CarProblemsDB

2004 Toyota Highlander exterior lighting problems

14 owners reported exterior lighting problems — 5% of all 286 complaints about the 2004 Toyota Highlander.

Exterior lighting complaints by Toyota Highlander year

202212
20218
20194
20185
20174
20169
201510
20142
20135
20122
20115
201012
20092
20083
20067
20059
200414
200315
200212
20012

What owners report

Jul 14, 2014electrical system, exterior lighting
I noticed that my original equipment/manufacturer passenger-side low-beam headlight lens had a burnt spot on the inside of the lens (clearly melted lens material). I checked the headlight bulb, which is a factory-installed kaito model hb3 low-beam bulb. The bulb was discolored black and smoky looking with an obvious bulge of melted glass in one side of the bulb. The… Read more

I noticed that my original equipment/manufacturer passenger-side low-beam headlight lens had a burnt spot on the inside of the lens (clearly melted lens material). I checked the headlight bulb, which is a factory-installed kaito model hb3 low-beam bulb. The bulb was discolored black and smoky looking with an obvious bulge of melted glass in one side of the bulb. The low-beam headlights still work, but the bulb seemingly has overheated, melting both the bulb glass and the inside of the lens assembly. *tr

NHTSA complaint #10610270
May 6, 2013exterior lightingFire

Tl* the contact owns a 2004 Toyota Highlander. The contact noticed condensation and moisture in both the driver and passenger side headlight lenses. In addition, the driver's side headlight lenses had melted and exhibited a bubble. The manufacturer was notified of the problem. The approximate failure mileage was 100,000. The VIN was unavailable.

NHTSA complaint #10510792
Oct 29, 2012exterior lighting, visibility/wiper
Late last year we noticed that the dayrunning portion of the headlamp cover had melted on the inside, next to the tip of the bulbs on each side. There is no way to turn the dayrunning feature on or off, it is always on. Not only does this wear down the battery, which we've already replaced in one year, but the headlight cover cannot handle the heat generated from constantly… Read more

Late last year we noticed that the dayrunning portion of the headlamp cover had melted on the inside, next to the tip of the bulbs on each side. There is no way to turn the dayrunning feature on or off, it is always on. Not only does this wear down the battery, which we've already replaced in one year, but the headlight cover cannot handle the heat generated from constantly being "on". We would like this issue resolved and a discount given on a new set, since it isn't our fault, as it couldn't be turned off. Headlights are expensive, and at night it is a safety issue, since our visibility is drastically reduced- where we live, there are deer and winding hilly roads. If Toyota won't do anything, we will be forced to do this expensive repair ourselves, but will be very, very disappointed. Toyota should stand behind their product, this is a design flaw and a huge safety issue. *tr

NHTSA complaint #10482596
Apr 19, 2011exterior lighting

Tl*the contact owns a 2004 Toyota Highlander. The contact stated when driving at low speeds the right rear brake lights do not illuminate when depressed. The failure was brought to his attention by another driver. The vehicle was not inspected by a dealer nor had it been repaired. The manufacturer was not contacted. The failure mileage was approximately 135,000.

NHTSA complaint #10396837
Apr 13, 2011exterior lighting
The lenses of the daytime running lamps/high beams have developed white, oval-shaped bubbling/melting marks of approximately 0.5 to 0.75 inches in diameter, in the center of the lenses, directly in front of the lamps. I first noticed this in december 2010 just prior to changing the original lamps (therefore the replacement lamps did not cause this problem). I reported this… Read more

The lenses of the daytime running lamps/high beams have developed white, oval-shaped bubbling/melting marks of approximately 0.5 to 0.75 inches in diameter, in the center of the lenses, directly in front of the lamps. I first noticed this in december 2010 just prior to changing the original lamps (therefore the replacement lamps did not cause this problem). I reported this to Toyota, case number 1012071480. Toyota told me to take this up with the service department of a dealer. At the dealership, I was initially quoted a price of $988 to replace the assemblies. After discussion with the service manager and his follow-up with Toyota, the price was lowered to $396 to pay only for labor, parts to be provided at no charge. I opted to not have this done for this price. Possible safety issues: 1) damaged/melting lenses could impact the effectiveness of the high beams and/or the daytime running lamps; 2) heat that is hot enough to damage/melt the lenses could be a fire hazard; 3) damaged/melting lenses could be an indication of an electrical problem. I have digital photos taken in december 2010 showing the damaged/melting lenses that I have provided to Toyota and would be pleased to provide to NHTSA. I have also retained the original lamps, and the car still has the damaged/melted lenses. *tr

NHTSA complaint #10395715
Nov 12, 2010exterior lighting
Recently discovered two white melted bumps in the exact center of the headlamp casing where the daytime running lamp beams pass through the plastic. Have only had the vehicle since july 2010 and the incident occured during a 19 hour drive, most of which took place during daylight hours. Headlights were not turned on until sunset. Concerned that factory lights are hot enough… Read more

