The dash pad is coming unglued causing a glare in the windshied.
2012 Jeep Grand Cherokee body problems
26 owners reported body & structure problems — 2% of all 1,645 complaints about the 2012 Jeep Grand Cherokee.
Body & structure complaints by Jeep Grand Cherokee year
What owners report
The contact owns a 2012 Jeep Grand Cherokee. The contact stated that the dashboard was wrinkled. The contact stated that while driving at an undisclosed speed and making a turn, the check engine warning light illuminated. The vehicle was taken to the local dealer, where it was determined that the dashboard needed to be replaced. The vehicle was not repaired. The manufacturer… Read more
The contact owns a 2012 Jeep Grand Cherokee. The contact stated that the dashboard was wrinkled. The contact stated that while driving at an undisclosed speed and making a turn, the check engine warning light illuminated. The vehicle was taken to the local dealer, where it was determined that the dashboard needed to be replaced. The vehicle was not repaired. The manufacturer was contacted. The approximate failure mileage was 68,000.
Paint above windshield has deteriorated and has rust bubbles. Paint first looked almost burnt then turned white/grey in color. The sun roof stopped working shortly after. Spot has increasingly become bigger and bigger. It has doubled in size in less than 3 months. I have had nothing but issues with this vehicle.
The contact owns a 2012 Jeep Grand Cherokee. The contact stated while driving approximately 5 MPH and when depressing the brake pedal, the contact heard a crack underneath the vehicle. The vehicle was towed to an independent mechanic and diagnosed with needing the sub frame bolts replaced. The vehicle was not repaired. The vehicle was then towed to a local dealer where it was… Read more
The contact owns a 2012 Jeep Grand Cherokee. The contact stated while driving approximately 5 MPH and when depressing the brake pedal, the contact heard a crack underneath the vehicle. The vehicle was towed to an independent mechanic and diagnosed with needing the sub frame bolts replaced. The vehicle was not repaired. The vehicle was then towed to a local dealer where it was not repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 200,000.
Car was travelling on a rural road and driver fell asleep at the wheel. Hit an electrical power pole approximately 12 inches inside the drivers side head lamp at speeds approximately at 40 -45 MPH. Car then proceeded to travel another approximate 25-30 yards before turning 90 degrees and crashing the rear of the car into the corner of a block building. The driver was unhurt… Read more
Car was travelling on a rural road and driver fell asleep at the wheel. Hit an electrical power pole approximately 12 inches inside the drivers side head lamp at speeds approximately at 40 -45 MPH. Car then proceeded to travel another approximate 25-30 yards before turning 90 degrees and crashing the rear of the car into the corner of a block building. The driver was unhurt however the air bags failed to deploy to protect the driver.
I had the car for 3 years and didn't have any issues. Last saturday evening 4/14/17 we had just gotten home from running to the store and black smoke started to come up from the front right side of the hood. I backed the car out of the garage and went around the car to see what the issue was. Saw sparks, grabbed my son from the back ran and called 911. With in 5 min the front… Read more
I had the car for 3 years and didn't have any issues. Last saturday evening 4/14/17 we had just gotten home from running to the store and black smoke started to come up from the front right side of the hood. I backed the car out of the garage and went around the car to see what the issue was. Saw sparks, grabbed my son from the back ran and called 911. With in 5 min the front of the Jeep was on fire. Took 30 min to put out and the car is totalled.
On june 24, 2016, between 1:30 pm and 2 pm, I was driving from brentwood ca to vallejo ca on hwy 780 w and after turning a curve on the freeway which sloped down towards curtola parkway, I applied the brakes at about 30 miles per hour after I emerged from the overpass which was at least 5 car lengths before the cars ahead of me which was stopped at a red traffic light. … Read more
On june 24, 2016, between 1:30 pm and 2 pm, I was driving from brentwood ca to vallejo ca on hwy 780 w and after turning a curve on the freeway which sloped down towards curtola parkway, I applied the brakes at about 30 miles per hour after I emerged from the overpass which was at least 5 car lengths before the cars ahead of me which was stopped at a red traffic light. However, the Jeep continued to roll even though I pressed on the brakes to the floor board. When I realized the Jeep did not stop, after checking for vehicles on the left from the rear view mirror, I swerved to the left to avoid hitting the truck in front of me, but I still hit the left corner of the nissan truck in front of me but the truck did not hit the vehicle in front of him. I damaged the right corner of the front of my Jeep. The Jeep is unsafe because the brakes failed and would have caused a fatal accident to me, my three passengers, and other vehicles had I been travelling at a high speed. I complied with all available recall repairs including the brake recall in 2014 and all the suggested chrysler maintenance on the Jeep. I reported the accident to my insurance geico and to chrysler.
Failure of automatic rear tailgate and associated obstruction/safety sensor mechanisms. Tailgate opens to within an inch or two of full height then silently starts to fall back at an increasing velocity and slams shut. Pressing the control button to stop the fall does not work nor does the rapid drop stop when encountering an obstruction. When tailgate first started to reverse… Read more
Failure of automatic rear tailgate and associated obstruction/safety sensor mechanisms. Tailgate opens to within an inch or two of full height then silently starts to fall back at an increasing velocity and slams shut. Pressing the control button to stop the fall does not work nor does the rapid drop stop when encountering an obstruction. When tailgate first started to reverse direction I reached in to press the button to stop or reverse it and it continued downward and pinned my arm and caused me to wrench my back. Had anyone leaned into the back as it was going up, it would have silently slammed back down on their head or neck resulting in serious injury as the tailgate is quite heavy and quickly gains substantial momentum and force. Since the tailgate never reaches full height it appears that safety interlocks do not get activated/triggered hence it becomes a dead drop. It appears that the cause is a loss of pressure in the right rear strut, though other electronic factors may be considered. This is a very dangerous defect that has the potential to cause serious or even a fatal injury. A repair is scheduled at the dealer on may 25. Other incidents of this type have been reported on google search.
On the first of march, my wife and daughter were about to start their day in the usual way. She opened the garage door and used her key fob to remote start our 2012 Jeep gc limited ( around 42k miles) ( factory installed remote starter) she walked away for less than 4 minutes and returned to see smoke coming from front passenger side of Jeep. She called for me, and pushed the… Read more
On the first of march, my wife and daughter were about to start their day in the usual way. She opened the garage door and used her key fob to remote start our 2012 Jeep gc limited ( around 42k miles) ( factory installed remote starter) she walked away for less than 4 minutes and returned to see smoke coming from front passenger side of Jeep. She called for me, and pushed the aux button to be sure the vehicle was off. I came running and despite my attempts to open the hood and beat back what quickly escalated into open flames I retreated to ensure my family's safety and to be sure the emergency responders were called. Thankfully I was able to remove some potential fuel for the fire by removing our second car from the garage (also a chrysler) and securing the door between the house and garage. Luck intervened when the flames destroyed the garage door assembly causing the garage door to fall and help remove some oxygen from the fire. Eventually first responders arrived and were able to knock down the fire with foam . Later the firemen pushed the Jeep into the driveway to ensure it was doused. Though the remote start may not be directly responsible for whatever arc sparked the fire, it's my belief that its use contributed directly to the conditions that conflagrated the situation. If the wiring harness is otherwise suspect I would not be surprised considering recent revelations on related models. The vehicle was just removed from the site today 3/9/2016 to copart facility,