Dec 10, 2020vehicle speed control
While driving my 2011 Ford Mustang (with a v6 engine and automatic transmission) at 40mph on a local street, I experienced the vehicle unexpectedly losing power and a fault light in the form of a wrench appearing on the dashboard. The engine speed dropped down to idle and did not respond to any gas pedal operation. The cars engine remained running, however, the engine ran… Read more
While driving my 2011 Ford Mustang (with a v6 engine and automatic transmission) at 40mph on a local street, I experienced the vehicle unexpectedly losing power and a fault light in the form of a wrench appearing on the dashboard. The engine speed dropped down to idle and did not respond to any gas pedal operation. The cars engine remained running, however, the engine ran roughly as evidence of it shaking the entire car. The incident placed myself and other drivers around me in danger, as I had to move quickly to get my vehicle out of the moving traffic and into a safe place off the side of the road.
NHTSA complaint #11382878
Jun 17, 2019vehicle speed control, engine
Tl* the contact owns a 2011 Ford Mustang. While driving 70 MPH with the cruise control engaged, the vehicle stalled and the check engine warning indicator illuminated. The vehicle was towed to elkins fordland (696 beverly pike, elkins, wv 26241, (304) 636-2222), but they were unable to duplicate the failure. The vehicle was not diagnosed or repaired. The manufacturer was… Read more
Tl* the contact owns a 2011 Ford Mustang. While driving 70 MPH with the cruise control engaged, the vehicle stalled and the check engine warning indicator illuminated. The vehicle was towed to elkins fordland (696 beverly pike, elkins, wv 26241, (304) 636-2222), but they were unable to duplicate the failure. The vehicle was not diagnosed or repaired. The manufacturer was contacted and did not assist. The failure mileage was 50,000.
NHTSA complaint #11220633
Apr 5, 2017vehicle speed control, service brakes
Tl* the contact owns a 2011 Ford Mustang. When the accelerator pedal was depressed up to 40 MPH, the throttle became stuck and the brakes failed to respond without warning. As a result, the contact shifted the vehicle into the neutral to stop. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 43,000.
NHTSA complaint #10970713
Jan 9, 2017vehicle speed control
Vehicle stuck accelerator at slow and higher speeds!! It happened once while I was driving it and once while my daughter was driving. This could easily cause severe accident. Throttle body was replaced by dealer. This accelerator problem happened after the throttle body was replaced. By the dealer. I brought it back to the dealer after this incident and they called me and… Read more
Vehicle stuck accelerator at slow and higher speeds!! It happened once while I was driving it and once while my daughter was driving. This could easily cause severe accident. Throttle body was replaced by dealer. This accelerator problem happened after the throttle body was replaced. By the dealer. I brought it back to the dealer after this incident and they called me and said "they can find nothing wrong". I told them to keep the car until the find the problem as this out of control acceleration is very dangerous. *tr
NHTSA complaint #10943802
Oct 11, 2016vehicle speed control, engine
While driving with cruise control set at 55 MPH, car began to decelerate, yellow "wrench" advisory light illuminated and engine appeared to be running rough. Car slowed to a stop and I pulled the car off the roadway. I switched off the ignition and waited approximately 30 seconds. I restarted the car. The advisory light stayed off and the engine ran normally thereafter. … Read more
While driving with cruise control set at 55 MPH, car began to decelerate, yellow "wrench" advisory light illuminated and engine appeared to be running rough. Car slowed to a stop and I pulled the car off the roadway. I switched off the ignition and waited approximately 30 seconds. I restarted the car. The advisory light stayed off and the engine ran normally thereafter. When the incident occurred, the car was on a highway curving turn to the right. The incident occurred coming out of the curve.
NHTSA complaint #10915386
Oct 7, 2016vehicle speed control
While driving on the highway the motor shuts off. I have to quick pull off the road, restart the car. It will drive but again get up to highway speed, car shuts off. After about the 5th time, finally a code comes on, p2111 (throttle actuator control system - stuck open. Very dangerous driving on the highway.
NHTSA complaint #10914427
Oct 3, 2016vehicle speed control
Engine stalled while driving several times (once on a city street and twice on the highway). On other occasions the car would hesitate to respond to the accelerator. Mechanic scanned the computer and found code p2111 throttle actuator control system stuck open, and determined the cause of the problem to be the throttle body.
NHTSA complaint #10913555
Jul 8, 2016vehicle speed control
While driving, without warning, the vehicle's wrench warning light comes on and the vehicle goes into idle mode. The car will not accelerate and you have to pull over, turn the engine off, and then restart the car.
NHTSA complaint #10883532
May 3, 2016vehicle speed control, engine
Tl* the contact owns a 2011 Ford Mustang. While driving approximately 65 MPH, the accelerator pedal was depressed but the vehicle failed to accelerate. The vehicle was towed to a dealer where it was diagnosed that the throttle body needed to be replaced. The vehicle was not repaired due to part unavailability. The contact was unaware if the manufacturer was notified of the failure. The failure mileage was unknown.
