Dec 18, 2016electrical system, visibility/wiper
I had just driven to the local walmart to get supplies before the freezing rain and ice got here. It was 15:50, about an house before the friday night after work christmas rush would be rushing home. After starting my truck, and letting it warm a little so the heat from defroster would melt the ice and clear the fog on the windows which enables me to drive safely. It is also… Read more
I had just driven to the local walmart to get supplies before the freezing rain and ice got here. It was 15:50, about an house before the friday night after work christmas rush would be rushing home. After starting my truck, and letting it warm a little so the heat from defroster would melt the ice and clear the fog on the windows which enables me to drive safely. It is also against state law to drive with unclear windows. Well, to make a long story short, my 5 speed manual select blower switch does nothing. When I bought the truck, I told them speeds 4 and 5 don't work. I know from past experience that the resistors can go out. They would not fix. Well now, all are out. I managed to get a little hot air on windshield but decided it was unsafe to drive and returned to get truck the next day. After googling "blower motor fan relay switch" I was amazed at how many people have had this problem for decades. Before I retired, I worked for at&t as a technician. We deal with corroded wires and electronic equipment damaged by water on a daily basis. After removing the resister module, it was very obvious it was damaged by water. Not only that, it was designed to be protected from water by having two seals, one foam, one rubber built into it. Of course these were probably placed into the module by a machine because you could they didn't fit properly into the slots they were designed to fit it. Not only that, the wires that were suppose to be sodered (sp) to the resistors must have bee
NHTSA complaint #10936029
Feb 4, 2014electrical system, visibility
With the heater on high (setting 5), the fan stopped blowing heat. I then set the blower to setting 4, and the fan worked fine. As soon as I then put the fan back to 5, I would hear a click but the fan would not work at all. I then began to fiddle around with the connector that is under the passenger side dash which powers the fan. If I move the one wire around, the fan would… Read more
With the heater on high (setting 5), the fan stopped blowing heat. I then set the blower to setting 4, and the fan worked fine. As soon as I then put the fan back to 5, I would hear a click but the fan would not work at all. I then began to fiddle around with the connector that is under the passenger side dash which powers the fan. If I move the one wire around, the fan would intermittently work while on setting 5. I unplugged this connector from the blower motor, noticed that the one wire seems as if it was causing a short (the wire was somewhat black from over current). I removed the pin from the connector, recrimped and soldered it. Worked fine until a few weeks ago when the fan once again began to stop only on setting 5. I am assuming that the problem is once again the connector that goes to the blower motor powering the fan resistor. I saw a few reports of this on here about vehicle fires all of which point to this connection being bad. So I thought I would submit this as well due to the vast amount of issues I have had with this truck. *tr
NHTSA complaint #10562846
Jan 24, 2014electrical system, visibility
The heater blower would not turn off which drained the battery. Now both parts need to be replaced. According to Chevrolet, this part was a recall item if made from a certain manufacture. Apparently, our part was a different manufacturer which is why we didn't get the recall notice. Since our part failed, perhaps, it is a design defect or the other manufacturers were… Read more
The heater blower would not turn off which drained the battery. Now both parts need to be replaced. According to Chevrolet, this part was a recall item if made from a certain manufacture. Apparently, our part was a different manufacturer which is why we didn't get the recall notice. Since our part failed, perhaps, it is a design defect or the other manufacturers were delinquent during the assembly process as well. Please investigate to see if we may qualify for a recall on this part. *tr
NHTSA complaint #10561368
Mar 20, 2013visibilityFire
Tl* the contact owns a 2005 Chevrolet Silverado 1500. The contact was driving approximately 35 MPH with the heater activated when he noticed a burning odor coming from the connector for the heater blower. The vehicle was maneuvered to the side of the road where the engine was turned off as the contact inspected the heater blower, which he discovered was melted. The vehicle… Read more
Tl* the contact owns a 2005 Chevrolet Silverado 1500. The contact was driving approximately 35 MPH with the heater activated when he noticed a burning odor coming from the connector for the heater blower. The vehicle was maneuvered to the side of the road where the engine was turned off as the contact inspected the heater blower, which he discovered was melted. The vehicle was not taken to the dealer. The manufacturer was not notified of the failure. The VIN was unavailable. The failure mileage was 88,000.
