Nov 22, 2021service brakesCrash
When car is cold and just started to drive ,and brakes used ,the front brake does not apply and vehicle is slow to stop when ABS is disabled all brakes operate normal. I have hit 3 cars because brake did not work. This is a euro brake system installed on vehicles with frt disc and rear drum Dodge would not fix after several instances reported to them I have been driving… Read more
When car is cold and just started to drive ,and brakes used ,the front brake does not apply and vehicle is slow to stop when ABS is disabled all brakes operate normal. I have hit 3 cars because brake did not work. This is a euro brake system installed on vehicles with frt disc and rear drum Dodge would not fix after several instances reported to them I have been driving since new and many years with ABS disconnected and no accidents since I disconnected the control unit
NHTSA complaint #11441385
Nov 9, 2017service brakes
The brake line that runs on the frame rail from the front to the rear had a blow out directly behind the gas tank when pressing the break peddle to come to a complete stop in my driveway
NHTSA complaint #11044813
May 26, 2017service brakes
Rear brake line rusted and blew out causing the vehicle to loose all stopping power. The line blew out on the driver's side rear near the gas tank. Line is very corroded and this is a faulty manufacturers defect
NHTSA complaint #10991734
Feb 11, 2015steering, service brakes
The power steering pump failed while driving on a mountain road. I was unable to steer the truck, and also unable to stop the truck, as the power steering pump also supplies power to assist the brakes. *tr
NHTSA complaint #10682845
Oct 2, 2014structure, service brakesCrash
Brakes failed when applied. ABS and brake warning lights came on with very little braking. After hard braking application the tires locked and slid about 5 inches in damp backtop and hit a car stopped at a light. Had plenty of time to brake but no or very little braking action. Later inspection showed that one of the brake lines rusted through and lost pressure. This is… Read more
Brakes failed when applied. ABS and brake warning lights came on with very little braking. After hard braking application the tires locked and slid about 5 inches in damp backtop and hit a car stopped at a light. Had plenty of time to brake but no or very little braking action. Later inspection showed that one of the brake lines rusted through and lost pressure. This is the second time this has happened. These trucks are prone to brake line rusting. Driver seemed to be fine and drove away after exchanging info. He later claimed injury. *tr
NHTSA complaint #10640916
Oct 31, 2012service brakes
I was driving today and while coming up to a stop sign I applied my brakes only to find out I had none. The rear brake line that runs on the drivers side corroded really bad behind the gas tank and blew. Luckily there were no other vehicles around or else an accident could have happened. After doing some research, I find this is a very common problem on these vehicles. *tr
NHTSA complaint #10482810
Aug 29, 2012service brakesCrash
While moving forward from parked, the brake pedal went to the floor. The truck rolled into a fence. Upon inspection under the truck, brake fluid was covering the frame rail under the bed, behind the fuel tank. Upon researching the problem, it was discovered that multiple vehicles have experienced brake line corrosion in this same area. *tr
NHTSA complaint #10472861
Jul 24, 2012service brakes
The brake line that runs from the master cylinder to the rear brake on the drivers side has rotted out and busted. This is a common problem on these Dodge ram trucks . I have cars from the 1960's and the brake lines have not rusted at all and this truck is 11 years old. This happens a lot on these trucks and im sure this is not the first complaint against them. Maybe a recall… Read more
The brake line that runs from the master cylinder to the rear brake on the drivers side has rotted out and busted. This is a common problem on these Dodge ram trucks . I have cars from the 1960's and the brake lines have not rusted at all and this truck is 11 years old. This happens a lot on these trucks and im sure this is not the first complaint against them. Maybe a recall should be ordered. Thanks for your time. *tr
NHTSA complaint #10467567
Jul 8, 2012service brakes
I was driving and someone pulled out in front of me and stopped and I went to hit my brakes and they went completely out . It was the rear main brake line that runs behind the gas tank. The next time I was coming down a hill to a stop sign with some steel in the bed and a different brake line after the one behind the gas tank blew out and sent me through the stop sign. *tr
