38 owners reported equipment problems — 2% of all 1,807 complaints about the 2002 Jeep Liberty.
Equipment complaints by Jeep Liberty year
20083
200710
200630
200511
200410
200320
200238
What owners report
Jul 10, 2017equipment
My 2002 Jeep Liberty, rarely driven past 3 years, has had to have the ignition switch replaced 3 times as of this week. I can not understand why your department enforced to replace so many Jeep ignition switch's to not think they did not have inferior products on the Liberty's as well. The keys slide right out of the ignition rather the vehicle is in drive motion or parked, on… Read more
My 2002 Jeep Liberty, rarely driven past 3 years, has had to have the ignition switch replaced 3 times as of this week. I can not understand why your department enforced to replace so many Jeep ignition switch's to not think they did not have inferior products on the Liberty's as well. The keys slide right out of the ignition rather the vehicle is in drive motion or parked, on or off, doesn't matter and there are complaints all over the web as to same issue. I understand the issue needs to be reported to you to make official, however, chrysler's lack of cooperativeness alone, I would think enough to be due cause to umbrella jeeps of all models and get them all enforced around the same time frame.
NHTSA complaint #11004138
Aug 25, 2011air bags, tires, equipmentCrash2 injured
Air bags didnt work ,rear tire driver side blew question steering? *tr
NHTSA complaint #10421420
Aug 29, 2007steering, suspension, equipmentCrash
In november of 2006, I had a recall fixed for the "front:control arm:lower ball joint" when the parts became available. I brought the car back 3 days later having issues with the steering and hearing a noise. The dealership took the car for a few days and did a complete inspection and assured me the new parts were sufficient. Every now and then (not constant, but scarcely)… Read more
In november of 2006, I had a recall fixed for the "front:control arm:lower ball joint" when the parts became available. I brought the car back 3 days later having issues with the steering and hearing a noise. The dealership took the car for a few days and did a complete inspection and assured me the new parts were sufficient. Every now and then (not constant, but scarcely) when I would turn the wheel just a little, the car would turn as if I had turned my wheel all the way. It scared me a few times, but it didn't happen often at all, so I didn't think much of it. On may 31, 2007, I was merging onto I-91 in connecticut driving only 22 miles per hour, and my car did that very thing. I went up and over the curb, up the embankment and crashed into a steel connecticut state sign. If it wasn't for the sign, I would have continued to lose control and possibly been killed. Hitting the sign swung my back end around, where I rolled down the embankment and to a complete stop on the side of the highway. My car sustained over $7,000 worth of damage and has damaged my perfect driving record. No other car was involved and no one was hurt, including myself. I was very fortunate, but I feel there needs to be further investigation into the previous recall and possibly a new recall should be posted to eliminate this problem. The problem still exists despite the recall from last year. *jb
NHTSA complaint #10201141
Dec 10, 2004suspension, equipment3 injured
1. Repeated returns to the dealer to correct a noise in the suspension. . While driving the ball joint separated causing the fron wheel to fall off and vehicle to crash to the ground and skid to a stop.*ak 3. Vehicle has not been repaired. Damier chrysler and it's dealership will not accept responsibilty for failure and as of current date is sitting at dealership lot awaiting outcome of lawsuit.