While driving on the highway on us route 15 the transmission let loose. Doing 55mph and lost drive and 3rd gears. Fluid and parts were spread all behind my truck causing a dangerous situation.
2001 Chevrolet Silverado 1500 transmission problems
19 owners reported transmission & powertrain problems — 4% of all 468 complaints about the 2001 Chevrolet Silverado 1500.
Transmission & powertrain complaints by Chevrolet Silverado 1500 year
What owners report
Evaporated system.
Tranny, ABS, cooling system, tailgate, etc. I bought the truck 2003 didn't exchange title until later recall when I first bought it under 50,000 mile warranty. I file an complain recall repair still having same problem. Sad thing my father is an retired employee in dallas location. Researched the recalls from previously and present same results. They have until 2 days to… Read more
Tranny, ABS, cooling system, tailgate, etc. I bought the truck 2003 didn't exchange title until later recall when I first bought it under 50,000 mile warranty. I file an complain recall repair still having same problem. Sad thing my father is an retired employee in dallas location. Researched the recalls from previously and present same results. They have until 2 days to contact me @ [xxx] in going to the warehouse and return the vehicle to the owner, cfo, ceo whomever and ask for a full refund or I'm filing an complaint and small clams for 30 yrs worth. [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6). *tr
Tl* the contact owns a 2001 Chevrolet Silverado 1500. The contact stated that while driving at 50 MPH, the vehicle emitted smoke. The contact stated there was excessive amounts of transmission fluid underneath the vehicle. The vehicle was towed to the residence. The contact inspected the vehicle and noticed that the transfer case was fractured around transfer case housing. The… Read more
Tl* the contact owns a 2001 Chevrolet Silverado 1500. The contact stated that while driving at 50 MPH, the vehicle emitted smoke. The contact stated there was excessive amounts of transmission fluid underneath the vehicle. The vehicle was towed to the residence. The contact inspected the vehicle and noticed that the transfer case was fractured around transfer case housing. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The approximate failure mileage was 200,000.
I started noticing rust spots on the body of the truck. Then I realized it was rusting out holes in the truck in certain areas. After I started noticing these spots, I was driving down the road towing my lawn equipment and heading to my next jobsite. When all the sudden I went to hit the brakes and nothing happened. The truck would not stop at all and course I was going down… Read more
I started noticing rust spots on the body of the truck. Then I realized it was rusting out holes in the truck in certain areas. After I started noticing these spots, I was driving down the road towing my lawn equipment and heading to my next jobsite. When all the sudden I went to hit the brakes and nothing happened. The truck would not stop at all and course I was going down hill. So I started to try and slow down the truck by downshifting to a lower gear and was able to slow down a few miles per hour but not near enough. As I was coming around a curve not long after the brakes started failing. Not to far in front of me was stopped traffic. I tried to do everything I could to stop but it was not enough. I only slowed down to 45 MPH before I was about to hit the back of a car head on. So I did the only other thing I could to maybe make it out without a fatal crash. I went off the road around the car and hit the parking brake and nothing happened because it failed as well. So I turned the truck real sharp to dodge the trees and slid sideways for a while and the truck finally came to a stop and I was so sick I had a bad panic attack and started throwing up and my heart felt like it was being hit by a hammer and my body hurt so bad from the truck coming to a stop and me slamming into the arm rest and the seat belt cut my neck stomach and chest. I got out and looked at my truck and noticed I hit a pile of logs and damaged my tires and the body of my truck in the several places. T
While attempting to shift from third to fourth the engine appeared to have a stuck throttle cable. Pulled the truck safely off the road and check the throttle cable making sure it was not broken or kinked. I restarted the truck and the rpms at idol were at 2000 and then I placed the truck into first gear and began to move forward towards my home. As I shifted from 1 to second… Read more
While attempting to shift from third to fourth the engine appeared to have a stuck throttle cable. Pulled the truck safely off the road and check the throttle cable making sure it was not broken or kinked. I restarted the truck and the rpms at idol were at 2000 and then I placed the truck into first gear and began to move forward towards my home. As I shifted from 1 to second the rpms began to rise. As I placed the truck into neutral the engine continued to increase in rpms to 3000 and then onto 4000. I placed the truck in neutral and allow the motion of the engine to push the truck forward and using the brakes I was able to keep speeds below 45 and when the truck came to a complete stop the engine rpms continued to rise above 4000. After getting the truck home and inspection of the throttle body, a half cup movable plate was found attached to the butterfly..this had prevented the butterfly to close and had torn from the butterfly plate. I have not found any documentation on this plate or cup on any sites nor is it mentioned in any owner manuals. I was lucky, but others who are not mechanically inclined may not know what to do or even an increase chance of an accident which could result in a death or injury. *tr
Transmission lost 1st and reverse. Spoke with transmission mechanic and learned that the GM 4l60e uses "pressed powdered metal" to manufacture the sunshell in the 4l60e. Learned that mechanics refer to the 4l60e transmission as a "140 thousand to 160 thousand mile part" requiring a very expense rebuild or replace. Also learned that aftermarket sunshells are available in case… Read more
Transmission lost 1st and reverse. Spoke with transmission mechanic and learned that the GM 4l60e uses "pressed powdered metal" to manufacture the sunshell in the 4l60e. Learned that mechanics refer to the 4l60e transmission as a "140 thousand to 160 thousand mile part" requiring a very expense rebuild or replace. Also learned that aftermarket sunshells are available in case hardened steel for about $50.00 usd. *js
This truck has been a nightmare concerning all aspects of braking system. First at 44,000 ABS sensors needed to be replaced, then at 53,400 all 4 new rotors and pads all the way around, 82,000 miles parking brake needs replaced, 81,000 front axle seal leaking, then at approximately 88,000 miles brake lines pops with trailer attached. Truck is towed to garage only to find… Read more
This truck has been a nightmare concerning all aspects of braking system. First at 44,000 ABS sensors needed to be replaced, then at 53,400 all 4 new rotors and pads all the way around, 82,000 miles parking brake needs replaced, 81,000 front axle seal leaking, then at approximately 88,000 miles brake lines pops with trailer attached. Truck is towed to garage only to find that brake lines are rusty and popped. All lines were supposed to be replaced total cost over $1,000. At 96,600 need front rotors and rear brakes, at 126,00 need rear rotors and front brakes and 1 original brake line from rear to front and right front that never was replaced. Cost 268.00. Used different garages for work and both have had trouble replacing hydraulic lines and one is a state inspection station. Braking system has cost me a fortune and I will not buy another chevy due to high repair cost. Truck was not neglected and serviced regularly. Had to replace transmission at 114,000 miles which left me stranded once again. *tr
While in motion, a component in the differential failed, creating an interference condition locking up my rear end. Luckily I was not traveling at highway speeds, and was just around town, traveling at about 30 MPH. There was no warning of parts failing. There was ample gear oil in the rear end, and maintenance was not a factor as I did a gear oil change this past summer. I… Read more
While in motion, a component in the differential failed, creating an interference condition locking up my rear end. Luckily I was not traveling at highway speeds, and was just around town, traveling at about 30 MPH. There was no warning of parts failing. There was ample gear oil in the rear end, and maintenance was not a factor as I did a gear oil change this past summer. I seldom use this vehicle to tow and it has never seen a plow or overly rough driving conditions. *kb
While making a turn rear end locked up. This caused the vehicle to pull hard, skid, and come to an abrupt halt. This problem was due to rear differential failure.*ak