CarProblemsDB

2000 Mitsubishi Eclipse transmission problems

17 owners reported transmission & powertrain problems — 6% of all 308 complaints about the 2000 Mitsubishi Eclipse.

Transmission & powertrain complaints by Mitsubishi Eclipse year

20091
20082
20072
20066
200320
20024
200118
200017

What owners report

Jun 2, 2016steering, suspension, power train

Needs recall fixed.

NHTSA complaint #10872248
Dec 27, 2006power train

Tl* - the contact stated that she experienced many different unusual incidents with the 2000 Mitsubishi Eclipse, beginning with ignition. Also states that when she drives 35 - 40 MPH the vehicle does not shift into gear consistently. The weather does not seem to be a factor. The contact reports that the most recent transmission hesitancy failure was on 12/27/06.

NHTSA complaint #10177139
Jul 30, 2004power train, equipment

When depressing the clutch while in motion the gear would not shift properly or not at all into first/second or third gear. This almost caused a vehicle crash. They informed consumer that the vehicle was not covered under a recall. *ak the clutch problem was a daily intermittent problem. The A/C had gone out as well. *sc *jb

NHTSA complaint #10079892
Jun 14, 2004power train

I have a 2000 Mitsubishi Eclipse that has 34000 miles on it, and about a month after I bought it the 2nd gear in the transmisswion kept grinding when shifting and I found out that a lot of other owners are having the same problem so I was wondering if there is a possibility of a recall for the parts involved.*ak

NHTSA complaint #10075335
Mar 25, 2004power train, wheels
The design of the manual transmission, the transmission synchros and the clutch mechanism has been faulty which causes the following parts to fail a lot earlier than any normal vehicle. - the clutch plate gets worn before time - the throw out bearing (tob) has a rattle - the clutch has a rattle - there is very hard gear shift into the 1st and 2nd gear. The 2nd gear is… Read more

The design of the manual transmission, the transmission synchros and the clutch mechanism has been faulty which causes the following parts to fail a lot earlier than any normal vehicle. - the clutch plate gets worn before time - the throw out bearing (tob) has a rattle - the clutch has a rattle - there is very hard gear shift into the 1st and 2nd gear. The 2nd gear is very hard, especially when its cold start.(that is not particularly cold at the end of the month of march in houston, texas) - it is also due to the "poor" synchronizers in the transmission box - this has been reported by a lot of Mitsubishi Eclipse gt v6 users for the 3rd generation I.e. 2000+ Mitsubishi Eclipse cars with a manual shift - this is due to substandard transmission and clutch quality from Mitsubishi

NHTSA complaint #10063875
May 23, 2003power train
Both rear hub & bearing assemblys were causing vibrations in the car. Car is 3 years old and the mechanic claimed he never had to replace both rear hub assemblys on such a new vehicle. The assembly left no room to lubricate the bearings which caused them to keep in moisture and rust prematurely. Mechanic said the parts were filled with rust fragments to the point he was… Read more

Both rear hub & bearing assemblys were causing vibrations in the car. Car is 3 years old and the mechanic claimed he never had to replace both rear hub assemblys on such a new vehicle. The assembly left no room to lubricate the bearings which caused them to keep in moisture and rust prematurely. Mechanic said the parts were filled with rust fragments to the point he was surprised the tires stayed attached to the axle. Mitsubishi parts supplier said this wasn't a common problem with that model year but said there was a lot of replacement parts being sold.

NHTSA complaint #10019175
May 13, 2003power train, wheels
The rims on my 2000 Mitsubishi Eclipse have become dented under what would be considered less than normal wear and tear. I have taken exceptional care to protect this car from damage. As an example, after three years of ownership, there is still not a single door dent or chip, due to the fact that I exercise the extra effort to park far away from other vehicles and walk the… Read more

The rims on my 2000 Mitsubishi Eclipse have become dented under what would be considered less than normal wear and tear. I have taken exceptional care to protect this car from damage. As an example, after three years of ownership, there is still not a single door dent or chip, due to the fact that I exercise the extra effort to park far away from other vehicles and walk the extra distance to my destination. Therefore it's reasonable to assume that I would also steer clear of potholes, etc., and I have the paper work to prove that I have maintained my car according to standards set by Mitsubishi. Yet despite this level of care, the rims have become damaged. Ironically, as this is my first new car, I take better care of it than any car I have ever owned, and yet it is the first car I have had this issue with. When I brought it to the dealership, the factory rep said it was because the air pressure must have been low and I hit a pothole. But yet he won't tell me how he came to that determination. At the same time I brought the car I for the rims, I had brought the car in for the clutch noise issue, and nowhere on the repair order is it mentioned that I requested to have the rims replaced and that my request was denied. Nor can I get it from Mitsubishi in writing. Also, it is my understanding from the dealership that the tires were never removed from my car during the "inspection", so I question its sincerity. I have left two messages with the factory rep to explain to

NHTSA complaint #10018655
Jun 4, 2002power train

I started noticing a rattle from the clutch/transaxle. It occurs after the vehicle has been driven for at least 30 minutes. The rattle stops when the clutch is pushed in. *ak

NHTSA complaint #762614
May 8, 2002power train

No summary listed for above vehicle. *ak

NHTSA complaint #761693
← All 2000 Mitsubishi Eclipse problems & recalls