Jan 2, 2021electrical system, wheels, service brakes
The front calipers will not engage when brake pedal is pressed. The brake pedal sinks to the floor and has no stopping power. The master cylinder was replaced and calipers are new replacements. After replacing these parts it now smell of burnt brake fluid but there is no leak and the problem seems to worsen. The first time I was doing 45-50 on a county rd when a another car… Read more
The front calipers will not engage when brake pedal is pressed. The brake pedal sinks to the floor and has no stopping power. The master cylinder was replaced and calipers are new replacements. After replacing these parts it now smell of burnt brake fluid but there is no leak and the problem seems to worsen. The first time I was doing 45-50 on a county rd when a another car pulled out 20 feet away and I was trying to slow down when I lost the front brakes as pished in on the pushed in on the brakes the pedal sank and they didn't engage. I then bought the new calipers and it was fine for about a month. The second time I was stuck in traffic on a busy city street when the ABS brakes failed resulting in me running a red light and almost getting hit. It has corroded and took hunks off aluminum from my front driver rim. I have not been able to figure out what the problem and keep replacing parts for it to tear up new ones
NHTSA complaint #11386118
Jun 28, 2019suspension, power train, structure, service brakes
Tl* the contact owns a 2008 Dodge Caliber. While driving, the contact heard a loud noise. The contact later discovered that the subframe was rusted through and caused the front driver's side axle to fracture. Also, the top of the driver's side wheel was tilted inward. The vehicle was towed to an independent mechanic and the axle, subframe, one of the brakes, and the… Read more
Tl* the contact owns a 2008 Dodge Caliber. While driving, the contact heard a loud noise. The contact later discovered that the subframe was rusted through and caused the front driver's side axle to fracture. Also, the top of the driver's side wheel was tilted inward. The vehicle was towed to an independent mechanic and the axle, subframe, one of the brakes, and the transmission fluid line were replaced. The dealer was not contacted. The contact called the manufacturer and was transferred to NHTSA. The failure mileage was 112,850.
NHTSA complaint #11223181
Aug 3, 2018electrical system, service brakes
Tl* the contact owns a 2008 Dodge Caliber. While driving 70 MPH, the radio and dome light automatically turned on and the vehicle stalled. In addition, the brake pedal had to be depressed extremely hard for the vehicle to stop and multiple unknown warning indicators illuminated. The contact called chrysler Dodge jeep ram greensboro (3710 w wendover ave, greensboro, nc 27407,… Read more
Tl* the contact owns a 2008 Dodge Caliber. While driving 70 MPH, the radio and dome light automatically turned on and the vehicle stalled. In addition, the brake pedal had to be depressed extremely hard for the vehicle to stop and multiple unknown warning indicators illuminated. The contact called chrysler Dodge jeep ram greensboro (3710 w wendover ave, greensboro, nc 27407, (336) 790-9850), but the vehicle was not diagnosed or repaired. The manufacturer was not notified. The failure mileage was unknown.
NHTSA complaint #11115596
May 24, 2017unknown or other, service brakes, engine
There are currently 0 recalls on the 2008 Dodge Caliber 2.0. However, a simple youtube search will bring up common issues with the lower ball joints, which cause extreme tire wear and even severe pulling to the left and right with very little control. The anti-lock breaking system as well as the throttle body are huge issues as well. However, it wasn't a youtube search that… Read more
There are currently 0 recalls on the 2008 Dodge Caliber 2.0. However, a simple youtube search will bring up common issues with the lower ball joints, which cause extreme tire wear and even severe pulling to the left and right with very little control. The anti-lock breaking system as well as the throttle body are huge issues as well. However, it wasn't a youtube search that brought this to my attention but instead driving one and looking into it. To my surprise there are zero recalls on this vehicle.
