CarProblemsDB

2000 Honda CR-V engine problems

17 owners reported engine & cooling problems — 13% of all 129 complaints about the 2000 Honda CR-V.

Engine & cooling complaints by Honda CR-V year

20271
202612
202526
202425
202321
202220
202138
202041
2019116
2018546
2017545
2016105
2015255
2014194
201399
201291
201144
201061
200915
200842
200729
200623
200536
2004154
200392
200265
200133
200017

What owners report

Mar 10, 2017engine

Exhaust valves on my 2000 Honda crv charred and exhaust valve in cylinder #1 chipped and charred. All valves and #1 seats had to be replaced. I understand that this seems to be a common design problem to 2000 crv's and civics.

NHTSA complaint #10959979
Mar 15, 2016engine and engine cooling
Tl* the contact owns a 2000 Honda CR-V. While driving 30 MPH, the check engine warning light illuminated and the vehicle stalled. The failure recurred intermittently. The vehicle was taken to an independent mechanic where it was diagnosed that the muffler, and radiator needed to be replaced. The vehicle was repaired, but the failure recurred. The manufacturer was notified of… Read more

Tl* the contact owns a 2000 Honda CR-V. While driving 30 MPH, the check engine warning light illuminated and the vehicle stalled. The failure recurred intermittently. The vehicle was taken to an independent mechanic where it was diagnosed that the muffler, and radiator needed to be replaced. The vehicle was repaired, but the failure recurred. The manufacturer was notified of the failure. The failure mileage was 184,000. Updated 04/29/16*lj *tr *cn

NHTSA complaint #10849847
Apr 12, 2015suspension, structure, engineFire

On 4/11/15 at 3:00 am we were woken up to see our Honda crv ex which was parked on our driveway next to our house was engulfed in fire. It was a ball of fire. The last it was driven was on 4/9/15 at 5:00 pm, so the car was not drive for 34 hours. We did not have any problems prior to this incident. The car was completely burned and there is damaged to our house because of the car fire. *tr

NHTSA complaint #10705199
Jan 9, 2012engine and engine cooling, unknown or other
At approx 147,000 miles, check engine light came one. After determining it was not due to leaking gas cap, ran a diagnostic on it. It produced error codes of p0300, p0301, p0302, p0303, p0304 and p1399 (all misfire codes). Took it to a highly recommended mechanic where they also ran their own diagnostic with same error codes. The checked the valves right away because there is… Read more

At approx 147,000 miles, check engine light came one. After determining it was not due to leaking gas cap, ran a diagnostic on it. It produced error codes of p0300, p0301, p0302, p0303, p0304 and p1399 (all misfire codes). Took it to a highly recommended mechanic where they also ran their own diagnostic with same error codes. The checked the valves right away because there is a known issue (defect) with the first gen crv head. Honda has admitted the problem and re-designed the head for my year model to eliminate the value problem. My heads had already been adjusted at 95k (as recommended by the Honda dealer service dept) although the recommended adjustment is at 105k miles. With mine requiring adjustment 10k miles sooner, this should be a red flag of a problem with my engine. But now there is no room for further adjustment; only solution is to replace the head with the re-designed head. In earlier years (2006) Honda was replacing at no cost through their goodwill program. They won't assist me in any way - in fact, american Honda customer service told me there was no such thing as a Honda goodwill program. I found out about the program because my dealership told me about it and that american Honda and denied my request! I had every single required maintenance service performed at our local Honda dealership; on time or early as recommended. The only time it was ever taken somewhere else was for a few oil changes and that was only because Honda couldn't work me in accordin

NHTSA complaint #10443164
Jan 9, 2012engine and engine cooling
Tl* the contact owns a 2000 Honda crv. The contact stated that while driving 35 MPH, the vehicle check engine warning lamp illuminated. The vehicle was taken to a local mechanic who diagnosed that the exhaust valves were out of adjustment and needed to be replaced. The manufacturer was made aware of the failure who did not offer any assistance since the vehicle was no longer… Read more

Tl* the contact owns a 2000 Honda crv. The contact stated that while driving 35 MPH, the vehicle check engine warning lamp illuminated. The vehicle was taken to a local mechanic who diagnosed that the exhaust valves were out of adjustment and needed to be replaced. The manufacturer was made aware of the failure who did not offer any assistance since the vehicle was no longer under warranty. The vehicle was not repaired. The failure and the current mileage was 147,000.

NHTSA complaint #10443161
Aug 27, 2010engine and engine cooling
We found what we thought would be the perfect vehicle for her a 2000 Honda crv with only 37,500 miles on it. After looking at the vehicle we decided to purchase it due to its great condition and lack of use. The check engine light was on when we looked at it. But the people we dealt with locally stated it was probably due to lack of driving and would need only a tune up. … Read more

We found what we thought would be the perfect vehicle for her a 2000 Honda crv with only 37,500 miles on it. After looking at the vehicle we decided to purchase it due to its great condition and lack of use. The check engine light was on when we looked at it. But the people we dealt with locally stated it was probably due to lack of driving and would need only a tune up. We picked the vehicle up on friday 8-20. I tuned up the crv with new platinum plugs, new rotor, distributor cap, and plug wires. The truck ran a little better but still had the check engine light on. I decided to bring it to a Honda dealer and have them look at it first thing monday 8-23. They stated it may be a valve adjustment. The dealer's service department called me and stated that the problems were much larger. A rocker arm had broken off and was floating in the engine and had done damage to valves etc. The crv would need a top end rebuild with head etc at a cost of $4400. We paid only $4500 for the vehicle. *tr

