May 26, 2015structure, service brakes
Tl* the contact owns a 2000 Dodge RAM 1500. While reversing at a low speed, the brake pedal was depressed but the vehicle failed to stop. The contact had to engage the emergency brake in order to stop the vehicle. In addition, the contact noticed that there was brake fluid leaking from underneath the vehicle. In addition, the contact stated that the dashboard fractured. The… Read more
Tl* the contact owns a 2000 Dodge RAM 1500. While reversing at a low speed, the brake pedal was depressed but the vehicle failed to stop. The contact had to engage the emergency brake in order to stop the vehicle. In addition, the contact noticed that there was brake fluid leaking from underneath the vehicle. In addition, the contact stated that the dashboard fractured. The vehicle was taken to an independent mechanic who diagnosed that the brake lines needed to be replaced. The vehicle was repaired; however, the failure recurred. The vehicle was taken back to the mechanic who diagnosed that the brake lines needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 89,000.
NHTSA complaint #10721446
Sep 16, 2014service brakes
Tl* the contact owns a 2000 Dodge RAM 1500. The contact stated that while driving at approximately 35 MPH and attempting to make a right turn, the front passenger wheel seized without warning. The vehicle was taken to the dealer where it was diagnosed that the anti lock braking system failed due to the aftermarket batteries installed in the vehicle leaking onto the ABS… Read more
Tl* the contact owns a 2000 Dodge RAM 1500. The contact stated that while driving at approximately 35 MPH and attempting to make a right turn, the front passenger wheel seized without warning. The vehicle was taken to the dealer where it was diagnosed that the anti lock braking system failed due to the aftermarket batteries installed in the vehicle leaking onto the ABS control module connector. Additionally, there was corrosion present from battery acid. The vehicle was not repaired. The manufacturer was notified of the failure and stated that the VIN was not included in NHTSA campaign: 04v185000 (service brakes, hydraulic). The approximate failure mileage was 100,000. The VIN was not available.
NHTSA complaint #10633749
Dec 2, 2013service brakes, hydraulic, equipment
2000 Dodge RAM 1500 extended cab 2 wheel anti-lock right caliper keeps stickin everything is new I've miss 2wks work cause of it and have been fired because of it I cant go 5 miles with out it stickin I keep takin the caliper back to 3 different part store and they getting pissed I have new shoes,rubber hose,brake booster rwal valve anti lock valve crystal clear fluid its… Read more
2000 Dodge RAM 1500 extended cab 2 wheel anti-lock right caliper keeps stickin everything is new I've miss 2wks work cause of it and have been fired because of it I cant go 5 miles with out it stickin I keep takin the caliper back to 3 different part store and they getting pissed I have new shoes,rubber hose,brake booster rwal valve anti lock valve crystal clear fluid its been to a brake shop and they r lost also im always on the side of road takin it apart to depress the caliper not sure if its a c body or not. *tr
NHTSA complaint #10554342
Mar 25, 2013service brakesCrash
Driving in the parking lot at work. Went to slow down to pull into a space and pedal dropped to the floor. I hit the office building as a result. The rear brake line by the gas tank blew. *tr
NHTSA complaint #10504490
Jul 25, 2012service brakes
I went to change my front pads (for the 3rd time in 15 months) and noticed that yet again, one of my calipers was stuck and one of the piston diaphrams was torn. I replaced the caliper, put in my new pads, bled the system, and my brake pedal goes all the way to the floor, the vehicle is driveable, but my stopping distance has greatly reduced. I have to pump the pedal 2-3 times… Read more
I went to change my front pads (for the 3rd time in 15 months) and noticed that yet again, one of my calipers was stuck and one of the piston diaphrams was torn. I replaced the caliper, put in my new pads, bled the system, and my brake pedal goes all the way to the floor, the vehicle is driveable, but my stopping distance has greatly reduced. I have to pump the pedal 2-3 times for the brakes to grab. If I stab on them, them pedal will travel all the way to the floor and then the rear wheels will lock up and the front brakes dont work at all. I replaced the master cylinder and the problem still persists. Dealership has absolutely no idea what the problem could be, and niether do any of the local shops. *tr
NHTSA complaint #10467709
Jun 16, 2010service brakes, hydraulic
2000 Dodge RAM 1500 -dec 2009 - 47000 mile. No indication of brake issues until hitting them hard to avoid car that ran a red light. Brake line from master cylinder to rwal unit failed (pinhole leak), but managed to avoid collision. Drove home (slowly) and fabricated/installed replacement section (about 16" long). After bleeding brakes - drove truck normally until june 2010.… Read more
