Mar 6, 2018vehicle speed control, service brakesFire
Tl* the contact owns a 2000 Ford Expedition. While the vehicle was undergoing an oil change, the cruise control switch underneath the hood that was connected to the brake master cylinder caught on fire. The contact stated that the ignition was off at the time. The contact was able to extinguish the fire. A fire report was not filed. The contact, a certified mechanic, stated… Read more
Tl* the contact owns a 2000 Ford Expedition. While the vehicle was undergoing an oil change, the cruise control switch underneath the hood that was connected to the brake master cylinder caught on fire. The contact stated that the ignition was off at the time. The contact was able to extinguish the fire. A fire report was not filed. The contact, a certified mechanic, stated that there was brake fluid coming out of the cruise control switch. The vehicle was not repaired. The dealer was not contacted. The manufacturer was not notified of the failure. The approximate failure mileage was 201,000.
NHTSA complaint #11076444
Jan 5, 2018vehicle speed control, service brakes, engine
Throttle feels like its sticking. The breaks feel like they get harder the longer you drive or use them. Its been extremely cold the last few weeks (air temp of -28f lows to -3f for highs). You let off the break from a stop sign or stop light and it will suddenly accerlerate by itself. Seems to happen anytime after 40mph, even if you slow back down to 10-15mph it will… Read more
Throttle feels like its sticking. The breaks feel like they get harder the longer you drive or use them. Its been extremely cold the last few weeks (air temp of -28f lows to -3f for highs). You let off the break from a stop sign or stop light and it will suddenly accerlerate by itself. Seems to happen anytime after 40mph, even if you slow back down to 10-15mph it will accelerate back up on its own, up to as fast as 65mph!) I need to downshift and ride brakes (which are hard as a rock!!!) to keep it from excelling though town and to try to keep the rpms at bay. When coming to a stop and turning its hard to steer and it makes jumpy/jerky movements forward when brakes are applied. When vehicle comes to a stop the rpms skyrocket until you shut down the engine. If you havn't given it enough time before you start it again, the engine and rpms soar up again. Things we've tried with no luck are, disengaging the cruise control, replacing the spring under hood where the throttle cable is. Thought maybe it was stretched and not depressing fully to alow deceleration. After that we replaced the throttle body itself. Again, no luck on test drive. You can hear a click/ping in the pedal and see it come up once truck is in park, give it time. Pedal seems to be partially depressed and there is play. Have tried to stick foot under the pedal to try and get it to disenge. Worked the first few times that's also why thought it was the spring. No longer works to do that. Can seem to hear a diffe
NHTSA complaint #11060776
Apr 16, 2015service brakes
Anti-lock brake system activated while driving on interstate with cruise control set at 65 MPH, causing uncontrolled stop in moving traffic without warning. Never had any previous problems with ABS system. The ABS warning light was not on (and is still not on). Ford's customer relations center suggested I take my vehicle to a Ford dealership for to determine the cause of this… Read more
Anti-lock brake system activated while driving on interstate with cruise control set at 65 MPH, causing uncontrolled stop in moving traffic without warning. Never had any previous problems with ABS system. The ABS warning light was not on (and is still not on). Ford's customer relations center suggested I take my vehicle to a Ford dealership for to determine the cause of this problem. They also said there are no warranties, recalls or programs that would provide coverage for this critical safety issue with the ABS system. Before I do anything else to my vehicle I wanted to notify NHTSA first. *tr
NHTSA complaint #10706062
Apr 25, 2014suspension, fuel system, gasoline, service brakes
Brake line above fuel line completely rusted through. Luckily I was stopped for fuel and lost brake pressure. Upon inspection at my local garage, all brake lines were rusted to the point all were replaced. Upon closer inspection, the rear suspension parts are rusting underneath the coating that covered the suspension parts. I realize the vehicle is 14 years old, but I have… Read more
Brake line above fuel line completely rusted through. Luckily I was stopped for fuel and lost brake pressure. Upon inspection at my local garage, all brake lines were rusted to the point all were replaced. Upon closer inspection, the rear suspension parts are rusting underneath the coating that covered the suspension parts. I realize the vehicle is 14 years old, but I have much older vehicles that have zero rust. Just for the record, we have years that we have no snow, so my exposure to salt roads is very limited. Items such as brake lines and suspension parts should be made of a better quality material. After all, this vehicle still has the original exhaust system! Regardless of age, with just over 77k miles this is a serious safety issue. *tr
NHTSA complaint #10585005
Aug 22, 2011service brakes, hydraulic
Brake lines failed and lost 90% of brake power.
