Clutch overheated and cause an immense amount of smoke during drive with no warning indication from hud. Dealer stated that clutch has gotten well passed 390c heat from clutch has also caused front driver caliper to lock up and damage rotors.
2020 Jeep Gladiator brakes problems
18 owners reported brakes problems — 4% of all 487 complaints about the 2020 Jeep Gladiator.
Brakes complaints by Jeep Gladiator year
What owners report
My Jeep Gladiator has recently been having multiple random error messages popping up. ABS warning, service 4wd, service shifter, traction control and others. Dealership charged $200 to diag a bad ABS module and charged $1400 to replace the module and controller. Less than 24 hrs later same issue occurred . Doing my own research this seems to be a common issue not just with… Read more
My Jeep Gladiator has recently been having multiple random error messages popping up. ABS warning, service 4wd, service shifter, traction control and others. Dealership charged $200 to diag a bad ABS module and charged $1400 to replace the module and controller. Less than 24 hrs later same issue occurred . Doing my own research this seems to be a common issue not just with gladiators but other jeeps as well. Many forums are saying it’s bad wire connectors or broken wires from improper initial installation. Causes issues with speed control, braking, and power steering.
Driver side rear wheel speed sensor. This is a known issue national back order on the part, mechanic installed new part system does not reset and clear. In the current state, ABS offline four-wheel drive system service required traction control service required. What is the true fix for this?
The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at approximately 40 MPH, the vehicle had suddenly started to vibrate and shake. The contact stated that the vehicle was maintaining its lane but was lurching from left to right. No warnings illuminated. The contact stated that she pulled off to the side of the road; however, when she turned the… Read more
The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at approximately 40 MPH, the vehicle had suddenly started to vibrate and shake. The contact stated that the vehicle was maintaining its lane but was lurching from left to right. No warnings illuminated. The contact stated that she pulled off to the side of the road; however, when she turned the vehicle on, it would start shaking again. The contact stated that she would keep driving while the vehicle was shaking, and the shaking would eventually stop. The contact stated that the shaking was occurring at any speed and was also triggered when she would drive over any small bumps or dips in the road. The contact stated recently, while she was driving in traffic at approximately 10 MPH, the vehicle started to shake again, however, this time violently. The contact stated that at the time, it was raining. The contact stated that it felt like the vehicle had lifted up, and then she crashed into the guard rail on the driver's side front bumper. The contact stated that the bumper and an LED light bar attached to the front grill had made contact and were slightly damaged, and the driver's side headlight stopped functioning. The police were not called, and the contact was not injured. The contact reported that the driver's side front air bag had deployed but had not inflated and was draped on her lap. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed
During normal driving, dash would display multiple warning lights. There would be traction control, ABS inactive, and transmission errors displayed on the screen. Twice, there was a loss of power steering while driving. All signs pointed to a can buss issue, but dealer could not/ would not find it. Doing research, I found that the can buss connector located behind the glove… Read more
During normal driving, dash would display multiple warning lights. There would be traction control, ABS inactive, and transmission errors displayed on the screen. Twice, there was a loss of power steering while driving. All signs pointed to a can buss issue, but dealer could not/ would not find it. Doing research, I found that the can buss connector located behind the glove compartment was known in the Jeep community to fail and cause these symptoms. The only replacement is offered by mopar/stellantis. Multiple models and makes under stellantis company use this same connector that has bad solder connections inside. It causes increased resistance inside the connector, and causes can buss communication errors, and setting any one of hundreds of possible dtc. In every occasion, there was a loss of stability control, ABS, and multiple occasions of vehicle being locked in park. In two occasions, the electric assist power steering was disabled.
Loss speedometer and all dash gauges. Known problem on forums; however no tsb or recall to fix issue. Plethora of cel codes to include causing speed to not display on digital or analog indicators.
I was driving at about 5 MPH and about to go onto the freeway on ramp in riverside, california, when the sensor in my car went off and locked the brakes, causing the person behind me to rear-end me. This is not the first time this has happened with this vehicle. Luckily, I was not injured, however, this could have been a serious injury if I was traveling at a higher speed or under many other circumstances.
