Nov 16, 2026steering
I own a 2011 Ford Crown Victoria police interceptor with an outstanding safety recall, Ford 13s08 (NHTSA 13v385000), involving corrosion of the lower intermediate steering shaft and potential loss of steering control. My vehicle is experiencing steering binding and inconsistent resistance, becoming excessively tight or loose depending on the steering wheel’s position. This… Read more
I own a 2011 Ford Crown Victoria police interceptor with an outstanding safety recall, Ford 13s08 (NHTSA 13v385000), involving corrosion of the lower intermediate steering shaft and potential loss of steering control. My vehicle is experiencing steering binding and inconsistent resistance, becoming excessively tight or loose depending on the steering wheel’s position. This presents a serious safety concern. On xxx, I brought my vehicle to bonnell Ford in [xxx] for the recall. The dealership ordered a part and scheduled the repair for xxx after leaving my vehicle for several hours on xxx I was informed that bonnell could not perform the repair because it lacked the required specialized equipment. The service manager stated that other Ford dealerships and a regional representative had been contacted, but nobody in [xxx] could locate the equipment. I opened a repair assistance case with Ford corporate. Rather than arranging a solution, Ford representatives instructed me to contact other dealerships myself or pursue repairs at my own expense. On xxx, I contacted Ford again. Despite speaking with multiple representatives, including level 2, no solution was provided. When I requested a supervisor, the level 2 representative accused me of potentially “holding her line hostage” and stated that a supervisor callback would take 24–48 hours. My vehicle remains unrepaired, with no confirmed repair location, timeline, or alternative remedy. I am requesting NHTSA investigate Ford’s f
NHTSA complaint #11778439
Nov 2, 2026steering
Ford is refusing to honor the 14s25 recall. The recall was completed xxx9. The part appears to be the same and research supports this. How does replacing the same faulty part solve the problem? How is that considered a repair? "on your vehicle, it may be possible that the upper intermediate steering shaft was serviced incorrectly during previous repairs for safety recall… Read more
Ford is refusing to honor the 14s25 recall. The recall was completed xxx9. The part appears to be the same and research supports this. How does replacing the same faulty part solve the problem? How is that considered a repair? "on your vehicle, it may be possible that the upper intermediate steering shaft was serviced incorrectly during previous repairs for safety recall 13s08 or regional program 13r01." - I take it as the recall was serviced incorrectly since one can be mistaken it wasn't serviced at all. Regardless, this is a safety issue and it is unacceptable it is being ignored considering no improvements were made to the design. What difference does it make replacing the part with another faulty part two years after manufacture when now the car is 15 years old? The part is certainly in worse condition now and I fear the safety of highway travel going forward. Ford doesn't seem to have any compassion. Please let me know if you would like photos to be sent in. I am willing to provide images of the corroded part that can fail anytime soon. NHTSA bulletin: [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6)
NHTSA complaint #11775187
Apr 28, 2023steering
I learned of recall on some models of Crown Victoria police interceptor. I own 3 such vehicles. Two were identified for recall, the third a 2011 however was not. This car has signs of steering issues very hard to turn the wheel at times. There is rust on the lower intermediate steering shaft and at the u joints of the shaft. When I took the other vehicles in for recall… Read more
I learned of recall on some models of Crown Victoria police interceptor. I own 3 such vehicles. Two were identified for recall, the third a 2011 however was not. This car has signs of steering issues very hard to turn the wheel at times. There is rust on the lower intermediate steering shaft and at the u joints of the shaft. When I took the other vehicles in for recall servicing I provided the VIN # for the 2011 and was informed that there was no recall for it. I am hoping that the recall can be expanded to include this vehicle which is showing some signs of steering shaft issues.
NHTSA complaint #11519486
Apr 28, 2023steering
Vehicle is exhibiting stiff steering issues associated with steering column. Mechanic determined steering shaft requires replacement. This vehicle was already involved in a steering column recall several years ago however the problem appears to have returned.