NHTSA complaint #10862833
Apr 7, 2016vehicle speed control, engine, fuel/propulsion system
While driving my 2011 v6 Mustang the car will completely loose power. This has happened on the highway and on side streets. There is no warning. The wrench light comes on and the car is forced to idle. No response at all to throttle input. Error code read is p2111 which indicates "throttle actuator "a" control system - stuck open". It is my understanding that the… Read more
While driving my 2011 v6 Mustang the car will completely loose power. This has happened on the highway and on side streets. There is no warning. The wrench light comes on and the car is forced to idle. No response at all to throttle input. Error code read is p2111 which indicates "throttle actuator "a" control system - stuck open". It is my understanding that the throttle body in this vehicle is the same as used in other Ford vehicles. A recall has been issued for those other vehicles but everyone suffering from this on the v6 Mustang is on their own. This can be very dangerous for people accelerating to merge and very dangerous on the highway to stop in the middle of the road or have to limp to the shoulder through traffic at idle. I have already paid $300 for a full throttle body service and the same thing is still happening.
NHTSA complaint #10853947
Dec 29, 2015vehicle speed control
Tl* the contact owns a 2011 Ford Mustang. The contact stated that while driving at 55 MPH, the vehicle failed to accelerate and started losing power. The contact stated also that the electronic throttle body warning light illuminated. The vehicle was merged to the shoulder of the road but still failed to accelerate. The vehicle was taken to a dealer where it was diagnosed that… Read more
Tl* the contact owns a 2011 Ford Mustang. The contact stated that while driving at 55 MPH, the vehicle failed to accelerate and started losing power. The contact stated also that the electronic throttle body warning light illuminated. The vehicle was merged to the shoulder of the road but still failed to accelerate. The vehicle was taken to a dealer where it was diagnosed that the throttle body needed to be replaced however, the vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 51,800. Updated 02/12/16*lj
NHTSA complaint #10816758
Nov 30, 2015vehicle speed control
Immediate loss of power and complete loss of acceleration. This has occurred in an intersection and in the middle of a multi-lane highway at 35 MPH and 60 MPH and when either accelerating or holding at a steady speed. The wrench light comes on and the vehicle immediately loses power and decelerates regardless of speed. The vehicle is inoperable until it is turned off and… Read more
Immediate loss of power and complete loss of acceleration. This has occurred in an intersection and in the middle of a multi-lane highway at 35 MPH and 60 MPH and when either accelerating or holding at a steady speed. The wrench light comes on and the vehicle immediately loses power and decelerates regardless of speed. The vehicle is inoperable until it is turned off and restarted. The problem is recurring and unpredictable. Because the code disappears upon restarting it cannot be diagnosed. I had to get a code reader to get the code which had to be used after an emergency stop along the highway. This is dangerous as there is no warning before the loss of power. Error code p2111-throttle actuator control system stuck open. The problem has occurred 10/29/15, 11/16/15, 11/25/15, and 11/30/15.
NHTSA complaint #10807387
Nov 5, 2015vehicle speed control
Car randomly goes into "limp home" mode. Code could not be caught by dealer so I purchased a scanner. Code caught everytime is p2111 representing that the throttle body actuator is stuck open. This can happen within a few miles of driving or up to 20 miles. It can happen at 5 MPH or 65 MPH. It can happen within the first few minutes of a trip or 30 minutes in. It can… Read more
Car randomly goes into "limp home" mode. Code could not be caught by dealer so I purchased a scanner. Code caught everytime is p2111 representing that the throttle body actuator is stuck open. This can happen within a few miles of driving or up to 20 miles. It can happen at 5 MPH or 65 MPH. It can happen within the first few minutes of a trip or 30 minutes in. It can happen once or every few minutes. This is very dangerous as the limp home does not get enough power to get off road. I almost caused a multi car accident . Can you imagine driving down the highway and the car just stops? It doesn't even coast. I see this complaint on alot of Ford forums. It is like Ford is just waiting for someone to be killed or sue them before they solve the issue. I have taken it to the Ford dealer and they say it is my battery. I went to an independent source and they tested my battery and I had known, the battery is fine. I have been into Ford service numerous times and when I return they do everthing but fix the issue. The date below is the 1st time experienced. It didn't happen often but this year is everytime I drive.
NHTSA complaint #10788529
May 7, 2013vehicle speed controlCrash
Tl* the contact owns a 2011 Ford Mustang. The contact stated that the vehicle stalled numerous times without warning. The wrench warning light illuminated after the failure occurred. The vehicle was taken the to the dealer several times for the failure who located the failure at the throttle body. The throttle body was replaced but the failure recurred and caused the contact… Read more
Tl* the contact owns a 2011 Ford Mustang. The contact stated that the vehicle stalled numerous times without warning. The wrench warning light illuminated after the failure occurred. The vehicle was taken the to the dealer several times for the failure who located the failure at the throttle body. The throttle body was replaced but the failure recurred and caused the contact to crash into the proceeding vehicle rear end. There was no injury to report. The manufacturer was made aware of the failure. The vehicle was towed to the dealer for further inspection. The failure mileage was 36,264 and current mileage was 36,508.
NHTSA complaint #10510909
Dec 17, 2012vehicle speed controlCrash1 injured
Driver was leaving parking lot of bank, when she states gas pedal stuck. She crossed 2 lanes of traffic and struck a building. Driver later succumbed to injuries. *tr
NHTSA complaint #10489025