NHTSA complaint #10421939
Sep 7, 2010service brakes, hydraulic
Brake failure due to brake line rust. *tr
NHTSA complaint #10354172
Jul 10, 2010service brakes, hydraulic
I own a 2000 my Ford Expedition xlt. On july 4, 2010, I was leaving my house and driving down the street towards an intersection when I applied the brakes. Upon placement of my foot on the brake pedal, virtually all braking power was lost forcing me to quickly apply the emergency brake to avoid crossing an intersection. I then turned the vehicle around and drove back to my… Read more
I own a 2000 my Ford Expedition xlt. On july 4, 2010, I was leaving my house and driving down the street towards an intersection when I applied the brakes. Upon placement of my foot on the brake pedal, virtually all braking power was lost forcing me to quickly apply the emergency brake to avoid crossing an intersection. I then turned the vehicle around and drove back to my house and parked it until it could be towed. On july 6, 2010, the vehicle was towed to the local Ford dealership. Later that same day the Ford mechanic contacted me and said that the main supply line for the rear brakes had rusted causing a loss of brake fluid. Once the failure originally occurred, it did not correct itself until Ford replaced the brake system supply line. The brake failure was catastrophic in that it caused a near loss of all braking capacity. Had a vehicle been in the intersection or had I failed to rapidly engage the emergency brake, the incident would certainly have resulted in an accident in which property damage and or the loss of life could have occurred. Specifically, I was very fortunate not to have been involved in an accident. The Ford dealership did show me the removed section of brake supply line. It was heavily rusted in two sections, although I am uncertain which section was actually responsible for the brake failure. It is possible that the Ford dealer still has possession of the failed brake fluid supply line. *tr
NHTSA complaint #10342379
Jan 12, 2009service brakes, hydraulic, engine and engine cooling, electrical systemCrash
Tl*the contact owns a 2000 Ford Expedition. While driving approximately 40 MPH, the vehicle began to vibrate and the ABS indicator illuminated on the instrument panel. Immediately following, the odometer, heat, and radio became inoperable and the vehicle began idling loudly. Upon entering her driveway, the vehicle stalled. The brake pedal was depressed, but there was no… Read more
Tl*the contact owns a 2000 Ford Expedition. While driving approximately 40 MPH, the vehicle began to vibrate and the ABS indicator illuminated on the instrument panel. Immediately following, the odometer, heat, and radio became inoperable and the vehicle began idling loudly. Upon entering her driveway, the vehicle stalled. The brake pedal was depressed, but there was no reaction. The contact rear ended another vehicle in the driveway. The vehicle did not sustain any damages; however, the vehicle that was rear ended sustained damage to the rear bumper. There were no injuries or a police report. The vehicle was towed to a local repair shop and the mechanic stated that water entered through the windshield and drained into the fuse box, which damaged the g.e.m module. The dealer was not notified. The manufacturer stated that they were not liable for the repairs. The current and failure mileages were 120,000.
