At ~33k miles, the truck started having issues with a hard vehicle shudder at highway speeds (30–60 MPH). The issue felt like it was in the transmission and was slamming between gears here's the history so far: visit 1 — dealer replaced the valve body (gen 3 revision). Issue returned worse within a day. Visit 2 — dealer couldn't duplicate the concern on a short test drive,… Read more
At ~33k miles, the truck started having issues with a hard vehicle shudder at highway speeds (30–60 MPH). The issue felt like it was in the transmission and was slamming between gears here's the history so far: visit 1 — dealer replaced the valve body (gen 3 revision). Issue returned worse within a day. Visit 2 — dealer couldn't duplicate the concern on a short test drive, found no codes, opened a GM tac case. No repairs made. Visit 3 — dealer found the c1 clutch had scorched/failed, along with a failed stator bracket. Replaced both. Issue returned — picked up the truck, noticed a vibration immediately, and the same shudder came back over the following weekend while towing. Visit 4 — dealer installed a full replacement transmission. Issue returned again — same shudder, but this time with a check engine light and reduced power. Codes pulled showed: fuel system faults: p0087 (fuel rail low pressure), p228c (fuel pressure regulator performance - low pressure), p0336 (crankshaft position sensor performance) a large cluster of network/communication faults across the TCM, ECM, brake control module, power steering module, and central gateway module visit 5 - the engine actually shut down while driving, at the same moment the vehicle was shuddering. New codes included p228a and p228b "forced engine shutdown" faults tied to the fuel pressure regulator. The car was completely inoperable in a lane of traffic. Issue was reproduced by the dealer and assumed to be a TCM. After replac