On 7/2/24, I went to robinson brothers Ford in baton rouge, la to address an unrepaired recall item on a 1994 f350. The service advisor refused to perform the recall work. They stated that the vehicle was too old. This recall is concerning an issue with a switch that can leak break fluid and cause an engine fire.
2000 Ford F-350 brakes problems
42 owners reported brakes problems — 14% of all 304 complaints about the 2000 Ford F-350.
Brakes complaints by Ford F-350 year
What owners report
Tl* the contact owns a 2000 Ford F-350. The contact stated that the independent facility and the seller of the vehicle made no mention of a failure with the front brakes and the rear brakes, which were warped before the vehicle was sold. In addition, the engine cooling fan had holes. The vehicle was not inspected nor diagnosed by a dealer. The vehicle was inspected by an… Read more
Tl* the contact owns a 2000 Ford F-350. The contact stated that the independent facility and the seller of the vehicle made no mention of a failure with the front brakes and the rear brakes, which were warped before the vehicle was sold. In addition, the engine cooling fan had holes. The vehicle was not inspected nor diagnosed by a dealer. The vehicle was inspected by an independent mechanic and it was diagnosed that the engine cooling fan, and front and rear brakes needed to be replaced. The vehicle was not repaired. The vehicle was not taken to a dealer for diagnostic testing or repairs. The manufacturer was notified of the failure. The approximate failure mileage was 148,000.
Brake lines failed and truck ran into fence.
While driving 5-70 MPH consumer lost power steering/braking. Consumer managed to pull over, and had the vehicle towed. Deaalership repaired the power steering and brake components, but the consumer was still having the same problems. *ak
Vehicle was traveling about 30 MPH when all of a sudden the brakes did not work. There was brake fluid spilling, and the emergency brake was applied, but it was still difficult for the vehicle to come to a complete stop.*ak
The brake line had rusted . As a result, the brakes failed. No impact reported. *jb all the other lines including the fuel lines were rust free. *sc *jb
While driving 45 MPH consumer applied the brake pedal and the brakes failed, causing consumer's vehicle to collide with the vehicle in front. Driver sustained minor injuries, and vehicle was towed to the dealer for inspection. *ak
While applying the brake at various speeds, the vehicle vibrated. The vehicle was taken to the dealer and they replaced both front rotors, however the problem resurfaced. Please provide any further information and complete this questionnaire. *jb
Lost steering and brakes towing a trailer on an off ramp. High way 80 in wamsutter wy. Sudden loss of steering and brakes at the same time seems to be unsafe to me. To happen on a high way off ramp towing a trailer makes it even worse. *la
The brake pedal went to the floor when applied. The dealer has been notified. *nlm
Although I have only listed this as 1 instance of failure simply because this poorly designed (dangerous) solution finally cost me getting into an accident. This ABS problem has caused me to loose sleep at night since owning this vehicle because of the various times it has failed me! It shouldn't take an einstein to figure out there's something wrong with a brake system that… Read more
Although I have only listed this as 1 instance of failure simply because this poorly designed (dangerous) solution finally cost me getting into an accident. This ABS problem has caused me to loose sleep at night since owning this vehicle because of the various times it has failed me! It shouldn't take an einstein to figure out there's something wrong with a brake system that fails when you really need it to work! Not only does it fail the brakes, but since the power steering is used to (hydroboost) power the brake system, when the ABS unit dumps the fluid to release the brake pressure, you also loose steering ability! I don't know how many people have been killed by this inadequate design. I guess I should count myself lucky that I'm even able to write this, but this system is plainly inadequate and flawed at the design layer. Either someone requires this to be corrected or everyone that drives a vehicle with this type of solution better triple their life insurance and quadruple their liability insurance and attend church services daily in hopes that they survive the experience!!!!!!!!!! Oh, maybe I've touched on something there. Do you think the insurance companies mind the prospect of having everyone having to increase their insurance to prepare for the results? Dt
Truck is equipped with rear ABS. When making a rapid stop and the rear end hits a bump instead of the ABS modulating the brakes it releases all of the brakes. This has happened 3-4 times since I have had the truck and this problem is not isolated to just my truck. Checking the forums at Ford-diesel.com there are lots of others out there with this same problem. Dealers have… Read more
Truck is equipped with rear ABS. When making a rapid stop and the rear end hits a bump instead of the ABS modulating the brakes it releases all of the brakes. This has happened 3-4 times since I have had the truck and this problem is not isolated to just my truck. Checking the forums at Ford-diesel.com there are lots of others out there with this same problem. Dealers have told them it is normal. I don't buy it. The only way to regain braking is to let up on the pedal, then quickly reapply. There have been a couple of times when I just barely had time to do that. It is very scary because it is not like most ABS where the pedal will pulse. This acts as if the brakes have just totally released, and the pedal drops. I don't understand, nor does anyone else with the problem why the front brakes let go. If it is only rear wheel ABS then why do we lose the front brakes also? This is very dangerous because you really can't predict when it will do it. I know that I am very wary of the possibility that a little hop of the rear wheels during hard braking can cause this and drive cautiously. No problem with a load in the back of the truck, but with a light rear it can happen anytime. I am surprised no one has been hurt.*ak
Blue smoke coming from tail pipe. Form letter reply. *mc the tail latch was sticking, the rotor had to be machined, the windshield had to be re-sealed due to it leaking, the ball joints and serpentine belt were replaced, the valve cover gasket was leaking and had to be replaced. *jb
Retaining clip that attaches cable to parking brake pedal assembly failed, which caused cable to separate from the assembly rendering parking/emergency brake inoperable. Reported failures are common based upon internet search. Manufacturer denied problem exists with design although dealership service departments report multiple repairs of similar problem.*ak
Brake surges uncontrolabl, also replaced hitch but new hitch did not correct the problem.