NHTSA complaint #10254723
Feb 12, 2007service brakes, hydraulic, vehicle speed controlFire
Tl*- the contact owns s a 2000 Ford Expedition with an odometer reading of 150000 miles. The contact stated that the vehicle was parked in the driveway when it caught on fire. The contact was able to put out the fire without contacting fire department. As the contact was putting out the fire under the hood they found that the master cylinder melted and was a possible source… Read more
Tl*- the contact owns s a 2000 Ford Expedition with an odometer reading of 150000 miles. The contact stated that the vehicle was parked in the driveway when it caught on fire. The contact was able to put out the fire without contacting fire department. As the contact was putting out the fire under the hood they found that the master cylinder melted and was a possible source of the fire. The cruise control wasattached to the braking system, and the recall 05v017000 concerning ) vehicle speed control:cruise control could be a cause as well. *ak
NHTSA complaint #10182319
May 23, 2006service brakes, hydraulic, electrical system, air bagsCrash1 injured
2000 Expedition horn failed. *ts when the horn failed to operate an accident occurred and the air bags failed to deploy. On a previous occasion, the consumer experienced problems with the cruise control and the ABS. The consumer stated the cruise control has been replaced 4 times and the horn was replaced 3 times. The consumer believed the continued failures of the ABS and… Read more
2000 Expedition horn failed. *ts when the horn failed to operate an accident occurred and the air bags failed to deploy. On a previous occasion, the consumer experienced problems with the cruise control and the ABS. The consumer stated the cruise control has been replaced 4 times and the horn was replaced 3 times. The consumer believed the continued failures of the ABS and horn were due to an electrical short in the wiring. *jb
NHTSA complaint #10158401
Jan 13, 2005service brakes, hydraulicFire
After parking the vehicle in the driveway, some fifteen minutes later the vehicle had flames coming from the hood. The consumer stated, the brake fluid leaked out of the cruise control onto the wiring harness. *nm
NHTSA complaint #10107379
Jan 13, 2005service brakes, hydraulicFire
The vehicle was parked without warning the vehicle caught fire. No injuries to report. The fire department was called to extinguished out the fire. The vehicle was towed by the insurance company. Please provide further information. *nm
NHTSA complaint #10107376
Jan 4, 2005service brakes, hydraulicFire
While vehicle was parked a fire started in the master cylinder. Dealership was notified, but did not resolve the problem. *ak same as complaint #10105051
NHTSA complaint #10106749
Dec 29, 2004service brakes, hydraulicFire
My wife parked our 2000 Ford Expedition at work around 8:30 a.m. Two hours later it was on fire. After many conversations with marshall mize Ford they told me that the cause of the fire started in the brake system. They said that brake fluid leaked on my manifold and sparked a flame causing my car to burst into flames. I was under the impression that brake fluid was not… Read more
My wife parked our 2000 Ford Expedition at work around 8:30 a.m. Two hours later it was on fire. After many conversations with marshall mize Ford they told me that the cause of the fire started in the brake system. They said that brake fluid leaked on my manifold and sparked a flame causing my car to burst into flames. I was under the impression that brake fluid was not flammable, especially after sitting for two hours it should not have even been hot enough. My truck was fixed and we have not had any problems with it yet. The fire started in the engine compartment on the left side. The fire was quickly put out causing there to be only $6500 in damage. Parts replaced consist of the main wiring harness, the components of the brake system under the hood, and the cruise control system. If needed we can fax a complete invoice of all parts and labor. *nm
NHTSA complaint #10104730
Nov 22, 2004service brakes, hydraulicFire
I was taking my child to school for a field trip. We were in the parking lot for approx. 20 min with the engine off. Then out of nowhere a big gush of gray/black smoke appeared. I immediately got myself and children out of the car and proceeded to call 911. At this time the 2 bus drivers came and ask me to pop my hood assuming it was my car running hot when they lifted the… Read more
I was taking my child to school for a field trip. We were in the parking lot for approx. 20 min with the engine off. Then out of nowhere a big gush of gray/black smoke appeared. I immediately got myself and children out of the car and proceeded to call 911. At this time the 2 bus drivers came and ask me to pop my hood assuming it was my car running hot when they lifted the hood there was flames. They got a fire ext. And put it out. I proceeded to find a way to get home and get my other children to school. I then called my mechanic and asked him to meet me at my truck. He inspected it and determined the sw asy and brake fluid lines had burned and melted . He talked to a couple of his friends whom own junkyards and they told him in the last year they have had 10 or so expeditions come in burned from the same problem. I called Ford and have had no response. I believe this is a man. Defect that needs to be looked into. Any help or comments would be appreciated because it could have turned out worse than what it did if I didn't have bus drivers there to help. *jb
NHTSA complaint #10100366
Oct 30, 2001service brakes, hydraulic, tires1 injured
While traveling heard noise coming from rear of vehicle. Dealer was contacted, and technician stated brakes needed to be replaced, repairs were made. While traveling rear tire (general tire 17 inch, no dot #) had a blowout, causing consumer to lose control of vehicle, driver sustained injuries. *ak *tt
NHTSA complaint #898400
May 16, 2001service brakes, hydraulicCrash
When applying brakes pedal went to the floor, causing extended stopping distance which resulted in a collision. Please give any further details.*ak
NHTSA complaint #888332