Oct 19, 2021power train
The yoke assembly on rear driveshaft broke and the rear part of shaft fell to the ground while making a turn on paved road. I was about to back down an inclined boat ramp to put boat in river. The boat was an aluminum john boat, motor and trailer not weighing over 800 pounds. Vehicle and boat could have gone in river or the truck could have hit someone. The vehicle was towed… Read more
The yoke assembly on rear driveshaft broke and the rear part of shaft fell to the ground while making a turn on paved road. I was about to back down an inclined boat ramp to put boat in river. The boat was an aluminum john boat, motor and trailer not weighing over 800 pounds. Vehicle and boat could have gone in river or the truck could have hit someone. The vehicle was towed and is being repaired by local repair shop. There were no warning lights or any unusual noise prior to the incident. The truck has 135,000 miles on the odometer. The shop were the repairs are being done said this was a common problem he has seen on many Toyota tundras and not any particular year.
NHTSA complaint #11437362
Oct 21, 2020suspension, power train, unknown or other
Rust rust rust
NHTSA complaint #11365494
Apr 12, 2019steering, suspension, power train
Takata recall 2006 Toyota Tundra sr5 4x4. Purchased about a year ago. Power steering failed a couple months in while driving to work. Found fluid leaking I crawled underneath and founf the entire frme rusted and both anti roll bar links have separated from control arms. The bushings and nuts were missing and the powersteering link is from rotted boot on the pasenger side.
NHTSA complaint #11195903
Jan 3, 2019power train
The rear differential cover plate is leaking gear oil. The cover plate is fixed in place not bolted on. The excessive corrosion of the entire rear axle assembly is the problem. The only solution is to replace the entire rear axle assembly. There is an existing recall for Toyota tacomas so I contacted Toyota and they will not address the problem without a recall initiated… Read more
The rear differential cover plate is leaking gear oil. The cover plate is fixed in place not bolted on. The excessive corrosion of the entire rear axle assembly is the problem. The only solution is to replace the entire rear axle assembly. There is an existing recall for Toyota tacomas so I contacted Toyota and they will not address the problem without a recall initiated by NHTSA. Should this cover plate totally fail while on the highway the resulting in loss of control the resulting accident may cause loss of life for this vehicle and other vehicles traveling on the same highway.
NHTSA complaint #11165637
Nov 14, 2018power train, structure
Had truck towed due to broken brake line and was advised by mechanic that frame was severely corroded with holes above front wheels and was not safe to drive. Rear end also severely corroded. Contacted Toyota dealer, no warranty or recall on 2006 frames although tundras and tacomas older and newer than 2006 are getting warrantied frame replacements due to recalls. Dealer… Read more
Had truck towed due to broken brake line and was advised by mechanic that frame was severely corroded with holes above front wheels and was not safe to drive. Rear end also severely corroded. Contacted Toyota dealer, no warranty or recall on 2006 frames although tundras and tacomas older and newer than 2006 are getting warrantied frame replacements due to recalls. Dealer went to the garage that had towed the truck and inspected the frame. Dealer advised us to get holes in frame fixed at our expense. Dealer verified that there was an earlier recall to spray frames, but the spray had limited availability from Toyota and they were unable to fulfill the recall when we brought the truck to them for this service. The vehicle currently has 150,000 miles on it and should have been drivable for many more. We lodged a complaint with Toyota USA on 11/14/2018, complaint# 181 114 1536 and are next entering a complaint with the nh attorney general.
NHTSA complaint #11151487
Feb 21, 2018power train
Drove my truck about 200 miles that day. Pulled into my driveway and unloaded a formica counter top in my garage then pulled my truck to it's normal parking spot. Walked back to the garage and saw a rather large grease spot. Looked at the rear of my truck and the rear end housing was leaking around the pumpkin area. Took it to my mechanic and he told me my whole rear end… Read more
Drove my truck about 200 miles that day. Pulled into my driveway and unloaded a formica counter top in my garage then pulled my truck to it's normal parking spot. Walked back to the garage and saw a rather large grease spot. Looked at the rear of my truck and the rear end housing was leaking around the pumpkin area. Took it to my mechanic and he told me my whole rear end housing was rusted out and had to be replaced. Since this is a problem with these trucks (frame was replaced a year ago) my mechanic told me there are no good used rear ends to be found and it would require a new rear end housing. If Toyota had made a recall on frame issues, why haven't they done the same with the rear end housing. A catastrophic failure of the rear driving train seems to me would be a major safety issue!!
NHTSA complaint #11073993
Dec 28, 2017power train, structure, engineCrash1 injured
Tamara recall - I was exiting the freeway, making a left hand turn onto the city street, I was traveling approximately 25 miles per hour. As I entered the intersection, on a green light, a 1996 gmc yukon ran a red light, travelling approximately 40 miles an hour and hit me on my front end, damaging the bumper, fender, door, hood and bed on the drivers side. I was wearing my… Read more
Tamara recall - I was exiting the freeway, making a left hand turn onto the city street, I was traveling approximately 25 miles per hour. As I entered the intersection, on a green light, a 1996 gmc yukon ran a red light, travelling approximately 40 miles an hour and hit me on my front end, damaging the bumper, fender, door, hood and bed on the drivers side. I was wearing my seatbelt but the impact was hard enough to propell me upwards, causing my left shoulder to hit the frame above the window which caused a grade 3 separation of my left collarbone.
