Nov 2, 2005seat belts
Dt: the contact stated the latch system was defective. He took the car to a certified inspection station in his city on 11-02-05 to have the safety seat inspected and turned to face forward. They told him they would not turn the safety seat because the latch system in the vehicle would not work properly with a forward facing child seat. The clip between the seats was facing… Read more
Dt: the contact stated the latch system was defective. He took the car to a certified inspection station in his city on 11-02-05 to have the safety seat inspected and turned to face forward. They told him they would not turn the safety seat because the latch system in the vehicle would not work properly with a forward facing child seat. The clip between the seats was facing forward, instead of vertical, causing the seat belt to get twisted and bunched up. This caused the safety seat to lurch forward when installed in a forward facing position. The latch system will allow proper installation of a rear facing infant seat.*ak 11/15/05. *jb
NHTSA complaint #10141577
Feb 24, 2004seat belts
Foia request a full copy of NHTSA bulletin 0800102, NHTSA item 634469 re seat belt comfort in a 2000 Mazda MPV. (nar) *la *cb *jb
NHTSA complaint #10059701
Feb 20, 2004seat belts
Foia request a full copy of the contents of odi investigation complaint# 875637, re seat belts, front buckle assembly. (nar) *la *cb *jb
NHTSA complaint #10059688
Nov 5, 2003parking brake, power train, seat belts, structure
Consumer states while vehicle was parked with the emergency parking brake on, the vehicle started to move forward. *ak the gear shift would stick in park or move by itself, the right rear door would open while the vehicle was in motion and failed to close properly, and one of the seat belts was installed backwards. *scc *jb
NHTSA complaint #10034468
Jul 18, 2003seat belts
The rear seat belt became so tight, it had to be cut in order for the passenger to get out. *jb *ts. The consumer stated it was the second occurrence. *jb
NHTSA complaint #10020224
Jan 22, 2003seat belts
Consumer stated that when putting on the rear seat belt it would not be tight enough for it to fit the consumer properly. Dealer will be notified. Ts
NHTSA complaint #10004402
Nov 23, 2001seat belts
Front passenger's side seatbelt tightens with minimal movement, retracts, locks up and will not release. Passenger must unbuckle seat belt due to extreme discomfort.*ak
NHTSA complaint #754824
Apr 27, 2001seat belts
Passenger's seat belt locks up and becomes extremely tight when vehicle is being driven or when passenger slightly moves. *ak the dealer confirmed that the seat belt was defective and replaced it, but the problem reoccured. *yh
NHTSA complaint #886928
Nov 28, 2000seat beltsCrash2 injured
Car safety seat was strapped in middle row on passenger's side seat. When vehicle was involved in a passenger side collision it caused vehicle to roll, and seat belt, that held car safety seat, unbuckled while vehicle was rolling over.*ak the two year toddler was injured during the accident. *yh
NHTSA complaint #875637
May 10, 2000seat belts
Seat belts lock up when vehicle is moving, they do not release. I believe design defect in that belts are too short. Middle seat moves from left to right. When in the left position, it locks up immediately. Manufacturer says operating normally.
NHTSA complaint #722508
Feb 24, 2000seat belts
The fixed seat belt anchors prevent safe installation of child and infant car seats. The point where the buckle engages the anchor is too far away from the car seat to properly secure the child seat. The child seat has too much freedom of movement after the seat belt is buckled and tightened.
NHTSA complaint #719168
Feb 17, 2000seat belts, child seat
Since we purchased the vehicle, we have had a problems keeping our 2-year old's car seat secured properly. The seatbelts in the middle seats and rear seat will not tighten and/or loosen after buckling, causing the car seat to shift and move easily. I felt we must be doing something wrong and finally had an opportunity to return it to the dealer. After over and hour and… Read more
Since we purchased the vehicle, we have had a problems keeping our 2-year old's car seat secured properly. The seatbelts in the middle seats and rear seat will not tighten and/or loosen after buckling, causing the car seat to shift and move easily. I felt we must be doing something wrong and finally had an opportunity to return it to the dealer. After over and hour and throught the efforts of a service advisor and a lead service technician, it was determined there must be some sort of design flaw in the seatbelt which prevented the belts from locking properly. They also did not feel that installing a tether would remedy the problem to an appropriate degree of safety. They also called Mazda headquarters who informed them that yes, there is a design flaw in the seatbelts but they don't have a resolution at this time and they don't know when they will. The service advisors only recommendation to me is that I find another car seat that might work with these seats. Unfortunately, there are none. Thus, each time my family and I ride in the car, my 2-year old's life is at stake since we cannot safely install a car seat within this vehicle. Please provide me any information you can on seeking remedy to this problem. We will anxiously await your response. *ak
NHTSA complaint #718907
Feb 6, 2000seat belts
This is of utmost concern for the safety of children in car-seats or booster seats. The seat belt anchors for the 2nd and 3rd row seats are of solid, inflexible construction. This inflexible construction combined with the placement of the anchors does not allow the safe installation of most infant car seats and toddler booster seats. Out of seven infant and booster seats… Read more
This is of utmost concern for the safety of children in car-seats or booster seats. The seat belt anchors for the 2nd and 3rd row seats are of solid, inflexible construction. This inflexible construction combined with the placement of the anchors does not allow the safe installation of most infant car seats and toddler booster seats. Out of seven infant and booster seats tried, only one has been able to be installed somewhat correctly. The placement and inflexibility of the anchors requires that the lap portion of the seatbelt be located approximately 7 inches away from the intersection of the seat face and back. This acutally pulls a typical car seat away from the seat back and does not work safely. *ak
NHTSA complaint #718394