While approaching the highway, brakes were applied, the ABS light came on, then brakes locked up and engine failed to slow down causing brakes to go in ABS, consumer ran into another vehicle and started to push the other vehicle two lanes length. Consumer applied park brake and vehicle stopped. Contacted dealer and the dealer could not find the cause. *ak *tt
During brake application while driving at any speed vehicle will pull intermittently to right and / or left, more severe at higher speeds. Dealership has examined vehicle nine times, and replaced brake calipers/pads/ lines/ rear spring shackle adjustments, and positive caster. Dealership has been unable to effectively remedy problem ,and informed consumer no more… Read more
During brake application while driving at any speed vehicle will pull intermittently to right and / or left, more severe at higher speeds. Dealership has examined vehicle nine times, and replaced brake calipers/pads/ lines/ rear spring shackle adjustments, and positive caster. Dealership has been unable to effectively remedy problem ,and informed consumer no more service would be performed on this vehicle. Please provide any additional information / documentation.*ak
My first serious situation occurred when I was pulling a 6000lb tractor. Conditions where good weather clear and outside temp 98. When approaching an area of hwy four lane divided hwy( 2 north 2 south). This area of hwy has several traffic lights spaced about two miles apart from one another. The truck operated as expected on the first three of lights. When I applied the… Read more
My first serious situation occurred when I was pulling a 6000lb tractor. Conditions where good weather clear and outside temp 98. When approaching an area of hwy four lane divided hwy( 2 north 2 south). This area of hwy has several traffic lights spaced about two miles apart from one another. The truck operated as expected on the first three of lights. When I applied the brakes for the fourth time my truck pulled left so hard the cross bar on the steering wheel was straight up and down and I was still headed into the median toward north bound traffic, I released the brake pedal as soon as I went into the grass to regain control, once stopped I checked under my truck for a possible broken brake line, but I seen nothing wrong. I proceeded to the office after checking everything and things seemed ok after the brakes cooled down. During checking the brakes and lines the left front rotor seemed very much hotter than the right front! The truck has been doing this and continues to do this. Southwest Ford in weatherford is the only dealer that has worked on it for this problem. They keep changing the pads and rotors and giving it back. I told them the conditions in witch the truck pulls but they will not load it. They want me to load it and bring it to them!!! I am very frustrated and worried to load it, and drive it. I have done everything they have asked and I guess I will load it too. But this will be the last straw! I had found an old message on the internet from "the carringtons
Master cyclinder has broken in half while stopping at a stop sign. Dealer has yet to be contatced. *ak *nlm
ABS braking system is defective. Dealership is aware of problem. *ak
When making a slow turn in either direction power steering locks up. This also affects brakes. *ak
During breaking, ABS activated and I was completely unable to steer the vehicle.. *ak
Brakes failed at 50 MPH, consumer then lost all steering and hit a guardrail at 35-40 MPH. Damage to vehicle was $ 7000. *ak *jb
Consumer applied brake at 50 MPH , brakes failed, and vehicle hit a guardrail at about 35-40 MPH.damage to vehicle was $ 7000. *ak *jb
Dates are not correct as I do not have information in front. Major brake issues, transmission shifting issues and turbo is now leaking oil again. Lots of intermittent issues that no one can duplicate. Unsure what to do. *ak
When traveling on highway went to apply brakes and brakes didn't hold. There were no injuries. *ak
Truck pulls uncontrollably to left , worse under heavy braking, Ford is aware of the problem but has no answers yet to solve this problem, brakes stop working if you hit a large bump in the road while braking. *ak
Vehicle was sitting in traffic and another vehicle was in front, and consumer pulled off on the right shoulder of the road, and the other vehicle tried to make a u-turn, and hit consumer's vehicle broadside. Front end was smashed, and driver side airbag didn't go off . Also, ABS brakes didn't kick in at all.*ak
On 1/28/2000, the operator of this vehicle parked it outside a business and put the truck in low gear, applied the emergency brake, turned the ignition off and exited and locked the vehicle. It was parked on a small downward slope and the vehicle began to roll and crossed 2 lanes of traffic, made a sharp left hand turned, looped around and ran through a wall of a business. … Read more
On 1/28/2000, the operator of this vehicle parked it outside a business and put the truck in low gear, applied the emergency brake, turned the ignition off and exited and locked the vehicle. It was parked on a small downward slope and the vehicle began to roll and crossed 2 lanes of traffic, made a sharp left hand turned, looped around and ran through a wall of a business. The owner of this business was present and witnessed the incident and when our driver came out of the building he was in, the property owner and our driver and another witness walked to the truck and watched while our driver unlocked the vehicle at which time it began to roll backwards. Four people witnessed that the truck was turned off and also witnessed the truck being unlocked by our operator and verified the truck was in low gear and that the emergency brake was applied. We would like to know if other similar problems have been reported as we have 2 additional f350's (a 1999 and another 2000) in which case the operators have reported similar braking problems although accidents haven't occured in the other two. I will also report those separately as complaints. Could you estimate a time frame for investigating this complaint? Thank you, tammy giles/office manager. *ak
While driving on highway and slowing down to make a turn, vehicle started making loud noises. Also, steering got hard to turn, and had no brakes. Pulled over and shut vehicle off. Started it back up and everything was fine. Another time wife had the vehicle, went to stop at a red light, and vehicle went straight through the intersection into the ditch. Had no power… Read more
While driving on highway and slowing down to make a turn, vehicle started making loud noises. Also, steering got hard to turn, and had no brakes. Pulled over and shut vehicle off. Started it back up and everything was fine. Another time wife had the vehicle, went to stop at a red light, and vehicle went straight through the intersection into the ditch. Had no power brakes or steering. Contacted dealer. *ak