NHTSA complaint #11057017
Jun 4, 2015power train, air bags, structureCrash3 injured
A 1992 ford f-250 (2 door) towing a portable cement mixer, estimated weight @350-450 pounds, crossed the center line and struck a 2006 Toyota Tundra crew cab (4 door) head on. Both vehicles estimated speed was 50 MPH. All drivers and passenger were wearing seat belts, airbags did deploy. The f-250's driver sustained 1 detached rib plus cuts and bruises. In the Toyota, the… Read more
A 1992 ford f-250 (2 door) towing a portable cement mixer, estimated weight @350-450 pounds, crossed the center line and struck a 2006 Toyota Tundra crew cab (4 door) head on. Both vehicles estimated speed was 50 MPH. All drivers and passenger were wearing seat belts, airbags did deploy. The f-250's driver sustained 1 detached rib plus cuts and bruises. In the Toyota, the following injuries occurred: passenger: broken left ankle, 7 broken ribs, sternum and clavicle fractures, 7 inch leg laceration, 5 inch hand laceration, cuts & bruises. Driver: broken right ankle, brain contusion/concussion (visible impact spot on windshield - see below), broken rib, cuts and bruises. Toyota's occupants confirmed that the engine/transmission intruded about 2 feet into the passenger compartment, consistent with the ankle injuries. It also appears from photos that the windshield was pushed back into the driver, although the belt and airbag could have not provided adequate protection also. Frontal photos of the Toyota show, apparently, that the bodywork detached from the frame - the front of the frame is clearly visible & does not look seriously damaged, with the bodywork (including the bumper) pushed back substantially. It seems to me there are several possible defect/design issues here: 1. Engine and transmission came straight back and did not deflect downwards, causing the lower extremity injuries. 2. Multiple rib injuries despite occupants being belted suggests excessive airbag I
NHTSA complaint #10723418
Aug 19, 2010power train, vehicle speed controlCrash
Tl* the contact owns a 2006 Toyota Tundra. The contact was driving 30 MPH and there was an abnormal increase in engine rpms causing the transmission not to shift correctly. She depressed the brakes and the tachometer increased to 2 and would not decline. In addition, when she attempted to shift into reverse and released the brakes, the rear tires began to spin and she crashed… Read more
Tl* the contact owns a 2006 Toyota Tundra. The contact was driving 30 MPH and there was an abnormal increase in engine rpms causing the transmission not to shift correctly. She depressed the brakes and the tachometer increased to 2 and would not decline. In addition, when she attempted to shift into reverse and released the brakes, the rear tires began to spin and she crashed rear-end into a boulder. The rear bumper was damaged and there were no injuries. The dealer stated they were advised by the manufacturer not to diagnose the vehicle. The vehicle was neither diagnosed nor repaired. The contact stated that the vehicle has had three transmissions since purchase. The failure mileage was 20,000 and the current mileage was 53,000. Updated 11/9/10 *cn the consumer stated the transmission had to be replaced three times. She also stated there were times when the vehicle would just take off at a high speed when the accelerator pedal was tapped lightly. When the vehicle was started, the engine would race extremely high. The high idle would also effect the way the vehicle shifted into gear. Updated 11/12/10 the drivers side has a grommet and the floor board has a grommet, but there is no hook to hold the floor mat in place. Also, the transmission has been replaced three times. Updated 11/1/610
NHTSA complaint #10350553
Oct 18, 2009power trainCrash
Toyota Tundra 2006 double cab 4wd automatic transmission. I was 4 wheeling and stopped behind a polaris, by approximately 5 feet. I was in drive and 4wd and brakes applied. I stopped because the polaris had stopped. All of a sudden with the brakes applied my Tundra lunged forward at a very high rpm crashing into the polaris. At that point I put the transmission into park and… Read more
Toyota Tundra 2006 double cab 4wd automatic transmission. I was 4 wheeling and stopped behind a polaris, by approximately 5 feet. I was in drive and 4wd and brakes applied. I stopped because the polaris had stopped. All of a sudden with the brakes applied my Tundra lunged forward at a very high rpm crashing into the polaris. At that point I put the transmission into park and shut the engine off. Had I not responded with the action I took I would have shoved the polaris with 2 people into a very deep wash. Needless to say there is a great deal of damage done to my Toyota. The Toyota has major damage to the front end. Had I not taken the action that I did, we all would have ended up in the deep wash with major injuries. When I arrived home I immediately called tim's Toyota in prescott arizona where the vehicle was purchased. The 2 people that could help me with the situation were not available so a call to them tomorrow will be in order. I have not contacted my insurance as yet as I feel that Toyota is the responsible party for the accident. I had written to you quite a long time ago regarding the cruise control surging to 5000 rpm's when approaching even a minor incline. So I don't use it anymore. I am afraid to drive my truck into my garage for fear that the truck will lunge forward, only this time it will crash into my hvac and water heater, both are on propane. *tr
NHTSA complaint #10288886