CarProblemsDB

2002 Dodge RAM 1500 suspension problems

71 owners reported suspension problems — 9% of all 815 complaints about the 2002 Dodge RAM 1500.

Suspension complaints by Dodge RAM 1500 year

201029
200934
200849
200769
2006106
200582
200466
200357
200271
200169
200033

What owners report

Jul 13, 2023suspension, unknown or other

To put it as simple as I can describe it is a death wobble. That occurs every time you hit a bump in the road, hole, or pot hole. This truck has always had this death wobble from factory. The reason why this is a safety issue is because it causes the steering wheel to go out of balance and go into other lanes in the road and potentially cause an accident.

NHTSA complaint #11531959
Dec 6, 2018suspension, wheels

Tl* the contact owns a 2002 Dodge RAM 1500. While driving 75 MPH, the rear wheels seized and the vehicle slid off the road without warning. There was no crash. The dealer and manufacturer were not contacted. The vehicle was not diagnosed or repaired. The failure mileage was 107,000. The VIN was unknown.

NHTSA complaint #11156598
Apr 25, 2018suspension, structure

Tl* the contact owns a 2002 Dodge RAM 1500. The contact stated that there was extensive rust, corrosion, and holes along the entire frame and undercarriage of the vehicle. The contact stated that the frame was detaching due to the failure. The vehicle had not been inspected and diagnosed by a dealer. The manufacturer was notified of the failure. The approximate failure mileage was 118,000.

NHTSA complaint #11090087
May 4, 2017suspension
Tl* the contact owns a 2002 Dodge RAM 1500. While driving at an unknown speed, an abnormal clicking noise was heard from the rear of the vehicle, which caused the rear axle to cease. The vehicle was taken back to the contact's residence and the contact was able to rebuild and replace the rear axle. The vehicle was repaired; however, one month later, the pinion nut disconnected… Read more

Tl* the contact owns a 2002 Dodge RAM 1500. While driving at an unknown speed, an abnormal clicking noise was heard from the rear of the vehicle, which caused the rear axle to cease. The vehicle was taken back to the contact's residence and the contact was able to rebuild and replace the rear axle. The vehicle was repaired; however, one month later, the pinion nut disconnected and damaged the rear of the vehicle. The manufacturer was notified of the failure. The approximate failure mileage was 150,000.

NHTSA complaint #10983476
Sep 30, 2016suspension, structure
Tl* the contact owns a 2002 Dodge RAM 1500. While driving approximately 60 MPH, the front end of the vehicle shook and vibrated violently. After stopping the vehicle, it was discovered that the front sway bars detached and the steering control arms separated due to rusting of the subframe. The cause of the failure was not diagnosed. The vehicle was not repaired. The… Read more

Tl* the contact owns a 2002 Dodge RAM 1500. While driving approximately 60 MPH, the front end of the vehicle shook and vibrated violently. After stopping the vehicle, it was discovered that the front sway bars detached and the steering control arms separated due to rusting of the subframe. The cause of the failure was not diagnosed. The vehicle was not repaired. The manufacturer was not notified of the failure. The VIN was invalid. The failure mileage was 158,888.

NHTSA complaint #10910822
Mar 4, 2015steering, suspension
My son was on the I-5 coming home from school when the seals blew on the rack and pinion. Upon taking it to a repair shop we were informed that this is a known defect of the Dodge ram trucks and they are known to blow any where from 50,000-100,000 miles. If we had known about this defect we would not have purchased the truck. When the seals blew the truck steering components… Read more

My son was on the I-5 coming home from school when the seals blew on the rack and pinion. Upon taking it to a repair shop we were informed that this is a known defect of the Dodge ram trucks and they are known to blow any where from 50,000-100,000 miles. If we had known about this defect we would not have purchased the truck. When the seals blew the truck steering components began to grind and it was difficult to get it off the road. There was no warning and luckily my son had the opportunity to pull off the freeway with out injuring anyone. My father who has contracted with a local reservation contacted their service department only to find out that the Dodge ram trucks were known to have serious power steering and front end issues. The only reason they purchased the trucks were that Dodge provided the low bid and there has not been a government recall on the steering and their practice is to accept the low bid. The power steering. Tie rods and suspension are major components to going down the road safely. It shouldn't take someone dying to solve the issue. While we all are concerned about the impacts caused by larger vehicles against the new smaller lighter weight cars it is extremely important that we know the larger trucks are safe to drive on our roads. The Dodge ram has numerous complaints on the internet, as well as dealers and repair shops noting that this is an issue. Chevy trucks, ford trucks and toyota trucks do not have the reputation for have issues with

NHTSA complaint #10692132
Oct 17, 2014suspension, power train
While I was driving, my truck made a odd sound and then came to a screeching halt. To my surprise, the rear driveshaft had disconnected and fell out of my 2002 Dodge RAM 1500 truck. After having it towed and inspected by a mechanic, it was discovered the nut came off of the pinion gear. The axle and companion gear slipping out of the pinion gear and the yolk came completely… Read more

While I was driving, my truck made a odd sound and then came to a screeching halt. To my surprise, the rear driveshaft had disconnected and fell out of my 2002 Dodge RAM 1500 truck. After having it towed and inspected by a mechanic, it was discovered the nut came off of the pinion gear. The axle and companion gear slipping out of the pinion gear and the yolk came completely off. The mechanic was as concern and surprised as I was, considering this type of thing should not happen to a vehicle. I contacted chrysler via their customer service website and advised them of my situation. Sadly, I received a response stating there was no information regarding my issue. I conducted my own research about the possible defect, and found the NHTSA details regarding this problem with Dodge ram trucks. Currently, they are only reviewing 2008-2014 models. Considering my 2002 Dodge RAM 1500 has incurred the same problem, chrysler should recall all of their 2000 series for this defective part. I consider myself and others very lucky. If the driveshaft would have disconnected 10 minutes earlier while I was driving 70 MPH on the interstate. The incident could have been much worse. I'm fortunate, I had reached my exit and was driving 45 MPH with no vehicle behind me when my truck came apart and stopped. *tr