NHTSA complaint #10464644
Feb 26, 2012service brakes, hydraulic
Pulling out of my driveway my steel brake line on the frame broke at the rear coupling due to rust. This truck was driven on nj roads and never put a boat in water. *tr
NHTSA complaint #10449369
Feb 23, 2012service brakes, hydraulic
Driving my Dodge truck to work. The brake pedal went to the floor for no reason. Pads and fluid was ok when checked several weeks prior. Limped home on backup brake reservoir. Almost no brakes. Took it to a shop. They found that the brake line on the frame behind the tank (can't see it) was badly rusted and perforated at several spots on several lines. Replaced both… Read more
Driving my Dodge truck to work. The brake pedal went to the floor for no reason. Pads and fluid was ok when checked several weeks prior. Limped home on backup brake reservoir. Almost no brakes. Took it to a shop. They found that the brake line on the frame behind the tank (can't see it) was badly rusted and perforated at several spots on several lines. Replaced both lines. Current inspection (2/23/2012) shows brake lines in the engine compartment badly rusted between the ABS brake components. These will have to be replaced as well. *tr
NHTSA complaint #10449085
Sep 12, 2011service brakes, hydraulic
Under solid braking at 20 MPH the main hard line from the front to the rear brakes blew at the 45* bend next to the fuel tank. *tr
NHTSA complaint #10424762
Jun 28, 2011service brakes, hydraulic
Tl* the contact owns a 2001 Dodge RAM 2500. While driving approximately 20 MPH, the brake pedal traveled to the floor upon engagement. The brakes were pumped repeatedly before the vehicle would stop. The contact stated the rear drivers side brake line was completely covered with rust causing brake fluid to leak. The vehicle was towed his residence. The contact planned to… Read more
Tl* the contact owns a 2001 Dodge RAM 2500. While driving approximately 20 MPH, the brake pedal traveled to the floor upon engagement. The brakes were pumped repeatedly before the vehicle would stop. The contact stated the rear drivers side brake line was completely covered with rust causing brake fluid to leak. The vehicle was towed his residence. The contact planned to repair the brake line. The manufacturer was not notified of the defect. The approximate failure mileage was 95,000. The VIN was unavailable.
NHTSA complaint #10409242
Oct 25, 2010service brakes, hydraulic, structure
2001 Dodge RAM 2500 4x4, brake line directly behind gas tank above rear axle on the driver side rusts/corrodes which causes a major brake fluid leak and causes loss of brakes. This area is hidden from immediate sight by the spare tire and apparently buildup doesn't get washed away in the carwash or when it rains or from road spray etc. I have never seen brake lines rust so… Read more
2001 Dodge RAM 2500 4x4, brake line directly behind gas tank above rear axle on the driver side rusts/corrodes which causes a major brake fluid leak and causes loss of brakes. This area is hidden from immediate sight by the spare tire and apparently buildup doesn't get washed away in the carwash or when it rains or from road spray etc. I have never seen brake lines rust so bad. They actually look like they swell as they rust and scale. The rest of the vehicles undercarrage is 90% black paint from the factory, but the brake lines are rusting. Manufacturer should have used stainless steel brake line material or at least a coated type brakeline. Loss of brakes is a big safety issue. There should be no warranty period on something like this, they should be the last thing to go on the vehicle. There should be a paid in full recall before someone gets hurt or killed. *tr
NHTSA complaint #10362320
Aug 30, 2010service brakes, hydraulic
Tl*the contact owns a 2001 Dodge RAM 2500. The contact stated that while trying to slow down at a stop sign, the brake pedal extended to the floorboard and the vehicle continued to coast. He stated that the front brakes were enough to stop the vehicle; however, the contact inspected the vehicle and noticed that the rear brake line was completely corroded. The vehicle had not… Read more
Tl*the contact owns a 2001 Dodge RAM 2500. The contact stated that while trying to slow down at a stop sign, the brake pedal extended to the floorboard and the vehicle continued to coast. He stated that the front brakes were enough to stop the vehicle; however, the contact inspected the vehicle and noticed that the rear brake line was completely corroded. The vehicle had not been repaired at the time of the complaint. The manufacturer was not notified. The current and failure mileages were approximately 114,000.