NHTSA complaint #11519396
Aug 6, 2021steering
The contact owns a 2011 Ford Crown Victoria. The contact stated while driving 40 MPH, the steering wheel started clicking and making an abnormal popping sound. The contact stated that the steering wheel was difficult to maneuver. There was no warning light illuminated. The contact stated he was able to continue to drive the vehicle. The vehicle was taken to the dealer who… Read more
The contact owns a 2011 Ford Crown Victoria. The contact stated while driving 40 MPH, the steering wheel started clicking and making an abnormal popping sound. The contact stated that the steering wheel was difficult to maneuver. There was no warning light illuminated. The contact stated he was able to continue to drive the vehicle. The vehicle was taken to the dealer who diagnosed that the intermediate steering shaft needed to be replaced. The manufacturer was made aware of the failure and advised the contact that the VIN was not included in NHTSA campaign number: 14v704000 (steering) or 13v385000 (steering). The vehicle was not repaired. The approximate failure mileage was 160,000.
NHTSA complaint #11428047
Jan 14, 2021steering
Tl* the contact owns a 2011 Ford Crown Victoria. The contact stated that while driving at speeds above 60 MPH, the front end would vibrate and a clunking noise was present coming from the steering column. Eventually the steering column would not lock after parking the vehicle. The vehicle was taken to an independent mechanic who diagnosed that the lower steering shaft bearing… Read more
Tl* the contact owns a 2011 Ford Crown Victoria. The contact stated that while driving at speeds above 60 MPH, the front end would vibrate and a clunking noise was present coming from the steering column. Eventually the steering column would not lock after parking the vehicle. The vehicle was taken to an independent mechanic who diagnosed that the lower steering shaft bearing was faulty. The vehicle was not repaired. The local dealer rye Ford located at 1151 boston post rd, rye, ny 10580 and the manufacturer were notified. The contact was informed that the vehicle was not included in NHTSA campaign number: 13v385000 (steering). The contact stated that the vehicle had experienced the same failure listed in the recall. The failure mileage was 82,000.
NHTSA complaint #11388103
Apr 30, 2020steering
My steering I super had to turn the wheel when parked as well as driving. It is because of the steering shaft is rusted out and very dangerous to drive .I just found out that Ford had a recall on this issue but I never received a notice about it
NHTSA complaint #11322802
May 20, 2019steering, suspension, unknown or other
There is a recall on my car,the rite front wheel is making poping sounds.
NHTSA complaint #11208767
Mar 13, 2014steering
2011 Ford Crown Victoria. Consumer writes in regards to steering column shaft recall notice. *smd the dealer informed the consumer, the vehicle would be inspected. However, the consumer stated according to the recall notice, the part would be replaced, as well as inspecting otter parts. The service representative responded again, by saying, first there would be an… Read more
2011 Ford Crown Victoria. Consumer writes in regards to steering column shaft recall notice. *smd the dealer informed the consumer, the vehicle would be inspected. However, the consumer stated according to the recall notice, the part would be replaced, as well as inspecting otter parts. The service representative responded again, by saying, first there would be an inspection to determine if the part needed to be replaced. The consumer stated he did not want to waste a day, just for an inspection. So he decided to make an appointment with another establishment, to have to part replaced.*jb
NHTSA complaint #10568470
Jun 27, 2013steering, suspension, service brakes
Steering this car was a nightmare always pulling to the right. Also brakes constantly grabbing and screeching. Also headlight and suspension problems. Was not happy with this car from start but was slammed into by dealership and chase... I am a senior citizen 76 years old. Please help. *tr
NHTSA complaint #10522077
Oct 1, 2012steering, suspension
Inspection found dislocated bushing. *tr
NHTSA complaint #10478033
Oct 1, 2012steering, suspension
Inspection found dislocated bushing. *tr
NHTSA complaint #10478028
Sep 21, 2012steering
Inspection found the lower column bushing dislodged from tube and shaft working out of spline. *tr
NHTSA complaint #10476621
Sep 21, 2012steering
Inspection found lower bushing of steering column dislodged and shaft working out of spline. *tr
NHTSA complaint #10476620