My daughter and I were on the way to o'reilly when we turned at a short curve going under 20 miles and the steering wheel got loose and the brakes wouldn't stop us. The car just kept swerving all over the road and we ended up in a ditch the day after my husband purchased the car.
2007 Mazda Mazda3 brakes problems
17 owners reported brakes problems — 8% of all 222 complaints about the 2007 Mazda Mazda3.
Brakes complaints by Mazda Mazda3 year
What owners report
After a hard brake event to avoid a crash, brake pedal is soft and loses pressure. Identical to many, many ford and mitsubishi reports on models that use the same ABS equipment. ABS valves probably leaking internally. Dealer refuses to remedy and insists brakes are fine - they are not, significantly worse since hard brake incident. Oem ABS part no longer available (I wonder… Read more
After a hard brake event to avoid a crash, brake pedal is soft and loses pressure. Identical to many, many ford and mitsubishi reports on models that use the same ABS equipment. ABS valves probably leaking internally. Dealer refuses to remedy and insists brakes are fine - they are not, significantly worse since hard brake incident. Oem ABS part no longer available (I wonder why?) so the only repair option is a used part that is probably also defective in manufacture.
The car idles very high which prevents it from shifting into gear most of the time. The idle and rpms will also accelerate when no one is touching the gas while driving making the car speed up when you are not speeding up. When these issues are happening the car also shuts off while driving it (while it is still on and being driven down the road) or sometimes will rev up when… Read more
The car idles very high which prevents it from shifting into gear most of the time. The idle and rpms will also accelerate when no one is touching the gas while driving making the car speed up when you are not speeding up. When these issues are happening the car also shuts off while driving it (while it is still on and being driven down the road) or sometimes will rev up when you push on the break causing it to launch forward. My car has almost caused several accidents because it died while driving it on the freeway and the starring wheel locked and could not be turned to drive me off to the side of the road. It has also launched forward while braking causing me to almost hit cars in front of me.
I believe this issue may be the same as investigation pe 16-017. That mentions only ford/mercury cars, but I think they share some components with Mazda3's of the same years. After an incident where ABS engaged while braking on a slippery city street, the brake pedal became very "mushy" and now the brakes take a worryingly large amount of travel (almost to the floor) to slow the car in regular driving.
While driving, I slowed down and when turning, my wheel locked up and I had no control over my turn. My ABS light flashed, along with the traction light. The radio turned off and then came back on. The wheel unlocked and luckily I was not turning where someone was stopped.
Tl* the contact owns a 2007 Mazda 3. The contact stated that the vehicle failed to start when the fuel tank was filled. The dealer performed a diagnostic, which located a failure code at the purge valve. The valve was replaced, but the vehicle experienced additional failures. The front end vibrated and the engine stalled while driving 65 MPH. The dealer performed diagnostic… Read more
Tl* the contact owns a 2007 Mazda 3. The contact stated that the vehicle failed to start when the fuel tank was filled. The dealer performed a diagnostic, which located a failure code at the purge valve. The valve was replaced, but the vehicle experienced additional failures. The front end vibrated and the engine stalled while driving 65 MPH. The dealer performed diagnostic testing, which indicated that the engine mount was worn, the struts leaked, and the EVAP system failed. However, the valves were replaced. The engine mount, struts, and evaporating system were not replaced. The rotor also wore prematurely and could not be resurfaced. The front bumper clips failed due to defective plastic. The clips were replaced several times; however, the failure was not corrected. The manufacturer stated that the vehicle was not included in NHTSA campaign number: 07v295000 (engine and engine cooling). The failure mileage was 50,000.
A few months after we bought our Mazda 3 we noticed the bulbs blew out well come to find out our lenses were melting and it got so hot the socket and bulb burst so we took it to the place we bought it and they warrantied them out well guess what the tail lenses we got replaced melted again and blew out the bulbs. We took our car to Mazda and the technicians found nothing… Read more
A few months after we bought our Mazda 3 we noticed the bulbs blew out well come to find out our lenses were melting and it got so hot the socket and bulb burst so we took it to the place we bought it and they warrantied them out well guess what the tail lenses we got replaced melted again and blew out the bulbs. We took our car to Mazda and the technicians found nothing wrong, no ground problem. Well we took it back to the place we bought it thinking they'd be able to warranty them out since they're less than a year well the lady wouldn't do it. Now I am stuck with my spoiler brake light and the passenger. So we decided to replace the brake switch and so far our passenger side hasn't blown out. I suggest replacing it and seeing what happens. It is a $30 part. Tonight I am buying new lenses and praying. I went through 4 bulbs in the driver and 3 bulbs in passenger. I need help figuring this out because $8 for a pack of bulbs every week is ridiculous. *tr
The ABS system is broken. *tr
The brake light housing (amber lens) was heated by the bulb to such a degree that the lens itself melted onto the bulb. We are not entirely sure when this happened and may have been ongoing for quite some time. Upon inspection by an experienced automotive technician, it was confirmed that the bulbs were the correct model and had been installed correctly. Some of the plastic… Read more
The brake light housing (amber lens) was heated by the bulb to such a degree that the lens itself melted onto the bulb. We are not entirely sure when this happened and may have been ongoing for quite some time. Upon inspection by an experienced automotive technician, it was confirmed that the bulbs were the correct model and had been installed correctly. Some of the plastic had melted down onto the bulb itself and could potentially become a fire hazard. This problem impacted both driver and passenger sides, with the driver side appearing more significantly melted. After a quick search on Mazda forums, this appears to be an issue experienced by many owners of 2007 Mazda 3 models, but only those in the hatchback configuration. *tr
