Jul 13, 2021vehicle speed control
I have a 2000 Sienna with 305000 miles. I have never had trouble with this vehicle until about 2 weeks ago. When I am stopped and my car is in drive, I just tap the gas pedal for a second and the engine rpm will increase to about 2000 rpm and will stay there until I put the car in neutral or turn the engine off. This is a problem because my breaks barely hold this and I must… Read more
I have a 2000 Sienna with 305000 miles. I have never had trouble with this vehicle until about 2 weeks ago. When I am stopped and my car is in drive, I just tap the gas pedal for a second and the engine rpm will increase to about 2000 rpm and will stay there until I put the car in neutral or turn the engine off. This is a problem because my breaks barely hold this and I must put the car into neutral for the car to stop pulling forward. Putting the car into neutral resets the rpm. If there is no car in front of me, I can release the brakes and the vehicle will continue to accelerate until the transmission switches to second gear, at this point I can drive normally. One time the vehicle continued to accelerate even after switching gears, I put the vehicle into neutral and the engine went to over 4000 rpm, the brakes could not stop the vehicle, I had to turn the engine off. The gas pedal is not sticky or stuck, floor mats are not in the vehicle. I can rev the engine normally when I am in park, this only happens when I am in gear. I have checked the throttle body, throttle position sensor and disabled the cruise control module, I can see no reason for this to happen. I have seen many complaints about this same issue online but have not found a resolution. I can buy an ECM but this is an expensive trial. I will take it to the dealer from here.
NHTSA complaint #11424539
Sep 24, 2019parking brake, vehicle speed control, service brakes
Tl* the contact owns a 2000 Toyota Sienna. When the ignition was started, the vehicle started to accelerate and moved forward without shifting into drive. The contact depressed the brake pedal and applied the emergency brake, but both failed to stop the vehicle. The contact was able to stop the vehicle by shifting into neutral gear. There were no warning indicators… Read more
Tl* the contact owns a 2000 Toyota Sienna. When the ignition was started, the vehicle started to accelerate and moved forward without shifting into drive. The contact depressed the brake pedal and applied the emergency brake, but both failed to stop the vehicle. The contact was able to stop the vehicle by shifting into neutral gear. There were no warning indicators illuminated. The vehicle was not diagnosed or repaired. A dealer and the manufacturer were not notified. The failure mileage was 210,581.
NHTSA complaint #11257729
Nov 27, 2017vehicle speed control
Tl* the contact owns a 2000 Toyota Sienna. While driving approximately 30 MPH, the vehicle accelerated on its own. The vehicle did a stop and go action that occurred every time the vehicle moved. The contact had to place the vehicle in neutral in order to stop it completely. The manufacturer and dealer were not notified. The vehicle was not diagnosed or repaired. There were no… Read more
Tl* the contact owns a 2000 Toyota Sienna. While driving approximately 30 MPH, the vehicle accelerated on its own. The vehicle did a stop and go action that occurred every time the vehicle moved. The contact had to place the vehicle in neutral in order to stop it completely. The manufacturer and dealer were not notified. The vehicle was not diagnosed or repaired. There were no recalls on the vehicle. The failure mileage was 200,000.
NHTSA complaint #11048620
Apr 4, 2017vehicle speed control, fuel/propulsion system
Yesterday afternoon, I was driving on a semi busy road in tucson, arizona at about 40 MPH and the van suddenly began to accelerate. I immediately thought I had hit the cruise control button but the dash showed no indication that this was case. I repeatedly pushed the cruise control button and jiggled the lever arm hoping to toggle something off but it had no effect. I began to… Read more
Yesterday afternoon, I was driving on a semi busy road in tucson, arizona at about 40 MPH and the van suddenly began to accelerate. I immediately thought I had hit the cruise control button but the dash showed no indication that this was case. I repeatedly pushed the cruise control button and jiggled the lever arm hoping to toggle something off but it had no effect. I began to push the breaks but they were not capable of slowing the car below about 25. I threw the van into neutral and the engine revved up to about 7000 rpm. That sound concerned me so I threw it back into gear and the van began to accelerate again. I pushed the emergency breaks, and with my pedal break fully compressed I could get the car to 5-10 MPH but there was absolutely no way to stop the van. After narrowly missing a pedestrian, I turned right, found a place to pull off to the side of the road, threw the van into neutral and quickly turned the van off. With the engine turned off the breaks were as effective as the should have been so the the van came to a stop. After a brief period I turned the key, started the van and, again, the engine again revved to 7000 rpm. I turned it off again. I pumped the accelerator several times before starting it again and it started up fine. I had the van towed after this and I'm not likely to drive it again.