Recently discovered two white melted bumps in the exact center of the headlamp casing where the daytime running lamp beams pass through the plastic. Have only had the vehicle since july 2010 and the incident occured during a 19 hour drive, most of which took place during daylight hours. Headlights were not turned on until sunset. Concerned that factory lights are hot enough to melt the plastic that is factory installed. Obvious defect, could cause fire. Impaired vision at night also a result as plastic is now permanently damaged. Also concerned that issue could worsen and hole could appear, causing rain and elements to come in direct contact with lighting system. Another obvious danger. Disengaging daytime lights is not an option, no control over overheating other to turn on headlights 100% of time. Also concerned with this solution, as defect could potentially be similar in these as well. Attempted to have dealer look at problem, however warrantly period has expired. After researching online, found several similar instances on models ranging from 2004-2007. Feel strongly that issue should be investigated as passenger saftey is at risk.

NHTSA complaint #10366129
Oct 5, 2010electrical system, exterior lighting
A 2004 Toyota Highlander signal light (safety item) is malfunctioning and when I took it to Toyota dealer (darcars), I was told I have to change the navigation system (luxury item) which currently is working. I have no idea why they had to integrate these two functions when one is a safety and the other one is luxury items. Besides, it costs $6000 + labor + tax to change the… Read more

A 2004 Toyota Highlander signal light (safety item) is malfunctioning and when I took it to Toyota dealer (darcars), I was told I have to change the navigation system (luxury item) which currently is working. I have no idea why they had to integrate these two functions when one is a safety and the other one is luxury items. Besides, it costs $6000 + labor + tax to change the navigation system. After intensive search on the internet I found out that Toyota knows about the problem except they only cover the problem under the 36,000mile/3 year warranty. If this was a mileage related problem, I can understand even if two none related functions are interlocked, but this has nothing to do with mileage and we cannot drive without a signal light but we can without a navigation system. This problem started a month ago and I have tried to get a response from Toyota and they are not giving me any response regarding this mater. *tr

NHTSA complaint #10359218
May 25, 2010exterior lightingFire

Tl* the contact owns a 2004 Toyota Highlander. The contact stated that the headlights would intermittently overheat and melt without warning. The dealer advised the failure was due to the bulb becoming extremely hot and melting the head light lens. The vehicle was not repaired. The failure mileage was 44,000 and the current mileage was 51,000.

NHTSA complaint #10332158
Nov 16, 2009electrical system, exterior lighting

Lens plate covers over fog lights are melting. This could result in a fire. *tr

NHTSA complaint #10292292
Oct 7, 2009exterior lighting

Tl* the contact owns a 2004 Toyota Highlander. The plastic on the headlights have peeled, subsequently causing the lights to appear very dim. The vehicle was taken to the dealer and the technician concluded that buffing would remedy the failure. The failure mileage was 40000. The current mileage was 51400, updated 10/19/09 *cn updated 10/19/09

NHTSA complaint #10286617
Apr 9, 2008exterior lighting
I have a 2004 Toyota highland and believe there is a design defect or manufacturing flaw with regard to the lens covers to the headlights and fog light covers. Both have significant melting from the light bulbs. I am concerned that the vehicle will catch on fire. All products involved are original Toyota parts. The lens covers each have a large (bigger than a quarter)… Read more

I have a 2004 Toyota highland and believe there is a design defect or manufacturing flaw with regard to the lens covers to the headlights and fog light covers. Both have significant melting from the light bulbs. I am concerned that the vehicle will catch on fire. All products involved are original Toyota parts. The lens covers each have a large (bigger than a quarter) circular spot where the melting took place from the inside out and there is a bubble on each. The same has happened with the fog lights and they are now cracked from the heat. I have contacted Toyota and they will not fix, replace, repair the lens covers and say that there is no recall. I would imagine that anything melting on a vehicle has the potential to catch fire. This has been progressively getting worse over several years so the incident date is not exact. It is evident that eventually there will be holes in these covers from the heat/melting as the daylights run constantly and cannot be turned off. *tr

NHTSA complaint #10223780
Mar 12, 2008exterior lighting

I was leaving my home going to work today and noticed that my wife's Toyota 2004 Highlander headlight lenses had started to melt where the day time running lamps are. *tr

NHTSA complaint #10220964
Dec 6, 2007exterior lighting

2004 Toyota Highlander headlamp material cover failure. Consumer states that the mechanic said he had never seen anything like that. Consumer stated the mechanic did not offer a corrective action. *kb the consumer stated the lens material had melted and a fog spot was present. When the lamp was removed from the vehicle, a bulge was on the side of the lamp in the up position. *jb

NHTSA complaint #10211695
← All 2004 Toyota Highlander problems & recalls