CarProblemsDB

2018 Chrysler Pacifica suspension problems

20 owners reported suspension problems — 2% of all 902 complaints about the 2018 Chrysler Pacifica.

Suspension complaints by Chrysler Pacifica year

20261
20232
20221
20212
20204
20195
201820
201725
20161
20089
200724
200686
2005187
2004125

What owners report

Jul 16, 2026suspension
My 2018 Chrysler Pacifica hybrid has developed a progressively worsening creaking noise from the front left suspension. It began two years ago occurring only occasionally when accelerating from a full stop or exiting a driveway, and has since become constant under most normal driving conditions including acceleration, deceleration, and slow turns in either direction. The… Read more

My 2018 Chrysler Pacifica hybrid has developed a progressively worsening creaking noise from the front left suspension. It began two years ago occurring only occasionally when accelerating from a full stop or exiting a driveway, and has since become constant under most normal driving conditions including acceleration, deceleration, and slow turns in either direction. The vehicle has approximately 35,000 miles and has been driven exclusively on regular paved roads with no off-road or unusual use. The pattern of gradual degradation on a low mileage vehicle suggests a corroding or deteriorating structural component rather than impact damage. An authorized Chrysler dealership recommended replacing both lower control arms at approximately $3,300, framing this as necessary to continue diagnostics rather than a confirmed repair. No specific component was isolated as the cause. This is directly relevant to recall v15 (NHTSA 19v143000), issued for right front lower control arm ball joint separation on 2018 Pacifica and Pacifica hybrid vehicles, which could cause loss of directional control without prior warning. My vehicle was excluded from that recall despite exhibiting similar symptoms on the left side. Two documented owner reports establish safety relevance. A mechanic warned an owner that their left ball joint should be replaced or risk failure while driving, leaving them unable to steer ([xxx]). Separately, an owner reported control arm bolts falling out causing the vehicle to

NHTSA complaint #11750884
Apr 21, 2026steering, suspension, wheels
My 2018 Pacifica hybrid suffered a catastrophic suspension separation while driving—the exact failure described in safety recall v15. The driver fortunately arrived at home safely only seeing smoke coming out form the tire rubbing against the wheel hood. Although my VIN isn't showing as 'active,' this is clearly a safety defect. I would like to open a case for a goodwill… Read more

My 2018 Pacifica hybrid suffered a catastrophic suspension separation while driving—the exact failure described in safety recall v15. The driver fortunately arrived at home safely only seeing smoke coming out form the tire rubbing against the wheel hood. Although my VIN isn't showing as 'active,' this is clearly a safety defect. I would like to open a case for a goodwill repair or a 'special policy' adjustment because this is a known dangerous failure.

NHTSA complaint #11732649
Oct 20, 2025steering, suspension

When taking turns the steering "sticks" amd it takes extra physical force to "unstick" the car. While unsticking by turning the steering wheel harder than normal, it either crosses into uncoming traffic or runs off the shoulder. It unsticks but with the extra physical force, it generally causes you to over correct and/or swerve/veer all over the roadway. 2018 with 72k miles

NHTSA complaint #11694637
Nov 1, 2019steering, suspension, wheelsCrash
I was driving in my 2018 Chrysler Pacifica on a rural street when it suddenly felt like the front passanger side tire had blown out. The car was difficult to control & and pulled to the right, pushing up against the curb. The car started to smoke and would not turn off. Concerned it was going to go on fire, my daughter & I ran out. When we were out of the car I saw that the… Read more

I was driving in my 2018 Chrysler Pacifica on a rural street when it suddenly felt like the front passanger side tire had blown out. The car was difficult to control & and pulled to the right, pushing up against the curb. The car started to smoke and would not turn off. Concerned it was going to go on fire, my daughter & I ran out. When we were out of the car I saw that the front axle connecting the tire had come completely disconnected and dropped to the street while driving. I called 911 for help. The firemen arrived first. The car was still revving & smoking but they were unable to shut it manually so they had to lift the hood & cut the wires. The police arrived & investigated the area. They showed me the gauge mark from where the tire axle dropped in the middle of street which was behind where the car stopped against the curb. There were zero interferences in the area (pothole, debris, signs, railguards etc.). It was a smooth street with a low, gradual curb. The officer told me that it was not my fault & due to a mechanical failure on the car. He wrote that in his report as well as on the notepad paper with his info & phone # to give the the dealership. 2 2018 recalls that may explain the problem, even though my VIN is not affected - which I would like further inspected, so I'm contacting the NHTSA to hopefully expand the recall VIN #s. *2018 Chrysler Pacifica recall, the front-axle half-shafts may have been incorrectly assembled, preventing the shaft from being pr

NHTSA complaint #11277493
← All 2018 Chrysler Pacifica problems & recalls