NHTSA complaint #10970623
Sep 19, 2016vehicle speed control
Tl* the contact owns a 2000 Toyota Sienna. While driving various speeds, the vehicle experienced unintended acceleration. The vehicle was taken to an independent mechanic who was unable to determine the cause of the failure. The manufacturer was not notified. The failure mileage was 189,000.
NHTSA complaint #10907691
Aug 31, 2016vehicle speed control
While parking the vehicle and curbing the tires on a medium downward grade, with car in "drive" and my right foot fully on the brake pedal, the engine suddenly and unexpectedly went full throttle. By applying maximum pressure on the brake pedal, I was able to slow the forward motion of the vehicle as it jumped the curb, heading for the wall of a local school. By continuing… Read more
While parking the vehicle and curbing the tires on a medium downward grade, with car in "drive" and my right foot fully on the brake pedal, the engine suddenly and unexpectedly went full throttle. By applying maximum pressure on the brake pedal, I was able to slow the forward motion of the vehicle as it jumped the curb, heading for the wall of a local school. By continuing applying maximum brake pressure and disengaging the transmission, I was able to stop the vehicle...approximately two feet short of impact with the wall. By good fortune, there were on injuries, and no property damage. But it could have been a tragedy. There was a function at the school on the day of the incident, and parents with children were on the sidewalk in the area both before and after the incident. Upon stopping the car and turning off the engine, I immediately checked mat positions, my foot positions, and the throttle pedal area. The was absolutely no interference between the mat and the throttle pedal, nor any contact or interference of any kind with the pedal. As I considered the car far too dangerous to drive at that point, I had it towed back to my residence. Inspection of the vehicle and further action is pending.
NHTSA complaint #10902936
Apr 28, 2016vehicle speed control
Tl* the contact owns a 2000 Toyota Sienna. The contact stated that when starting the vehicle, it would rev up than accelerate up to 60 MPH without warning. The vehicle would also independently accelerate when attempting to accelerate from a stop. The contact had not taken the vehicle to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was not made aware… Read more
Tl* the contact owns a 2000 Toyota Sienna. The contact stated that when starting the vehicle, it would rev up than accelerate up to 60 MPH without warning. The vehicle would also independently accelerate when attempting to accelerate from a stop. The contact had not taken the vehicle to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 200,000. The VIN was not available.
NHTSA complaint #10861977
Apr 11, 2016vehicle speed controlCrash1 injured
Tl* the contact owns a 2000 Toyota Sienna. While driving at an unknown rate of speed, the vehicle independently surged forward at a high rate of speed. The contact swerved and crashed into a wall. The driver's and front passenger side air bags deployed. The driver sustained extensive bruising to the left knee and sternum, which required medical attention. The manufacturer was… Read more
Tl* the contact owns a 2000 Toyota Sienna. While driving at an unknown rate of speed, the vehicle independently surged forward at a high rate of speed. The contact swerved and crashed into a wall. The driver's and front passenger side air bags deployed. The driver sustained extensive bruising to the left knee and sternum, which required medical attention. The manufacturer was not notified. A police report was filed. The failure mileage was not available.
NHTSA complaint #10854799
Oct 13, 2015vehicle speed control
Tl* the contact owns a 2000 Toyota Sienna. On several occasions, the vehicle accelerated independently. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 226,000.