My truck malfunctioned at an automatic car wash. It has approximately 54k miles. I had no warning lights or system alerts on vehicle or uconnect app. I stopped in the parking lot & put the Gladiator in park, I left the ignition on. I got off truck & got a towel to clean interior.there are several spaces to vacuum. I put the vehicle in drive to move forward & out of the way of… Read more
My truck malfunctioned at an automatic car wash. It has approximately 54k miles. I had no warning lights or system alerts on vehicle or uconnect app. I stopped in the parking lot & put the Gladiator in park, I left the ignition on. I got off truck & got a towel to clean interior.there are several spaces to vacuum. I put the vehicle in drive to move forward & out of the way of a patron that was going to reverse out. In drive, I pushed the gas pedal in a slight & normal way. The truck reversed in drive position. It accelerated to an unknown speed, it felt constant. I pushed break with foot I pushed d with. Right foot. The breaks didn’t work. I tried breaking several times during incident, it was approximately 10 seconds. I didn’t have time to use e- break. I don’t believe back up camera was displayed. I concentrated on physically looking at surroundings & steering. I avoided hitting 1 car, a suv & a brick wall. The truck made contact with around 4 trees & a sign. The damage was mainly to l side. There’s damage to r side & r back tire had a bulge on it. I went over a concrete, grassy area & felt the impacts of front & back ends going over it & landing. I went over another concrete curve & hit a tree at an angle around the middle of front l cab. The impact caused the car to bounce forward. It didn’t move. I put the truck in park from d position. I pushed off button. I couldn’t get out of truck of driver side door it’s damaged. 1 witness & lady from suv stopped to check on me.
A braking sensor failed on the Gladiator causing the ABS, 4wd, and cruise warning lights to become illuminated. The brakes then did not work properly causing an accident. The edr report shows the ABS system was turned off as a result of the sensor. The attached documentation shows an expert reviewed the information and came to the conclusion the failed sensor caused the ABS… Read more
A braking sensor failed on the Gladiator causing the ABS, 4wd, and cruise warning lights to become illuminated. The brakes then did not work properly causing an accident. The edr report shows the ABS system was turned off as a result of the sensor. The attached documentation shows an expert reviewed the information and came to the conclusion the failed sensor caused the ABS to be off which in turn caused the brakes to lock. The brakes locking caused a skid which caused the accident. Also to note the general manager of bellevue autonation let me know the sensor has since been changed out along with the brake cables on 06/05/2021 for all Jeep gladiators. Jeep has known this is a problem and has not done a recall.
First incident was approaching a turn off into a shopping area, a car was stopped there waiting for traffic as I approached I applied the brakes and the brake pedal went to way down, I didn't have time to recycle brake pedal as it went so far down I was hitting gas pedal, thus causing me to collide. Second incident occurred while driving to town and a strong brake burnt smell… Read more
First incident was approaching a turn off into a shopping area, a car was stopped there waiting for traffic as I approached I applied the brakes and the brake pedal went to way down, I didn't have time to recycle brake pedal as it went so far down I was hitting gas pedal, thus causing me to collide. Second incident occurred while driving to town and a strong brake burnt smell was occurring, when I attempted to stop again brake pedal went way down again which this time I had time to regain control from hitting gas pedal and force stop, inspected brakes and front brakes were extremely hot and smoking as if brakes were being constantly applied, I did not feel brakes being applied going down the highway just smell and inspection of front brakes heating up. I called roadside assistance and vehicle was towed to repair station waiting on results. I feel that if not taken care of total brake failure would occur and major accident.
I purchased the Jeep on 12/30/2019. It had 1,200 miles when the incident occurred. The vehicle was in motion when 4wd and ABS warning light came on to indicate failure. I hit the brakes and nothing happened. The vehicle did not stop and caused an accident when I could not stop at a red light.*dt consumer is currently waiting on diagnosis and no repairs have been made.… Read more
I purchased the Jeep on 12/30/2019. It had 1,200 miles when the incident occurred. The vehicle was in motion when 4wd and ABS warning light came on to indicate failure. I hit the brakes and nothing happened. The vehicle did not stop and caused an accident when I could not stop at a red light.*dt consumer is currently waiting on diagnosis and no repairs have been made. During the accident consumer had neck, back, and shoulder injuries. Police report has been filed case [xxx]. ('parts of this document have been redacted to protect personally identifiable information pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).')*jb