CarProblemsDB

2020 Tesla Model 3 exterior lighting problems

14 owners reported exterior lighting problems — 3% of all 456 complaints about the 2020 Tesla Model 3.

Exterior lighting complaints by Tesla Model 3 year

20257
202427
20231
20227
20218
202014
20196
201816

What owners report

Aug 1, 2026suspension, exterior lighting
Suspension is grinding. I had it replaced once at Tesla and it began grinding again in less than 18 months. I took it to Tesla and was informed the lower control arm failed and the price had more than doubled from the prior replacement. No warning lights have come on regarding this issue. The original replacement was 3/7/2024. I noticed the grinding between 12-18 months… Read more

Suspension is grinding. I had it replaced once at Tesla and it began grinding again in less than 18 months. I took it to Tesla and was informed the lower control arm failed and the price had more than doubled from the prior replacement. No warning lights have come on regarding this issue. The original replacement was 3/7/2024. I noticed the grinding between 12-18 months later. Also, the rear brake light gets condensation in it somehow. I had noticed this about 1 year ago.

NHTSA complaint #11754235
Jun 27, 2026electrical system, exterior lighting
The wiring in my trunk harness was severed due to the repeated opening and closing of my trunk. This caused my reverse lights to fail and my trunk latch to stop working. This issue is part of a known recall: campaign 21v-00d. Tesla attempted to fix the issue in 2023 but the poor repair did not work. I took my Tesla to the dealer and they refused to remedy the issue unless I… Read more

The wiring in my trunk harness was severed due to the repeated opening and closing of my trunk. This caused my reverse lights to fail and my trunk latch to stop working. This issue is part of a known recall: campaign 21v-00d. Tesla attempted to fix the issue in 2023 but the poor repair did not work. I took my Tesla to the dealer and they refused to remedy the issue unless I would pay $1300. I persuaded them to lower the feet to $300 but still feel that I should not pay anything because this issue was due to the recall.

NHTSA complaint #11746953
Apr 2, 2025exterior lighting

License plate light has a recall

NHTSA complaint #11652421
Oct 23, 2024exterior lighting

I am writing this claim to report a headlight assembly passenger side has failed at 22,000 miles in a Tesla model three 2020 year

NHTSA complaint #11621520
May 22, 2024exterior lighting
Subject: non-functional left rear tail light due to condensation build-up in Tesla vehicle dear NHTSA, I am writing to report an issue with my Tesla vehicle concerning the left rear tail light. The tail light has stopped functioning, and I believe this failure is due to condensation build-up within the light assembly. When I previously reported the condensation to Tesla, I… Read more

Subject: non-functional left rear tail light due to condensation build-up in Tesla vehicle dear NHTSA, I am writing to report an issue with my Tesla vehicle concerning the left rear tail light. The tail light has stopped functioning, and I believe this failure is due to condensation build-up within the light assembly. When I previously reported the condensation to Tesla, I was informed that it was normal and not a cause for concern. However, it now seems that this persistent condensation has LED to the failure of the tail light. This issue raises significant safety concerns, as fully functional tail lights are essential for safe driving. *especially during automated self-driving which disregards the alert of a nonfunctional tail light. * I am seeking your assistance in addressing this problem and ensuring that it is properly investigated. I am concerned that other Tesla owners might experience similar issues, which could compromise vehicle safety. Thank you for your attention to this matter. I look forward to your guidance on the next steps. Sincerely, [xxx] [xxx] VIN: [xxx] --- information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6)

NHTSA complaint #11590195
Feb 20, 2024exterior lighting
Fsd beta 11.4.9 - a concern documented in NHTSA complaint id 11555478 and subsequently remedied with later releases has returned in the current fsd beta build 2023.44.30.14. When engaging fsd ,the display screen enters an auto brightness mode and requires driver intervention to adjust brightness back to the driver's desired setting, as described by the following. When fsd is… Read more

Fsd beta 11.4.9 - a concern documented in NHTSA complaint id 11555478 and subsequently remedied with later releases has returned in the current fsd beta build 2023.44.30.14. When engaging fsd ,the display screen enters an auto brightness mode and requires driver intervention to adjust brightness back to the driver's desired setting, as described by the following. When fsd is engaged, display auto brightness is activated and the screen adjusts up in brightness from the previous setting, which is often too high. The driver's attention is then taken away from road and traffic ahead while the screen is reset to the driver's preferred setting. In the current build the following anomalies also occur. When fsd is engaged and the display is set to auto brightness, if the driver opens the display menu and adjusts brightness down, that driver setting is held even though the display brightness is still shown to be in auto mode. However, if after activating fsd and the auto brightness is engaged, and the brightness is then adjusted down using the left scroll wheel, the display remains in auto mode and the screen is automatically adjusted back up to the auto set point. This is true when the driver's preferred setting is lower than the auto set point, but not true if the driver's preferred setting is higher than the auto set point. When the initial driver setting is higher than the auto set point, the screen remains at the driver's preferred setting. While these anomalies are not safety co

NHTSA complaint #11572855
Nov 16, 2023exterior lighting, visibility/wiper
Fsd beta firmware version 2023.27.7. -- when operating with fsd beta in control of the vehicle, the turn signal is activated and the appropriate left or right side blind spot video is brought upon the driver's display automatically. This works perfectly for city street lane changes and turns at intersections or driveways, etc. When operating on a controlled access highway the… Read more

Fsd beta firmware version 2023.27.7. -- when operating with fsd beta in control of the vehicle, the turn signal is activated and the appropriate left or right side blind spot video is brought upon the driver's display automatically. This works perfectly for city street lane changes and turns at intersections or driveways, etc. When operating on a controlled access highway the systems works in the same manner, activating the turn signal and displaying the blind spot video on the driver's display when changing lanes and exiting the highway. However, the turn signal is not activated and the blind spot video is not displayed on the driver's instrumentation when first entering a controlled access highway. This is the one exception where the driver is required to activate the turn signal while fsd beta is in control, and seems like an oversight or 'bug'. However, it might be by design, in which case the intent that the driver is required to activate the signal indicating the vehicle's merge has not, to my knowledge, been communicated to the driver as the one exception to the otherwise automatic operation of the turn signal and blind spot video display while the vehicle is under fsd beta's control.

NHTSA complaint #11555494
Nov 16, 2023exterior lighting
Activating fsd beta version 2023.27.7 switches the display brightness to auto and to a brightness that is higher then the level set by the driver. In a darkened vehicle at night the auto setting was too bright and a distraction to safe driving at night. I then spent 2-3 seconds with my attention away from the road ahead as I reset the brightness on the display screen to the… Read more

Activating fsd beta version 2023.27.7 switches the display brightness to auto and to a brightness that is higher then the level set by the driver. In a darkened vehicle at night the auto setting was too bright and a distraction to safe driving at night. I then spent 2-3 seconds with my attention away from the road ahead as I reset the brightness on the display screen to the comfortable level. After disengaging fsd beta the display remains at the brightness level set buy the driver. The next time fsd beta is activated the display brightness is once again set to auto and the distracting process of taking the display out of auto and adjusting the brightness to a level comfortable to the driver must be repeated. Activating fsd beta puts the high beams into auto and allows the system to use the high beams when the vision system requires it. This is excellent and works well. The display brightness is a driver preference and adjusting the display brightness is not needed for the vision system to operate effectively and should remain set at the driver's preferred setting so as to no be too bright and so the driver does not need to repeatedly adjust the brightness each time fsd beta is activated.

NHTSA complaint #11555478
← All 2020 Tesla Model 3 problems & recalls