Feb 13, 2026service brakes, hydraulicCrash1 injured
The contact owned a 2001 Dodge RAM 1500. The contact stated that while exiting a parking lot and attempting to depress the brake pedal, the brake pedal floored, causing the contact to roll to a stop on the side of the road. The ABS and brake warning lights illuminated. The contact was able to drive at 2 MPH to their home. The vehicle was towed to the dealer, who diagnosed that… Read more
The contact owned a 2001 Dodge RAM 1500. The contact stated that while exiting a parking lot and attempting to depress the brake pedal, the brake pedal floored, causing the contact to roll to a stop on the side of the road. The ABS and brake warning lights illuminated. The contact was able to drive at 2 MPH to their home. The vehicle was towed to the dealer, who diagnosed that the brake line had blown and replaced it where it had failed. Approximately 6 months later, the ABS and brake warning lights illuminated again. The contact inspected the vehicle and noticed no leaks. When restarting the vehicle, the warning lights were no longer illuminated. While driving at an unknown speed, the ABS and brake lights illuminated again. The vehicle was taken to meineke car care center to a certified mechanic. The following morning, the lights were not illuminated. The vehicle was returned to meineke car care center, who stated that it may have been a computer glitch causing the lights to illuminate, then turn off when the vehicle was restarted. The contact had the brakes replaced as routine maintenance; however, after doing so, while driving in the rain at approximately 25 MPH and attempting to apply the brakes, the brakes failed, causing the vehicle to rear-end the vehicle in front. The air bags did not deploy. The contact did not sustain injuries or require medical attention. The contact assumed the other driver had injuries, but could not confirm. A police report was filed. The conta
NHTSA complaint #11717773
Aug 7, 2017service brakes
Tl* the contact owns a 2001 Dodge RAM 1500. While driving 50 MPH, the brake pedal was depressed, but failed to respond. The vehicle was taken to an independent mechanic. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 200,000.
NHTSA complaint #11013526
Mar 16, 2017service brakes
The brake line leading to the driver rear tire is severely corroded. The entire line from the master cylinder to the wheel will have to be replaced. My 16 year old daughter was driving the truck when the brakes fell to the floor. It leaked the entire contents of the brake fluid out. The breaks did still function but barely. Enough to get it home.she was on a busy street in… Read more
The brake line leading to the driver rear tire is severely corroded. The entire line from the master cylinder to the wheel will have to be replaced. My 16 year old daughter was driving the truck when the brakes fell to the floor. It leaked the entire contents of the brake fluid out. The breaks did still function but barely. Enough to get it home.she was on a busy street in traffic when the brake petal went to the floor.
NHTSA complaint #10966378
Oct 28, 2016service brakes
Tl* the contact owns a 2001 Dodge RAM 1500. The contact stated that the brake system failed. While driving approximately 30 MPH and attempting to slow down, the brake pedal stuck to the floor board. The contact was able to coast the vehicle over to the shoulder, inspected the vehicle, and found that the rear brake lines fractured due to corrosion. The vehicle was not diagnosed… Read more
Tl* the contact owns a 2001 Dodge RAM 1500. The contact stated that the brake system failed. While driving approximately 30 MPH and attempting to slow down, the brake pedal stuck to the floor board. The contact was able to coast the vehicle over to the shoulder, inspected the vehicle, and found that the rear brake lines fractured due to corrosion. The vehicle was not diagnosed or repaired. The manufacturer was not notified. The approximate failure mileage was 62,800.
NHTSA complaint #10919864
Mar 17, 2016service brakes
Rear brake line heavily corroded and ruptured in between the fuel tank and the frame (very little corrosion to the surrounding parts/frame). Fortunately the vehicle was parked when the line broke and I noticed I had lost virtually all braking ability while attempting to put it in gear. I had driven it 10 minutes prior to the line failing, and had noticed no degradation whatsoever.