NHTSA complaint #10991328
Sep 13, 2016suspension, service brakes
Tl* the contact owns a 2008 Dodge Caliber. After the vehicle underwent a routine oil change and tune up, the vehicle made an abnormal noise when the brake pedal was depressed. The dealer was notified of the failure more than once and provided no solution. In addition, when driving over un-leveled land, the vehicle continued to make an abnormal noise and the suspension was… Read more
Tl* the contact owns a 2008 Dodge Caliber. After the vehicle underwent a routine oil change and tune up, the vehicle made an abnormal noise when the brake pedal was depressed. The dealer was notified of the failure more than once and provided no solution. In addition, when driving over un-leveled land, the vehicle continued to make an abnormal noise and the suspension was unstable from the front to the rear. The contact was unable to determine if the dealer would provide a remedy. The manufacturer was not notified. The failure mileage was not available.
NHTSA complaint #10906195
Mar 2, 2016suspension, service brakes, engine
I bought my car in 2009, ran great at first until I hit over 100 thousand miles. I was on my way out of town to see a family member in the hospital. It was 80 degrees out and my car just slowed down on the highway and came to a stop. I thought it overheated so I waited about 30 mins and started it up again. Today I was at the Dodge dealership to have them look at it, to… Read more
I bought my car in 2009, ran great at first until I hit over 100 thousand miles. I was on my way out of town to see a family member in the hospital. It was 80 degrees out and my car just slowed down on the highway and came to a stop. I thought it overheated so I waited about 30 mins and started it up again. Today I was at the Dodge dealership to have them look at it, to find out why the passenger side front tire was making a noise(like it was going to fall off). They told me it was the controll arm and that I needed to replace it. Apparently I'm not the only one having these issues. Where's the recall Dodge?
NHTSA complaint #10839592
Feb 5, 2016power train, service brakes
I was turning onto a state highway when my brakes made the most awful grinding noise and my ABS brake light came one. I immediately took my vehicle to the mechanic. I was told by my mechanic my brakes were bad and rotors needed to be replace and there was a sensor that had to be ordered before I could use the car after it was repaired. It had 11,000 miles!! I doubt my… Read more
I was turning onto a state highway when my brakes made the most awful grinding noise and my ABS brake light came one. I immediately took my vehicle to the mechanic. I was told by my mechanic my brakes were bad and rotors needed to be replace and there was a sensor that had to be ordered before I could use the car after it was repaired. It had 11,000 miles!! I doubt my brakes were even bad at that point I think it was just a sensor after all. (after it cost me $480.00 plus I had to rent a car for 3 days. My transmission kept surging at the stop lights from the day I got it at 1,471 miles. So it was probably bad from day one. I should have taken it right back to where I bought it, at least it would have been under warranty. I had my transmission replaced at 30,000 miles at a cost of $6,000.
NHTSA complaint #10824514
Sep 20, 2015steering, power train, service brakes
Found that the engine cradle is rusting out. This cradle supports all steering front suspension and engine/transmission. Have also found that this was a problem for the 2007 models and is still a problem on 2008 models. Although 2007 models are recalled and replaced but not 2008. This is a huge safety factor as stated all steering and suspension are connected to this cradle.… Read more
Found that the engine cradle is rusting out. This cradle supports all steering front suspension and engine/transmission. Have also found that this was a problem for the 2007 models and is still a problem on 2008 models. Although 2007 models are recalled and replaced but not 2008. This is a huge safety factor as stated all steering and suspension are connected to this cradle. If failure to cradle happens all loss of control of vehicle is inevitable.
NHTSA complaint #10765342
Sep 10, 2015suspension, wheels, service brakes
Owned the car for almost 4 years. Tie rods have been replaced 3 times. Recently had to replace, struts, ball joints, brakes on the front for the 5th time, back breaks are out and rotors as well had them replaced less than a year ago. Manifold had to be replaced. Barrings on the front and one on the right back. Went through a set a tires in less than 6 months. Has been to Dodge… Read more
Owned the car for almost 4 years. Tie rods have been replaced 3 times. Recently had to replace, struts, ball joints, brakes on the front for the 5th time, back breaks are out and rotors as well had them replaced less than a year ago. Manifold had to be replaced. Barrings on the front and one on the right back. Went through a set a tires in less than 6 months. Has been to Dodge and other mechanics problems still persist.