NHTSA complaint #10503808
Apr 28, 2010electrical system, visibilityFire
The electrical connector for the hvac blower motor resistor caught fire and melted on my 2005 Chevrolet silverado k1500 w/t. *tr
NHTSA complaint #10327836
Sep 24, 2009electrical system, visibility, equipmentFire
2005 chevy 1500 silverado - heater blows hot air on drivers side, cold on passenger side - happens without notice - have spent around $300.00 (+) dollars trying to fix this. Was told by GM service tech it was the heater motor resistor wiring harness, it burns out the resistor. I replaced both, the resistor burned out again and the wiring harness was fried again. The internet… Read more
2005 chevy 1500 silverado - heater blows hot air on drivers side, cold on passenger side - happens without notice - have spent around $300.00 (+) dollars trying to fix this. Was told by GM service tech it was the heater motor resistor wiring harness, it burns out the resistor. I replaced both, the resistor burned out again and the wiring harness was fried again. The internet is full of these reports - a recall is needed - this condition is not safe. Thank you for your help. *tr
NHTSA complaint #10285115
Aug 5, 2009electrical system, visibilityFire
While parked the blower motor for the climate system continued to run. The keys were removed, engine off. Upon discovery I could not turn off the blower. I decided to take it to a shop. Before I could leave the parking lot the cab was full of a thick white smoke. I was able to shut the engine off and disconnect the battery before a fire started. The dealership said it… Read more
While parked the blower motor for the climate system continued to run. The keys were removed, engine off. Upon discovery I could not turn off the blower. I decided to take it to a shop. Before I could leave the parking lot the cab was full of a thick white smoke. I was able to shut the engine off and disconnect the battery before a fire started. The dealership said it was a common problem. There is no recall on it though as the dealer is not reporting the occurrences to GM so nobody is aware of the frequency. An easy internet search returns many occurrences of similar problems. *tr
NHTSA complaint #10279517
Jul 13, 2009electrical system, visibilityFire
Tl*the contact owns a 2005 Chevrolet Silverado 1500. The contact stated that the heating circuits under the dashboard were heating up excessively and would crackle and sparkle. There were no recalls for this failure. The manufacturer would not assume liability for the failure. The contact was concerned that a fire could occur. He also stated that the heater and defroster… Read more
Tl*the contact owns a 2005 Chevrolet Silverado 1500. The contact stated that the heating circuits under the dashboard were heating up excessively and would crackle and sparkle. There were no recalls for this failure. The manufacturer would not assume liability for the failure. The contact was concerned that a fire could occur. He also stated that the heater and defroster were inoperable. The failure and current mileages were less than 22,588.
NHTSA complaint #10276520
Jul 6, 2009electrical system, visibilityFire
The wiring harness to the blower motor resistor in my 2005 Chevrolet started smoking, from excess heat within the wiring to the harness or resistor. I have since replaced the harness and resistor, but it still does the same thing. Hopefully this faulty wiring harness is the only one in these models. *tr
NHTSA complaint #10275819
Jan 9, 2009visibilityFire
2005 chevy Silverado 1500 caught on fire on our driveway, smoke came up through defogger vent and within seconds flames came from under dash, truck burned in minutes. *tr
NHTSA complaint #10254349
Oct 2, 2008visibilityFire
2005 Chevrolet Silverado 1500. Smell from heater/A/C blower. First told blower motor. Upon closer examination found that blower motor was ok but resistor and wiring harness had melted/burned. Damage was local to harness and resistor. Dealer will not cover damage. Service bulletin exist but will not help pay. *tr
NHTSA complaint #10244230