2000 Dodge RAM 1500 -dec 2009 - 47000 mile. No indication of brake issues until hitting them hard to avoid car that ran a red light. Brake line from master cylinder to rwal unit failed (pinhole leak), but managed to avoid collision. Drove home (slowly) and fabricated/installed replacement section (about 16" long). After bleeding brakes - drove truck normally until june 2010. Then, with no warning, the brakes again failed in a parking lot stop. Found the leak in the rear section of the line running from front to rear.dealer estimate to replace all hard lines is $1000. Who can afford that ?? So, I will be spending many hours of my own time to fix the problem caused by cheap imported chinese steel. Thanks bill clinton !! I have other "good american cars" that are 40+ years old and 100k+ miles with the oem lines still good. These new vehicles suck !!! *tr
NHTSA complaint #10336724
Aug 18, 2009service brakes, hydraulic
The brake line on drivers side behind the gas tank burst due to corrosion I lost brakes while driving not able to stop well. Could cause injury. *tr
NHTSA complaint #10280793
Aug 13, 2009service brakes, hydraulic
Brake line behind the gas tank on drivers side burst due to corrosion on my 2000 Dodge RAM 1500 4x4. *tr
NHTSA complaint #10280396
Jun 22, 2009service brakes, hydraulic
Tl*the contact owns a 2000 Dodge 1500. While driving 40 MPH, the air idle valve did not open and caused the vehicle to stall when the brakes were applied. The contact believes that there is a defect in the design of the vehicle. The air idle valve was installed backwards and should remain in the open position to allow air to enter and for the vehicle to properly close. The… Read more
Tl*the contact owns a 2000 Dodge 1500. While driving 40 MPH, the air idle valve did not open and caused the vehicle to stall when the brakes were applied. The contact believes that there is a defect in the design of the vehicle. The air idle valve was installed backwards and should remain in the open position to allow air to enter and for the vehicle to properly close. The failure occurred on two occasions. The contact took the vehicle to the dealer and they replaced the valve, which was installed in the same manner. The repair lasted for a year, but the failure has recently resurfaced. The VIN was unknown. The failure mileage was 100,000 and current mileage was 112,000.
NHTSA complaint #10274615
Nov 21, 2008service brakes, hydraulic
Tl*the contact owns a 2000 Dodge RAM 1500. While pulling out of the driveway, the contact noticed that the brakes felt low. He also noticed that the brake hose assembly was leaking brake fluid from the front brakes. The VIN was not included in NHTSA campaign id number 01v038000 (service brakes, hydraulic foundation components: hoses, lines piping, and fittings); therefore,… Read more
Tl*the contact owns a 2000 Dodge RAM 1500. While pulling out of the driveway, the contact noticed that the brakes felt low. He also noticed that the brake hose assembly was leaking brake fluid from the front brakes. The VIN was not included in NHTSA campaign id number 01v038000 (service brakes, hydraulic foundation components: hoses, lines piping, and fittings); therefore, they would not assist with the repair. The vehicle is currently parked at the contact's residence. The failure and current mileages were 70,089. Updated 04-17-09 updated 04/20/09.*jb
NHTSA complaint #10249513
Sep 8, 2003service brakes, air, electrical systemFire
1998-2001 b-van (Dodge full size). ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or the relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then… Read more
1998-2001 b-van (Dodge full size). ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or the relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then continues until the van is engulfed in flames. This van is located at the verizon repair garage 6720 ammendale rd., beltsville, maryland. *ak
NHTSA complaint #10037431
Sep 8, 2003service brakes, air, electrical systemFire
1998-2001 b-van (Dodge full size). The ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then… Read more
1998-2001 b-van (Dodge full size). The ABS control module is protected with a 40 amp fuse. A 10 ga. Wire comes out of the control module, then this wire "y's" out to two 14 ga. Wires. It appears as though the ABS pump or relay sticks on these vehicles. Then one of the 14 ga. Wires over heats and catches the wiring harness on fire. The 40 amp fuse does not blow. The fire then continues until the entire van is fully engulfed in flames. This van is at burlington Dodge. 90 middlesex turnpick burlington, mass 01803. *ak
NHTSA complaint #10037430
Jun 1, 2001service brakes, hydraulic, engine and engine coolingFire
Engine fire, investigator located a blown ABS fuse as well, claim 04-1283-455. *slc
NHTSA complaint #6900561