NHTSA complaint #10762967
Aug 24, 2015suspension, service brakes
Tl* the contact owns a 2008 Dodge Caliber. The contact stated that the vehicle swerved and made a clicking sound while driving. The vehicle was taken to the dealer where it was diagnosed that the front ball joint and the lower control arm failed. The vehicle was repaired but the failure recurred. The vehicle was taken back to the dealer where an alignment was performed but… Read more
Tl* the contact owns a 2008 Dodge Caliber. The contact stated that the vehicle swerved and made a clicking sound while driving. The vehicle was taken to the dealer where it was diagnosed that the front ball joint and the lower control arm failed. The vehicle was repaired but the failure recurred. The vehicle was taken back to the dealer where an alignment was performed but failed to correct the failure. The contact also stated that the brake system failed. The brake emitted a metal grinding noise when the brake pedal was engaged. The dealer inspected the brake system and found corrosion on the brake lines the corrosion was removed from the brake lines however, the failure was not corrected. The manufacturer was notified of the failure. The failure mileage was 133,833. Ma 10/15/2015 *cn
NHTSA complaint #10758841
Nov 18, 2012electrical system, service brakes, engineCrashFire
I was on my way to work, headlights and dash lights started to flicker, all the indicator light on the dash came on. Smoke started coming in the vents into the vehicle went to stop, brakes grabbed for a second then went out completely, even shifting the vehicle to park did nothing. Stopped the vehicle by hitting guard rail called police, within minutes the entire front end was in flames. *tr
NHTSA complaint #10485042
Jan 29, 2010service brakes, hydraulicCrash
Tl*the contact owns a 2008 Dodge Caliber. While attempting to exit his driveway in snowy conditions at speeds of less than 3 MPH, the brakes locked and caused the vehicle to slide in the snow and crash into a vehicle in the contact's driveway. There were no injuries. Neither the dealer nor manufacturer were contacted. The contact was awaiting repairs by his insurance company.… Read more
Tl*the contact owns a 2008 Dodge Caliber. While attempting to exit his driveway in snowy conditions at speeds of less than 3 MPH, the brakes locked and caused the vehicle to slide in the snow and crash into a vehicle in the contact's driveway. There were no injuries. Neither the dealer nor manufacturer were contacted. The contact was awaiting repairs by his insurance company. The failure and current and failure mileages were under 35,222.
NHTSA complaint #10303250
Jan 28, 2009service brakes, electricCrashFire
My husband and cousin were in this car some how lost control on a clear dry day and rolled. They say the brakes were never applied but I wonder why not, maybe there was a problem with this car. *tr
NHTSA complaint #10256657
Oct 22, 2008service brakes, hydraulic, air bagsCrash
I was traveling to a t intersection; I was the one who was required to make the left or right hand turn. My brakes stopped working and I went from ~55mph to 45mph over the course of a football field or so. I should have been able to stop completely but that wasn't the case. It was the 2008 Caliber srt4. The srt4 has a massive brake kit from the charger and magnum on it which… Read more
I was traveling to a t intersection; I was the one who was required to make the left or right hand turn. My brakes stopped working and I went from ~55mph to 45mph over the course of a football field or so. I should have been able to stop completely but that wasn't the case. It was the 2008 Caliber srt4. The srt4 has a massive brake kit from the charger and magnum on it which should have made it stop relatively quickly. I mashed my vehicle into another vehicle at the intersection and my airbags did not deploy. I believe there is something wrong with the brakes and airbags on the 2008 Caliber srt4. *tr
NHTSA complaint #10246329