NHTSA complaint #10781591
Apr 25, 2014fuel system, gasoline, vehicle speed control
Vehicle suddenly accelerates when the gas pedal is lightly tapped. The engine will accelerate over 2000 rpm a stay there until the ignition is turned off. If the brakes are not held down during this time the vehicle would certainly crash into anything in its way. Gas pedal is not sticky or stuck, floor mats are not in vehicle, and throttle is closed yet the vehicle still… Read more
Vehicle suddenly accelerates when the gas pedal is lightly tapped. The engine will accelerate over 2000 rpm a stay there until the ignition is turned off. If the brakes are not held down during this time the vehicle would certainly crash into anything in its way. Gas pedal is not sticky or stuck, floor mats are not in vehicle, and throttle is closed yet the vehicle still accelerates? Can not find any other issues for this model and year online for help or advice. *tr
NHTSA complaint #10584983
Feb 4, 2010vehicle speed control
While driving on tollway in our 2000 Sienna with cruise set to 70 MPH I pushed the accelerator a little to increase speed a few MPH. It instantly took off as if I had hit the "resume" on the cruise control (cc) and had it set for 120 MPH. After a few seconds of panic I hit the brakes to slow the van and release the cc. No luck. With no traffic near me I looked to see if… Read more
While driving on tollway in our 2000 Sienna with cruise set to 70 MPH I pushed the accelerator a little to increase speed a few MPH. It instantly took off as if I had hit the "resume" on the cruise control (cc) and had it set for 120 MPH. After a few seconds of panic I hit the brakes to slow the van and release the cc. No luck. With no traffic near me I looked to see if the acc. Pedal was stuck, floor mat was interfering, or something else holding the pedal down - nothing was. I turned off the cc, pumped the accelerator pedal, stomped on the brakes and was just about to put van in neutral when we went back to normal control. We took van to Toyota dealer next day, but they could find nothing wrong. They called Toyota and were told it was not a known problem, so no fix. We still drive it daily, but do not use the cc in traffic, or accelerate with the cc on. This was not a stuck pedal, nor a floor mat problem. Because we have not used the cc in the same manner as when the sudden acceleration happened, I would think it is cc related. *tr
NHTSA complaint #10305945
Feb 4, 2010vehicle speed controlCrash
In summer of 2000, I had an accident in a 99 Toyota Sienna and my accelerator stuck causing me to have to put the car in reverse to stop forward motion after impact. I reported the stuck accelerator to dealer, and state farm. My car was totaled. The accident occurred at an intersection and another driver hit me from the right - he ran a red light and was cited as at fault,… Read more
In summer of 2000, I had an accident in a 99 Toyota Sienna and my accelerator stuck causing me to have to put the car in reverse to stop forward motion after impact. I reported the stuck accelerator to dealer, and state farm. My car was totaled. The accident occurred at an intersection and another driver hit me from the right - he ran a red light and was cited as at fault, but after the impact, my car continued to go forward and although I had my foot on my brake all the way to the floor the car would not stop. I had my two young children in the car who were screaming in fear and pain, and there were two rows of cars in every direction stopped at the intersection. I looked at a concrete pillar in a parking lot and thought about running my car into it to stop. Instead, I reached for the gears and tried to shift to park. It went into reverse, and by some true miracle, I was able to miss all the sitting traffic and steer into a chain link fence. By yet another miracle, there was only one spot on the fence that was not tree lined. I backed between two trees into the fence and that stopped my car, which I left running as I got my two children out. A bystander was able to reach in and remove the keys and stop the car. The fence belonged to a catholic church which later sent a bill to my insurance company for the damage. This occurred in memphis, tn, and I have always been sure that the accelator was stuck in that incident. I was told to report it to the nthsa, but frankly, thou
NHTSA complaint #10305050
Apr 6, 2005vehicle speed controlCrash
While traveling 50 MPH suddenly the vehicle accelerated to 80 MPH, resulting in a crash and a roll over. The consumer was not injured in the collision. *ak *sc *jb
NHTSA complaint #10111771
Feb 22, 2005vehicle speed control
The vehicle accelerated while driving in the neighborhood. The brake was on, and the vehicle went to 40 MPH. Consumer was able to stop by shifting into park, applying the emergency brake, and turning the key off.*ak
NHTSA complaint #10112859
Jan 8, 2000service brakes, hydraulic, power train, vehicle speed controlCrash
Location-parking lot, raining, tires lost traction and accelerator stuck on full, brakes would not function. The vehicle propelled forward glancing off the back of a full sized pickup and deflected into a suburban where it finally stopped. No one was hurt but this situation could have been very serious if anyone had been near because I had very little control(steering only). *ak
NHTSA complaint #717089