NHTSA complaint #10352754
May 10, 2010service brakes, hydraulic
I started my truck to head out to answer a fire call (I am a volunteer firefighter). The engine was cold, had been sitting for over 8 hours. At the first stop sign, I pressed the brake pedal, only to have it go all the way to the floor with no resistance and no stopping power. The ABS and brake warning lights came on the dashboard. I pumped the brakes twice, and the… Read more
I started my truck to head out to answer a fire call (I am a volunteer firefighter). The engine was cold, had been sitting for over 8 hours. At the first stop sign, I pressed the brake pedal, only to have it go all the way to the floor with no resistance and no stopping power. The ABS and brake warning lights came on the dashboard. I pumped the brakes twice, and the system re-pressurized and started functioning correctly. I took the truck back home, and parked it for the weekend. Sunday pm I went to drive it over to the dealership, and when I started it up, the computer codes cleared and the truck functioned perfectly. According to the dealer, chrysler is aware of the problem, and it only occurs when the truck is cold and within the first 5 minutes after starting. The engineers have no idea why it is happening. Obviously, since I am a volunteer firefighter, I have a tendency to start my truck and go, so this issue is very worrisome to me. *tr
NHTSA complaint #10329742
Apr 9, 2010service brakes, hydraulic
Tl* the contact owns a 2001 Dodge 2500. The contact stated while driving at speeds of 25 MPH, he noticed brake fluid leaking from under the vehicle from the drivers side. The dealer advised the steel hydraulic pipeline had fractured due to rust and corrosion. The dealer also confirmed they were aware of the issue. The contact also wanted to include in the complaint that the… Read more
Tl* the contact owns a 2001 Dodge 2500. The contact stated while driving at speeds of 25 MPH, he noticed brake fluid leaking from under the vehicle from the drivers side. The dealer advised the steel hydraulic pipeline had fractured due to rust and corrosion. The dealer also confirmed they were aware of the issue. The contact also wanted to include in the complaint that the vehicle was manufactured in mexico. The approximate failure mileage was 79,000 and the approximate current mileage was 79,089. The VIN was not available.
NHTSA complaint #10324678
Mar 21, 2009service brakes, hydraulic
Ordered truck new. Has always been well maintained. Had the front left brakeline fail completely without warning. Never a drop of fluid leaked before it had an immediate and complete loss of braking. Very serious failure that normally does not happen in modern vehicles. *tr
NHTSA complaint #10262670
Mar 16, 2009service brakes, electricCrash
The ABS sensor wire was damaged by contact with the right wheel. This caused the ABS system to believe that the wheel was not turning and engaged the ABS system making it impossible to engage the brakes. Speed was approximately 10 MPH. This resulted in having to quickly engage the 2001 RAM 2500 into park. The truck crashed into the my garage door. If this happened in a… Read more
The ABS sensor wire was damaged by contact with the right wheel. This caused the ABS system to believe that the wheel was not turning and engaged the ABS system making it impossible to engage the brakes. Speed was approximately 10 MPH. This resulted in having to quickly engage the 2001 RAM 2500 into park. The truck crashed into the my garage door. If this happened in a traffic situation the results could have been very bad. If one of my children had been in the driveway this problem would have probably received more attention. This wire should not ever be able to come in contact with the wheel and the route is poorly planned. *tr
NHTSA complaint #10262069
Mar 7, 2007parking brakeCrash
Tl* the contact owns a 2001 Dodge RAM 2500. The vehicle was parked on a hill with the engine on, 30 seconds after exiting the vehicle it rolled backwards and crashed into a light pole. The parking brake was not engaged. The road conditions were clear. The dealer informed the contact that the vehicle must not have been in the park position. The current and failure mileage was 60,000. *ak
NHTSA complaint #10184460
Nov 20, 2003service brakes, hydraulicCrash1 injured
Driver stated that brakes failed on vehicle while trying to stop at intersection resulting in crash with another vehicle. *la
NHTSA complaint #10047241