NHTSA complaint #10352259
Mar 29, 2008engine and engine cooling
October 2005 - low compression, burned valves. Head machined, valves replaced. Only 82,000 miles. Complained to Honda and they reimbursed me for the parts & labor, almost $1,500. Fast forward to february 2008. Same failure, same valves, 162,000 miles. Cost now is $4,000 because the head can't be machined a second time. Dealer stated Honda recommends valves be adjusted… Read more

October 2005 - low compression, burned valves. Head machined, valves replaced. Only 82,000 miles. Complained to Honda and they reimbursed me for the parts & labor, almost $1,500. Fast forward to february 2008. Same failure, same valves, 162,000 miles. Cost now is $4,000 because the head can't be machined a second time. Dealer stated Honda recommends valves be adjusted every 30,000 miles. Owner's manual contradicts that - inspect/adjust valves only if noisy and at 105,000 miles. Because the valves get tight, they don't get noisy. Honda is aware of this problem and has a responsibility to repair/replace the defective head assembly. *tr

NHTSA complaint #10222678
Feb 26, 2008engine and engine cooling
Honda 2000 crv check engine light went on. Car was running and idling rough. I found out that tsb 03-038 (technical service bulletin) had been issued for all Honda crv's from 1999-2001. This defect concerns a defective cylinder head that causes the valves to recede into the head. When I contacted Honda north america regarding my 2000 Honda crv they denied responsibility for… Read more

Honda 2000 crv check engine light went on. Car was running and idling rough. I found out that tsb 03-038 (technical service bulletin) had been issued for all Honda crv's from 1999-2001. This defect concerns a defective cylinder head that causes the valves to recede into the head. When I contacted Honda north america regarding my 2000 Honda crv they denied responsibility for this defect since my vehicle was out of warranty. *tr

NHTSA complaint #10219202
Jan 15, 2008engine and engine cooling
My Honda vehicle, 2000 crv, is one of many hondas that has a defective cylinder head within the engine. This caused multiple breakdowns in my car of which many occurred at an intersection and became very dangerous to my safety and others on the road. Honda posted a technical bulletin, 03-038 that there was a defective cylinder head but most Honda owners are unaware of it. I… Read more

My Honda vehicle, 2000 crv, is one of many hondas that has a defective cylinder head within the engine. This caused multiple breakdowns in my car of which many occurred at an intersection and became very dangerous to my safety and others on the road. Honda posted a technical bulletin, 03-038 that there was a defective cylinder head but most Honda owners are unaware of it. I didn't receive full consideration for this part to be replaced and requested it despite my warranty being up. I feel very strongly that Honda is not taking this defect seriously enough and have found many Honda owners experiencing the same problem. The part needs to be recalled and addressed because Honda has failed to take this bulletin more seriously given the fact that it put my safety in danger and others as well. *tr

NHTSA complaint #10214863
Nov 25, 2006engine and engine cooling
2000 Honda crv - valve seat problem involving necessary head replacement. This is a known defect affecting a large percentage of models produced. The metal used to manufacture the head is apparently too soft of a compound to withstand the engine temperatures. I can not find a recall and have not been notified by Honda or advised of such by the dealer. The vehicle was in four… Read more

2000 Honda crv - valve seat problem involving necessary head replacement. This is a known defect affecting a large percentage of models produced. The metal used to manufacture the head is apparently too soft of a compound to withstand the engine temperatures. I can not find a recall and have not been notified by Honda or advised of such by the dealer. The vehicle was in four months ago and I was not informed of any potential problem nor were any corrective measures implemented. *nm

NHTSA complaint #10174217
Apr 10, 2006engine and engine cooling

Dt*: the contact stated while driving 35mph, the check engine lamp illuminated. The vehicle was taken to a local repair shop for inspection. The mechanic determined one of the valves in the engine would need replaced. The valve was replaced due to loss of compression.

NHTSA complaint #10154945
Apr 16, 2004engine and engine cooling

At 85,000 miles, exhaust valves had to be replaced. Seven were worn by heat. One was cracked. Inquiry with dealers and firm which actually repairs engine valves said they have been seeing a number of crv's-which have recessed valves-with the same problem as mine.*ak

NHTSA complaint #10066331
Jan 30, 2004engine and engine cooling

Cylinder head failed, resulting in improper venting of exhaust and problems with fuel burn. This could lead to failure of the vehicle and dangerous buildup of noxious fumes.

NHTSA complaint #10056191
Jan 9, 2004engine and engine cooling

The crv will have the motor just stall - even while traveling at highway speeds. Sometimes it will also stall while ideling. Sometimes it is hard to start, requires a jump. This has been happening for over a month. Dealership can't fix.*ak

NHTSA complaint #10052705
Aug 26, 2003engine and engine cooling

Vehicle was beginning to overheat, and consumer decided to inspect the radiator to find numerous pin holes. The pin holes were causing vehicle to overheat on a regular basis.*ak

NHTSA complaint #10037617
Apr 18, 2003engine and engine cooling

Exhaust valves on my 2000 Honda crv charred and exhaust valve in cylinder #4 chipped and charred. All valves had to be replaced. I understand that this seems to be a common design problem to 2000 crv's and civics. *nlm

NHTSA complaint #10016175
Apr 22, 2002engine and engine cooling

Engine dip stick and sleeve have disconnect itself from the engine while driving,.dealer and the manufacturer were notified. Feel free to provide any further information.*ak

NHTSA complaint #8008259
← All 2000 Honda CR-V problems & recalls