CarProblemsDB

2000 Ford Crown Victoria engine problems

21 owners reported engine & cooling problems — 25% of all 85 complaints about the 2000 Ford Crown Victoria.

Engine & cooling complaints by Ford Crown Victoria year

20113
20092
20082
20078
20063
200511
200410
200313
20028
200111
200021

What owners report

Jun 26, 2015engine

I was driving across the causeway when my car started shaking. I turned down the radio and it sounded like it back firing. I pulled over and called my mechanic to meet me where I broked down. H immediately saw the problem but he could not fix it. I had to bring it to another shop to get it repaired. Luckily when this happened I was getting off the causeway because that bridge is 24 miles long.

NHTSA complaint #10730648
Sep 19, 2014engine
Defective plastic intake manifold prone to cracking and leaking coolant. This item was previously reported to NHTSA and Ford was required to pay for repairs already done and to extend warranty. I'm told that warranty expired for something that a recall should have taken care of. I'm told that cost to repair is in excess of $1400. Contacted dealer and Ford asking for… Read more

Defective plastic intake manifold prone to cracking and leaking coolant. This item was previously reported to NHTSA and Ford was required to pay for repairs already done and to extend warranty. I'm told that warranty expired for something that a recall should have taken care of. I'm told that cost to repair is in excess of $1400. Contacted dealer and Ford asking for replacement of part and I will pay labor but both declined. *tr

NHTSA complaint #10637677
Aug 15, 2010engine and engine cooling

Intake manifold failure, cracked in rear at heater hose boss that resulted in coolant loss. Also, the #4 ignition coil was damaged by coolant leaking on to it from cracked manifold... *tr

NHTSA complaint #10349502
Feb 28, 2010engine and engine cooling

Crown Victoria 2000 has a crack intake manifold resulting in a leak coolant which is going inside of plug #8 causing a malfunction and car start shaking loosing power. *tr

NHTSA complaint #10314908
Nov 16, 2009engine and engine cooling
On 15 nov 2009, my car started spitting and sputtering, I thought it was bad gasoline. On 16 nov 2009, I had my car checked by my garage, was told that #5 spark plug and coil was bad due to leaking coolant at my intake manifold. After contacting my local Ford dealer thinking I could just buy a part vs. A whole manifold (like I was told I needed), I learned that there had… Read more

On 15 nov 2009, my car started spitting and sputtering, I thought it was bad gasoline. On 16 nov 2009, I had my car checked by my garage, was told that #5 spark plug and coil was bad due to leaking coolant at my intake manifold. After contacting my local Ford dealer thinking I could just buy a part vs. A whole manifold (like I was told I needed), I learned that there had been a recall for this problem and repairs were covered by Ford for only 7 years of auto's life. Well naturally, my car is 9 yrs old now and I'm facing a $1100.00 repair bill. I was told the manifold could rupture at any time leaving me and my 2 yr old grandson stranded at any time. I feel like Ford is holding me hostage. With the spitting and sputtering the car was doing, we could have been in a serious accident. I have always driven Ford/mercury products, but I'm not impressed with what's just happened. I don't want to be "found on road dead" (Ford).

NHTSA complaint #10292412
Oct 5, 2009engine and engine cooling

Spark plug blew out of the engine due to weak threading in the cylinder head. *tr

NHTSA complaint #10286321
Sep 9, 2008engine and engine cooling

2000 Ford Crown Victoria leaks coolant from the intake manifold. Consumer wants to know why the warranty is only seven years for this part. *nj

NHTSA complaint #10241551
Aug 27, 2007engine and engine cooling
Tl*the contact owns a 2000 Ford Crown Victoria. The vehicle was taken to the repair shop to have the brakes serviced. The repair shop stated that the vehicle had a recall and they made the repair. He did not know what recall was serviced or what part was replaced. The vehicle would not start after a year. The vehicle was taken to another repair shop who stated that the… Read more

Tl*the contact owns a 2000 Ford Crown Victoria. The vehicle was taken to the repair shop to have the brakes serviced. The repair shop stated that the vehicle had a recall and they made the repair. He did not know what recall was serviced or what part was replaced. The vehicle would not start after a year. The vehicle was taken to another repair shop who stated that the intake manifold kit, the ignition coil and spark plugs need to be replaced. The failure mileage was 76,375. The current mileage was 89,113.

NHTSA complaint #10200932
Dec 1, 2006engine and engine cooling

Dt*: the contact stated while driving 50 MPH, the vehicle hesitated and sputtered badly. The vehicle was taken to a service dealer, who determined that there was a crack in the manifold, and that the number 4 heater coil had failed.

NHTSA complaint #10174862
Sep 22, 2006engine and engine cooling

Dt*: the contact stated an independent service mechanic found a milky substance in the radiator coolant reservoir indicating a problem with the intake manifold. The engine temperature was running high as well. A service dealer offered to check for leaks, but informed the contact the warranty had expired.