In march 2008, my vehicle had warning lights turn on for both the seat belt and ABS system. The dealer cleared the code and checked the system for errors. No codes re-occurred and the car was returned to me. Subsequently in december 2008, the airbag light came on again. The dealer adjusted some wiring and cleared the light/code. Now in september 2011, the airbag light is on again. *tr
Emergency/parking brake failure I parked my car in the driveway at my mother's house at the top of the driveway, which is relatively flat and only a very slight incline. There is a portion of driveway between the sidewalk and the house level which is steeper; however my car was parked above that area and on the flat portion. The car is a manual transmission and I had set the… Read more
Emergency/parking brake failure I parked my car in the driveway at my mother's house at the top of the driveway, which is relatively flat and only a very slight incline. There is a portion of driveway between the sidewalk and the house level which is steeper; however my car was parked above that area and on the flat portion. The car is a manual transmission and I had set the car to neutral with the emergency parking brake on. About 20 minutes after the car had been parked, it rolled backwards- down the driveway, out into the street and hitting 2-3 trash cans, and ended up jumping the curb on the opposite side of the street. The rear left tire was up on the curb and the Mazda 3 collided with the rear right corner of another parked vehicle. I witnessed the incident from inside the house and there were several other witnesses. When we looked at the Mazda 3 after it had come to a stop on the opposite curb, we saw from the outside that the emergency brake was indeed engaged. Background information on vehicle use: I always fully engage the brakes before parking and setting the emergency brake. When parking on any obviously sloped surface, I always put the car into gear (into 1st when sloped upwards, and into reverse when sloped downwards) and set the emergency brake, as well as turn the wheels toward the curb when parallel-parked. I have kept up with normal scheduled maintenance and have read through the owner's manual which does not mention anything about when to inspect the e
Tl*the contact owns a 2007 Mazda 3. While the contact was driving approximately 45 MPH the steering wheel began to shake. The vehicle was taken to the dealer on two separate occasions for the identical failure. The failure was contributed to warped brake rotors which were resurfaced twice at the dealers expense. The vehicle was taken to the dealer on a third occasion where the… Read more
Tl*the contact owns a 2007 Mazda 3. While the contact was driving approximately 45 MPH the steering wheel began to shake. The vehicle was taken to the dealer on two separate occasions for the identical failure. The failure was contributed to warped brake rotors which were resurfaced twice at the dealers expense. The vehicle was taken to the dealer on a third occasion where the technician stated the brake rotors required replacement and could not be resurfaced. The manufacturer was notified and they advised that there was not a recall defect related to the problem and the defect was not under the service warranty. The failure mileage was 10,000. The current mileage was 30,000.
Mazda 3 brakes and rotors were replaced at 18,000. Mechanic says the pads were worn thin and the rotors warped. He had never seen any thing link this for a new low mileage car. Replaced them on the spot out of fear for safety. Mazda needs to own up to warped rotor issue and not blame it on driving and braking. Isn't a car suppose to drive and brake when necessary? Any… Read more
Mazda 3 brakes and rotors were replaced at 18,000. Mechanic says the pads were worn thin and the rotors warped. He had never seen any thing link this for a new low mileage car. Replaced them on the spot out of fear for safety. Mazda needs to own up to warped rotor issue and not blame it on driving and braking. Isn't a car suppose to drive and brake when necessary? Any comment from Mazda on recall would help me feel better about buying this model. *tr
1. Normal everyday driving, current mileage just under 16,700. 2. Occurs when driving the car above 40 MPH and then applying the brakes, the car shimmys hard (steering wheel shakes and so does braking foot as it is applying brakes) 3. Took the car to the dealer service center for diagnosis and repair. The dealer would not repair under warranty as the car has more than… Read more
1. Normal everyday driving, current mileage just under 16,700. 2. Occurs when driving the car above 40 MPH and then applying the brakes, the car shimmys hard (steering wheel shakes and so does braking foot as it is applying brakes) 3. Took the car to the dealer service center for diagnosis and repair. The dealer would not repair under warranty as the car has more than 12,000 miles. Dealer indicated that the front rotors are warped and need to be repaired for $189. After much research on the internet, I have discovered that this is a very common problem with the Mazda with many rotors warping well under the 12,000 mile threshold on the warranty. I have owned many cars and this is the only car that I have ever experienced "warped rotors". *tr
2007 Mazda 3 parked on a moderate grade in second gear and with parking brake engaged. After 10-15 minutes car rolled backwards and hit 2 other cars. Mazda was still in gear with brake engaged. *ak
I have sustained a painful ergonomic injury to my right achilles tendon from the poor design of the accelerator/brake area and the limited seat adjustment in this car (2007 Mazda speed 3). I have to ice my ankle every night. When driving it is painful and can become numb, reducing my ability to do emergency braking. I am concerned that this will lead to an accident. The… Read more
I have sustained a painful ergonomic injury to my right achilles tendon from the poor design of the accelerator/brake area and the limited seat adjustment in this car (2007 Mazda speed 3). I have to ice my ankle every night. When driving it is painful and can become numb, reducing my ability to do emergency braking. I am concerned that this will lead to an accident. The issue started in early january with less than 100 miles on the car - now I have 1300 on the car and experience this every day I drive the vehicle. *nm