CarProblemsDB

2004 Mercedes-Benz E-Class transmission problems

15 owners reported transmission & powertrain problems — 3% of all 472 complaints about the 2004 Mercedes-Benz E-Class.

Transmission & powertrain complaints by Mercedes-Benz E-Class year

20161
20141
20131
20114
20102
20084
20076
20062
200517
200415
200325
20023

What owners report

Jun 14, 2019power train
The problem with my vehicle is that with its current TCM( transmission control module) in a 722.9 transmission, the conductor plate that holds the sensors in place become defective and creates a problem in which the transmission gets stuck in 2nd gear. This causes a major problem driving on road ways that are +45mph because the vehicle cannot drive over 25mph further causing… Read more

The problem with my vehicle is that with its current TCM( transmission control module) in a 722.9 transmission, the conductor plate that holds the sensors in place become defective and creates a problem in which the transmission gets stuck in 2nd gear. This causes a major problem driving on road ways that are +45mph because the vehicle cannot drive over 25mph further causing more problems that may actually freeze up the engine causing the car to stop. If the car is stopped and begins to go again, the rmp's can go very high without any power or motion in the vehicle. This has happened to 2 of my personal friends already with the 722.9 transmission. In particular the conductor plate or valve body was corrupted and caused the vehicle to fail. I am reporting this because the part can fail anytime during operation of the vehicle and is a safety issue to the driver and others around when this may occur. Many other owners (I've read online) with this 722.9 transmission conductor plate fault is also frustrated by the fact that not only Mercedes-Benz doesn't allow for a consumer to buy the part but many warranties are voided with this fault. My vehicle (Mercedes-Benz e500 2004) also is only at 56,000 miles on the speedometer. Considering the mileage, this is a problem that seems to be premature due to the fact that the vehicle has been serviced by a Mercedes-Benz dealer but has no service for the very commonly faulted part.

NHTSA complaint #11220227
May 25, 2018power train
The shifter module is defective because after starting the engine, when in drive, it stays in 2nd gear only. To put the car in reverse, I must shut the engine. Otherwise I can't shift from d to n to r. The shifter will not move past neutral. To get to p or r, I must shut the engine. This is unsafe when trying to back into a city street parking. When the car is stationary,… Read more

The shifter module is defective because after starting the engine, when in drive, it stays in 2nd gear only. To put the car in reverse, I must shut the engine. Otherwise I can't shift from d to n to r. The shifter will not move past neutral. To get to p or r, I must shut the engine. This is unsafe when trying to back into a city street parking. When the car is stationary, after starting it, once I shift from p to r & arrive at n, the shifter will not allow me to shift back into r without shutting the engine & then restarting it.

NHTSA complaint #11098019
Feb 22, 2016power train, electrical system, service brakes
Tl* the contact owns a 2004 mercedes benz e500. The contact stated that while driving at approximate 60 MPH, the vehicle stalled but continued to roll without stopping, the brake pedal failed, and the gear shifter failed to come out of park. In addition, all the instrument panel warning lights illuminated. The vehicle was not diagnosed or repaired. The manufacturer was not… Read more

Tl* the contact owns a 2004 mercedes benz e500. The contact stated that while driving at approximate 60 MPH, the vehicle stalled but continued to roll without stopping, the brake pedal failed, and the gear shifter failed to come out of park. In addition, all the instrument panel warning lights illuminated. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 86,000.

NHTSA complaint #10837458
Jan 19, 2015power train, electrical system, engine
Benz e500 2004 (54k miles) safety issue1: nov 2008(36k miles), the car used to lose power and shut down while driving with all the lights blinking on the dash board. But I was able to break ansdstop . Sometimes it started back on and sometimes it did not.dealer replaced the crankshaft sensor and the sender unit. Had to pay the bill of $600 plus towing. They did not inspect… Read more

Benz e500 2004 (54k miles) safety issue1: nov 2008(36k miles), the car used to lose power and shut down while driving with all the lights blinking on the dash board. But I was able to break ansdstop . Sometimes it started back on and sometimes it did not.dealer replaced the crankshaft sensor and the sender unit. Had to pay the bill of $600 plus towing. They did not inspect other safety issues like the sbc pump or let me know about the 10 year warranty. Neither did they tell me if sbc pump failure or its malfunction has any impact on other parts of the car. Safety issue 2: jan 6th 2015.(refer to complaint #10676289)sbc pump failed during a long road trip and thinking it was just brake pads, could have been fatal. Dealer/mb refused any assistance in repairs. Cost us $2200. When the dealer refused to look at the sbc pump before the warranty expired and they know it is going to fail, customer is in a very uncomfortable position with safety aspect, huge repair costs involved and possible impact on other parts and situations. They designed a warranty on this programmable unit that is programmed to lend certain cycles or service. Mercedes benz has turned this major defect into a money making opportunity lately. They are installing reman units with a high repair cost of $2000-3000. Sometimes, more than the worth of the car. Regulators should revisit the case and have them provide life time warranty on this major flaw and maybe more. When there were two recalls just a year after it w

NHTSA complaint #10676537
← All 2004 Mercedes-Benz E-Class problems & recalls