NHTSA complaint #10168954
Jan 15, 2005engine and engine cooling
In january 2005, when my 2000 Ford Crown Victoria had 41573 miles on it, the heater fan failed to blow warm air. A local service garage in gaithersburg, md tested the system and determined that the blower control module had malfunctioned. The module was replaced (part #xw1h-19e624-ab, made in brazil, $95.88), and labor to replace the module brought the total bill to… Read more

In january 2005, when my 2000 Ford Crown Victoria had 41573 miles on it, the heater fan failed to blow warm air. A local service garage in gaithersburg, md tested the system and determined that the blower control module had malfunctioned. The module was replaced (part #xw1h-19e624-ab, made in brazil, $95.88), and labor to replace the module brought the total bill to $259.27. It should be noted that only 4000+ miles earlier the compressor and dryer had been replaced to provide cool air during the summer. *nm

NHTSA complaint #10106386
Jan 15, 2005engine and engine cooling
In june 2004, when my 2000 Crown Victoria had 37082 miles on it, the air conditioner failed to blow cold air; the vehicle was inspected by Ford quality care in gaithersburg, md, where it was determined that the problem was associated with the compressor and the dryer, both of which were replaced. The compressor (part #f3az-19v703-aarm - $391.59) and dryer (part… Read more

In june 2004, when my 2000 Crown Victoria had 37082 miles on it, the air conditioner failed to blow cold air; the vehicle was inspected by Ford quality care in gaithersburg, md, where it was determined that the problem was associated with the compressor and the dryer, both of which were replaced. The compressor (part #f3az-19v703-aarm - $391.59) and dryer (part #yw1z-19c836-aa - $139.30) along with other smaller parts were replaced for $543.12, and labor brought to total bill to $1010.62. I asked that the parts be returned, but was told they were core and could not be returned. Had the failure occurred 1083 miles earlier I assume it would have been covered under the warranty. *nm

NHTSA complaint #10106383
Jul 1, 2004engine and engine cooling

While pulling out of a parking space, a loud pop sounded and the vehicle stalled . The dealer stated the spark plug stripped out of the cylinder head. Please provide additional information. *jb

NHTSA complaint #10080282
Jun 24, 2004engine and engine cooling

While parked with the engine running smoke came from under the hood. Consumer notice water leaking out of the intake when opening the hood. This occurred because the intake cracked at the heater hose. Mechanic determined that the intake cracked because it was made out of plastic.*ak

NHTSA complaint #10079779
May 11, 2004engine and engine cooling

Plastic intake cracks at heater hose connection. This is a police car which can idle for long periods at a time.this condition leaks antifreeze into the well of the spark plug which causes a misfire,and the car overheats if not constantly watched.we have changed manifolds after calling Ford and we were told only a crack behind the alternator was under warranty.

NHTSA complaint #10072408
Jan 15, 2004steering, engine and engine cooling, power train
The engine in my 2000 Crown Victoria stalled at a stop sign, and I lost the power steering and power brakes. The car turned into a tank and could not be controlled. It was extremely scary because I could have hit some innocent people which would have meant another lawsuit for Ford. I had to put one foot on the brake and one foot on the accelerator to get the car to an auto… Read more

The engine in my 2000 Crown Victoria stalled at a stop sign, and I lost the power steering and power brakes. The car turned into a tank and could not be controlled. It was extremely scary because I could have hit some innocent people which would have meant another lawsuit for Ford. I had to put one foot on the brake and one foot on the accelerator to get the car to an auto service center. At 38,938 miles, the car needed a new idle speed control motor, air filter, and mass air flow sensor. I believe that these parts were defective and wrote a letter to william clay Ford, the chairman of Ford motor company. While the car was still under warranty, the overdrive switch had to be replaced because the warning light would not go off. I felt that there should have been no charge, but the dealer charged me $200 for labor. I believe that this car is an ontario-built monday morning lemon and will never buy another Ford automobile.

NHTSA complaint #10071183
Jan 15, 2003engine and engine cooling, electrical system, structure
Nar 01/15/2003. The idle air control motor failed which caused the vehicle not to idle and stall if the consume did not drive with one foot on the brake and the other on the accelerator. The dealer suggested replacing the part, but not under any warranty. The consumer discovered that if he taps on the componet it will work for awhile. Also the lower trim on the windshield… Read more

Nar 01/15/2003. The idle air control motor failed which caused the vehicle not to idle and stall if the consume did not drive with one foot on the brake and the other on the accelerator. The dealer suggested replacing the part, but not under any warranty. The consumer discovered that if he taps on the componet it will work for awhile. Also the lower trim on the windshield vibrated and the consumer had to place a card board box between the trim and the windshield to stop the noise. The right passenger window will not operate when the sun heats up and shines on that side of the vehicle when the vehicle is parked. The dealer inspected and greased the track, but the problem continued. The consumer believed it was an electrical issue, because as soon as the door cools off and is parked in the shade, the window operated fine. *jb

NHTSA complaint #10003862
Oct 1, 2002engine and engine cooling

The vehicle's engine is experiencing problems engine, consumer knows that there is a recall for the same year and model of her vehicle but is only on the police vehicles, she states that her vehicle has the same type of engine that the recalled engine has. Consumer has contact Ford for this information. Nlm *yh

NHTSA complaint #8019931
Jan 31, 2001engine and engine cooling

Over a period of time air conditioning panel has heated up. Panel gets very hot, no matter what setting it is on. Dealer says all vehicles do this, and it's nothing to be alarmed about. Consumer is getting a second opinion. *ak the control panel was replaced but the problem still exists. *yh

NHTSA complaint #879415
Nov 16, 2000suspension, engine and engine cooling

Vehicle experincing problem with excessive usages of oil. Replaced a quart of oil every 800 miles. Dealer / manufacturer notified, and informed that was normal. *ak the driver line is also out of balance. *yh

NHTSA complaint #875086
Sep 20, 2000engine and engine cooling

Oil is leaking from the cylinder heads and from the head gaskets, Ford replaced the engine which failed again within 500 miles, Ford refuses to replace the engine again. Nlm

NHTSA complaint #554815
← All 2000 Ford Crown Victoria problems & recalls