While driving my 2017 Ford Expedition limited 4wd at approximately 45 MPH, the speedometer suddenly dropped to 0 MPH even though the vehicle was still moving. At the same time, the wrench warning light illuminated, and the transmission became stuck in third gear. The transmission would no longer shift normally, including when slowing down and accelerating again. I was able to… Read more
While driving my 2017 Ford Expedition limited 4wd at approximately 45 MPH, the speedometer suddenly dropped to 0 MPH even though the vehicle was still moving. At the same time, the wrench warning light illuminated, and the transmission became stuck in third gear. The transmission would no longer shift normally, including when slowing down and accelerating again. I was able to safely pull over, shut off the engine, and restart the vehicle. After restarting, the speedometer and transmission returned to normal operation, and the warning light disappeared. This is approximately the third time this same failure has occurred within the past 15,000 miles. The vehicle has approximately 200,000 miles and previously displayed diagnostic trouble code p0720, indicating an output shaft speed sensor circuit malfunction. These symptoms appear consistent with a possible failure of the transmission’s molded lead frame or integrated output shaft speed sensor in the 6r80 automatic transmission. I am concerned that this intermittent failure could result in an unexpected transmission downshift, sudden deceleration, or loss of normal transmission operation while driving at highway speeds, increasing the risk of a collision. I understand similar transmission lead-frame failures have been documented in other Ford vehicles equipped with the 6r80 transmission. I am requesting that NHTSA investigate whether the 2017 Ford Expedition is affected by the same potential safety defect.