CarProblemsDB

2002 Ford F-150 wheels problems

13 owners reported wheels problems — 2% of all 821 complaints about the 2002 Ford F-150.

Wheels complaints by Ford F-150 year

20251
20241
202321
20228
202127
20204
20199
201842
201740
201653
201537
201425
201339
201218
201113
201012
20097
20087
20078
200610
200516
200421
200313
200213
200114
200013

What owners report

Feb 2, 2024wheels

The contact owns a 2002 Ford F-150. The contact stated while at a tire shop to have the tires rotated, the mechanic was unable to remove the tires due to the lug nuts being swollen. The manufacturer was made aware of the failure and suggested to the contact to call the NHTSA hotline to report the failure. The approximate failure mileage was 100,000.

NHTSA complaint #11569578
Apr 7, 2016wheels, unknown or other
Takata recall. While I was driving I noticed a loud pop and my truck started vibrating and spun me sideways going down the highway. I had fought it until I was able to get it under control and come to a stop. (I was lucky enough that nobody else was heading in my direction because the truck took up both sides of the road). I got out and looked to see what had happened and seen… Read more

Takata recall. While I was driving I noticed a loud pop and my truck started vibrating and spun me sideways going down the highway. I had fought it until I was able to get it under control and come to a stop. (I was lucky enough that nobody else was heading in my direction because the truck took up both sides of the road). I got out and looked to see what had happened and seen my aluminum Ford factory rim had busted into pieces. Takata recall. A problem that I am having as of right now is spark plugs keep flying out and destroying my coil packs. This is the third time it has done this.

NHTSA complaint #10853941
Nov 8, 2015wheelsCrash1 injured
Involved in a roll over accident caused by the right front tire (purchased in 5-13-2014) bfg 275/60r17 from discount tires. Truck was totaled and the one piece of tire we have does not have the dot numbers on them. When the blow out occurred I hit soft sand losing traction causing the truck to roll 3 times while on a main road. I will be including three pictures - one of… Read more

Involved in a roll over accident caused by the right front tire (purchased in 5-13-2014) bfg 275/60r17 from discount tires. Truck was totaled and the one piece of tire we have does not have the dot numbers on them. When the blow out occurred I hit soft sand losing traction causing the truck to roll 3 times while on a main road. I will be including three pictures - one of the tire on its rim, one of the truck at the tow yard and one of the piece of tire we picked up off the road upon my release from the hospital. The chp officer did not speak to any witnesses and I heard the lady who called 911 tell the officer I suffered a blow out and she pointed it out to him - yet he does not even mention it in the report nor the names of any witnesses. My insurance company (aaa) claims unless I file a complaint with the tire manufacturer they will find me at fault for not maintaining control of the vehicle which I find to be totally ridiculous. I handled a blow out in a Ford explorer on a dry freeway previously and was able to control the vehicle to the shoulder without any serious damage or injuries. Different story when you hit sand. I feel the tire blowing out is what was the cause of the accident.

NHTSA complaint #10789127
Jan 19, 2014wheels, service brakesCrash
Front brake caliper mounting bracket seized on the slide bolts that allow the brakes to move in and out when pressed and released. The slide bolts that allow the caliper to move have seized causing the vehicle to pull very hard to one side of the road. In my case I was towing a 20' commercial landscape trailer equipped with dual axle trailer brakes. I approached a traffic… Read more

Front brake caliper mounting bracket seized on the slide bolts that allow the brakes to move in and out when pressed and released. The slide bolts that allow the caliper to move have seized causing the vehicle to pull very hard to one side of the road. In my case I was towing a 20' commercial landscape trailer equipped with dual axle trailer brakes. I approached a traffic light and proceeded to make a left turn going a speed of approximately 15 to 20 MPH when I pressed the brake during the turn the truck pulled extremely hard to the left resulting in my trailer jack knifing into the left side of the truck causing major damage to my bed and rear wheel on my truck. Later after investigating the cause of the sudden pull found that the left brake caliper mounting bracket had one of the bolts seized while the other was moving properly allowing the brake to move a little but not properly causing the brake to drag against the rotor on the inner brake pad. When the brake is pressed the pressure pulls the truck to the left extremely hard. Replacing the slide bolts and the brake caliper mounting bracket fixed this issue and I haven't had any issues after replacement. I know this may be a little hard to understand as my description may not be the best, but the upper brake caliper bolt was seized while the lower bolt was moving freely, when the brake peddle was pressed caused the left brake caliper to grab harder than the right side causing the truck to pull extremely hard to the left.

NHTSA complaint #10560585
Jul 11, 2005steering, structure, wheelsCrash
Vehicle was traveling at 15 MPH and lost control due to a codder pin snapping in half causing the right front wheel to come entirely off of the vehicle. The disk brake stayed connected to the rim and was also removed entirely from the vehicle causing the brake lines to be severed which caused no pressure. With no pressure in the brake lines I was not able to stop the other… Read more

Vehicle was traveling at 15 MPH and lost control due to a codder pin snapping in half causing the right front wheel to come entirely off of the vehicle. The disk brake stayed connected to the rim and was also removed entirely from the vehicle causing the brake lines to be severed which caused no pressure. With no pressure in the brake lines I was not able to stop the other wheels but was forced to let the vehicle come to a skidding stop, which happened by hitting a tree. The vehicle was taken to a local Ford dealership where a year prior they had worked on the same wheel to pack the bearings and do other small maintenance. Both the dealership and Ford claimed no responsibility for the accident, which seems strange since a vehicles wheel should remain on when going 15 MPH.

NHTSA complaint #10128308
Jun 14, 2004steering, wheelsCrash1 injured

There was no cotter pin installed on the front driver side spindle. As a result, the entire driver side front wheel fell off and the vehicle crashed into a parked car. *ak *nm

NHTSA complaint #10072086
← All 2002 Ford F-150 problems & recalls