Sierra 2500. While the contact attempted to move the vehicle, the brakes failed. He inspected the vehicle and found a leak, and noticed that the brake lines were corroded and leaking brake fluid. The vehicle was towed to the dealership who stated that the main brake lines were also corroded. The vehicle was repaired. The manufacturer will be contacted. The failure and current mileages were 50,000. Updated 03/16/11*jb
Dt: the contact stated when applying brake pressure at 5 MPH or less there was a loss of power steering. When brake pressure was released, the power steering returned. He took the vehicle to the dealer, who stated the same pump activated the power steering and the power assist brakes;. He replaced a valve on the pump. The problem persisted, and he returned to the dealer. … Read more
Dt: the contact stated when applying brake pressure at 5 MPH or less there was a loss of power steering. When brake pressure was released, the power steering returned. He took the vehicle to the dealer, who stated the same pump activated the power steering and the power assist brakes;. He replaced a valve on the pump. The problem persisted, and he returned to the dealer. The dealer performed a diagnostic test that produced normal codes. There was technical service bulletin pit3310 , and the contact felt this was related to the ongoing problem. No further repairs have been made. *ak