NHTSA complaint #10850137
Jul 27, 2015steering, electrical system, structure, service brakes
Tl* the contact owns a 2001 Dodge RAM 1500. While driving 30 MPH, the power steering failed. The vehicle had a past failure with the brakes, corrosion of the frame, a cracked dashboard, and warning indicators illuminating since 26,000 miles. The vehicle was repaired for these failures, but not for the steering failure. The manufacturer was made aware of the failures. The… Read more
Tl* the contact owns a 2001 Dodge RAM 1500. While driving 30 MPH, the power steering failed. The vehicle had a past failure with the brakes, corrosion of the frame, a cracked dashboard, and warning indicators illuminating since 26,000 miles. The vehicle was repaired for these failures, but not for the steering failure. The manufacturer was made aware of the failures. The failure mileage was approximately 41,000.....updated 01/04/2016 *bf
NHTSA complaint #10743865
Jul 15, 2015suspension, service brakes, hydraulic, structure
2001 Dodge ram. Consumer writes in regards to vehicle steering wheel vibration, brake line replacement and front frame problems. *smd updated 07/27/15.....updated 11/19/15 *bf updated 01/12/16*lj updated 11/08/2017*cn
NHTSA complaint #10733146
Jul 10, 2014service brakes
The rear brake line between the gas tank and frame blew out as my son was pulling in the driveway. According to the internet, this is a common problem with these trucks. *tr
NHTSA complaint #10609713
Jul 22, 2013service brakes
Tl* the contact owns a 2001 Dodge RAM 1500. The contact stated that the brakes failed and he had to utilize the emergency brake in order to stop the vehicle. The contact stated that the main brake lines had were completely rusted and failed. The vehicle had not been repaired. The VIN was not available. The failure and current mileages were 120,000. *tr
NHTSA complaint #10526121
Jun 1, 2013service brakes
Stopped at gas station, got back in truck brake light was on, added fluid, walking back to truck noticed puddle of fluid under truck, brake line had burst above fuel tank, major safety issue! *tr
NHTSA complaint #10514658
May 31, 2012service brakes
Traveling down drive way when hard brake line blow out, causing lose of brakes. *tr
NHTSA complaint #10460134
Jul 21, 2010service brakes, hydraulicCrash
On 8/19/2009, I was traveling east on rt 360 in chesterfield co, va in my 2001 Dodge 1500 pickup truck. As I approached the light at turner rd, I apply the brakes but the truck was not stopping as normal. I struck the nissan in front of me in the rear. Damage done to both vehicles but thankfully there were no injuries. It was later determined that the steel brake line that… Read more
On 8/19/2009, I was traveling east on rt 360 in chesterfield co, va in my 2001 Dodge 1500 pickup truck. As I approached the light at turner rd, I apply the brakes but the truck was not stopping as normal. I struck the nissan in front of me in the rear. Damage done to both vehicles but thankfully there were no injuries. It was later determined that the steel brake line that runs along the inside of the frame rail had burst causing the rear brakes to fail. The insurance company responded to the repair shop and inspected the old brake line. It appears from several Dodge forums that this is a common problem with some model years but Dodge refuses to address the issue. I believe this to be a very serious issue as the next victim may not be as lucky as I. *tr
NHTSA complaint #10344440
Dec 5, 2005service brakes, hydraulicCrash1 injured
When in panic stop brake pedal is hard , but brakes do not apply. Almost feels like sliding on ice, also had this happen on 91 dakota. *nm
NHTSA complaint #10144419
Apr 27, 2005steering, suspension, service brakes, hydraulicCrash1 injured
While driving at 40 MPH something under the 2001 Dodge ram malfunctioned resulting in the consumer loosing braking and steering ability. The vehicle went off an embankment and hit a tree. *mr *sc the consumer believed the problem may have been a ball joint or tie rod end. *jb
NHTSA complaint #10119251
Sep 8, 2003service brakes, air, electrical systemFire
1998-2001 b-van (Dodge full size). The ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this 10 ga. Wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or the relay sticks on these vans. Then one of the 14 ga. Wires overheats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire… Read more
1998-2001 b-van (Dodge full size). The ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this 10 ga. Wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or the relay sticks on these vans. Then one of the 14 ga. Wires overheats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then continues until the van is fully engulfed in flames. This van was bought back from us by chrysler corp. In 2002. The official fire investigation reports conducted by chrysler were never disclosed to us at verizon. *ak
NHTSA complaint #10037441
Jan 24, 2003service brakes, hydraulic, air bagsCrash
The vehicle was involved in a collision and the air bags failed to deploy. *ts consumer believed the brakes may have locked up.*jb
NHTSA complaint #10004620
Jan 23, 2002service brakes, hydraulic, power train1 injured
Per dealer service advisor, my trucks wheel sub-assembly was damaged from an over-torqued center nut (during manufacture assembly). This condition caused the bearings to seize and superheat, they have been cutting into the axle and the heat expansion caused the brakes to fail (locked on, but steering has not been pulling). Parts needing replacement include: axle; caliper; hub… Read more
Per dealer service advisor, my trucks wheel sub-assembly was damaged from an over-torqued center nut (during manufacture assembly). This condition caused the bearings to seize and superheat, they have been cutting into the axle and the heat expansion caused the brakes to fail (locked on, but steering has not been pulling). Parts needing replacement include: axle; caliper; hub and bearings; rotor; center nut; center cap.
NHTSA complaint #757215