NHTSA complaint #10648397
Jun 12, 2014suspension
Tl* the contact owns a 2002 Dodge RAM 1500. The contact stated that while driving 30 MPH, the vehicle made a loud noise and within minutes the rear axle seized. The contact was able to control the vehicle and merged to the side of the road. After inspecting the vehicle, the contact noticed that the drive shaft had separated from the rear axle. The vehicle was towed to the… Read more

Tl* the contact owns a 2002 Dodge RAM 1500. The contact stated that while driving 30 MPH, the vehicle made a loud noise and within minutes the rear axle seized. The contact was able to control the vehicle and merged to the side of the road. After inspecting the vehicle, the contact noticed that the drive shaft had separated from the rear axle. The vehicle was towed to the contact home. The vehicle was not repaired. The failure and current mileage was mileage was 171,000.

NHTSA complaint #10597805
Nov 12, 2013suspension, power train

Our gears came apart, there was rear end fluid in there but the gears came apart. Which I was told what I needed to do before this happened, but I wasn't and now I am looking at a $4000 bill to get this fixed. Heard it was a common problem with these trucks to have rear end issues. *tr

NHTSA complaint #10551865
Mar 2, 2010suspension, wheelsCrash

2002 Dodge RAM 1500 wheel hub bearing assembly separation / wheel separation, while traveling at a speed of 35 -40 MPH on the highway, my vehicle began to shake and pull to the right and then the wheel right front wheel hub bearing assembly failed causing my vehicle to become disabled during a snow storm. *tr

NHTSA complaint #10315751
Jan 5, 2009steering, suspensionCrash
While driving to work early in the morning, roads were wet, temperature was 23 degrees. Was driving on a two lane roadway about 40 MPH. Was on a straight stretch when truck started to fish tail slightly. Rear of the truck slid slightly toward drivers side. I turned the wheels slightly in the direction of the slide and then started to turn the wheels back the other direction as… Read more

While driving to work early in the morning, roads were wet, temperature was 23 degrees. Was driving on a two lane roadway about 40 MPH. Was on a straight stretch when truck started to fish tail slightly. Rear of the truck slid slightly toward drivers side. I turned the wheels slightly in the direction of the slide and then started to turn the wheels back the other direction as truck started to straighten out. At that point I felt something give in the front end on the drivers side. The truck started pulling across the center line and off the other side of the road. I was heading straight for a telephone pole. I tried pushing the brakes fully, but the pedal went to the floor. I cut the wheels all the way to the right , just missing the telephone pole. My front fender struck a steel pole filled with cement next to a split rail fence. When I got out of the truck, the front drivers side tire was laying under the truck, only held on by the tie rod end. This was by no means a very bad case of sliding and over steering. The upper ball joint had just separated causing the tire to buckle under. I was lucky to have escaped this accident without injury or having my truck roll over. I have seen alot of problems with the Dodge durangos with the ball joint separation and I can only imagine it is the same suspension parts used in the Dodge RAM 1500 4x4 trucks. This needs to be checked into before someone gets killed. *tr

NHTSA complaint #10253777
Jul 19, 2007suspensionCrash

I have a 2002 dodgeram 1500 truck approx. 70,000 miles, the upper balljoint (passenger side) bearing failed, and caused undo stress on the lower balljoint causing it to brake. Causing the truck to pull to the right into a tree. *jb

NHTSA complaint #10196883
Jan 1, 2005suspension, air bags, structureCrash
While driving at interstate speed (70 MPH), and switching lanes while on a bridge, the excessive bouncing and bad suspension of truck make me lose control of the truck. The truck pulled to the right and the rear end of the truck ended up spinning around, making a complete 180--- on a bridge!! I ended up slamming into the safety rail of the bridge. And the air bags didn't go… Read more

While driving at interstate speed (70 MPH), and switching lanes while on a bridge, the excessive bouncing and bad suspension of truck make me lose control of the truck. The truck pulled to the right and the rear end of the truck ended up spinning around, making a complete 180--- on a bridge!! I ended up slamming into the safety rail of the bridge. And the air bags didn't go off. Luckily, I wasn't injured. At first I thought the accident was my fault, but after talking to a few owners of this model, I figured out that many of us have had the same problems with this truck. The question is, why is this problem not being fixed?? I have talked to the dealer, and they just keep referring me to dealers from other towns. *jb

NHTSA complaint #10104914
Oct 25, 2004suspension, service brakes, hydraulicCrash

While driving 40 MPH consumer applied the brakes and vehicle did not stop. The front wheel hub assembly broke on driver's side, causing the vehicle to flip.*ak

NHTSA complaint #10097660
Mar 27, 2004suspensionCrash4 injured

The rear right tire and assembly broke off my 2002 Dodge ram while my wife and children were on the freeway. This caused the vehicle to rollover. Apparently a problem with the axle. I understand there has been a recall for a weak weld on the rear axle bracket. I never got such recall on my vehicle.*ak

NHTSA complaint #10064013
Feb 19, 2003suspensionCrash

Traveling at around 70mph on i30 east mile 16 I hit a bump in the road causing the truck to sway uncontrollably and causing a spin out into the center divide. Weather was cloudy and road way was dry. Truck has always had a tendency to sway when hitting even the smallest bumps in the road this was the first time it was completely uncontrollable.

NHTSA complaint #10007795
← All 2002 Dodge RAM 1500 problems & recalls