Nov 9, 2012electrical system, exterior lighting, vehicle speed control
First driver side rear turn signal blinked rapidly, then brake light and turn light ceased to work. When checked, the light and lens were fused (melted) together. As well driver side window ceased to work. Mechanic stated its electrical and advised I check recalls.also sometimes gas pedal accelerates without pressure from me. No cruise control engaged, not able to determine… Read more
First driver side rear turn signal blinked rapidly, then brake light and turn light ceased to work. When checked, the light and lens were fused (melted) together. As well driver side window ceased to work. Mechanic stated its electrical and advised I check recalls.also sometimes gas pedal accelerates without pressure from me. No cruise control engaged, not able to determine when or why...just occasionally happens. *tr
NHTSA complaint #10483900
Feb 18, 2010vehicle speed control, equipment adaptive/mobility
I took my foot off the gas pedal to begin to slow as I approached a red light. The vehicle did not slow down but instead continued to accelerate, as the gas pedal was stuck down. I was surprised and pushed down on the brake pedal, and the car was able to stop. Once the light turned green and I took my foot off the brake, the car immediately began accelerating quickly… Read more
I took my foot off the gas pedal to begin to slow as I approached a red light. The vehicle did not slow down but instead continued to accelerate, as the gas pedal was stuck down. I was surprised and pushed down on the brake pedal, and the car was able to stop. Once the light turned green and I took my foot off the brake, the car immediately began accelerating quickly without touching the gas pedal, which was still stuck down. I pushed the gas pedal repeatedly with my foot until it became unstuck, and immediately drove to a nearby auto repair facility. The technician looked at the car and discovered that the gas pedal had stuck on the driver's floor mat, which appeared warped near the pedal area. Due to the indentation in the mat, it appeared that the pedal had been rubbing on the mat for some time before becoming totally stuck. There were no injuries, and I immediately removed the mat and have not had any problems since then. The floor mat is the original manufacturer mat supplied with the car. *tr
NHTSA complaint #10311647
Jul 17, 2006vehicle speed control
This 2000 Cavalier was purchased feb. 2006, the needle was going at a higher rpm constantly. Finally, the other day it went up 5000 rpm's. I brought the car to my garage and several valves were replaced. This did not correct the problem. The computer was just replaced. Hopefully the problem is solved. This is a dangerous situation. *jb
NHTSA complaint #10162684
Apr 29, 2004service brakes, hydraulic, vehicle speed control
While driving uphill at 20-25 MPH consumer noticed low traction indicator light flashing. Consumer depressed the accelerator pedal to gain speed and engine stalled. *ak
NHTSA complaint #10071837
Nov 5, 2003service brakes, hydraulic, vehicle speed control
While driving at slow a speed, the vehicle lurched forward and it felt like the vehicle was rear ended. The dealer refused to fix the vehicle and stated the vehicle was safe to drive. *ph the ABS sensor had become inoperative. *scc *jb
NHTSA complaint #10039847
Apr 16, 2003vehicle speed control
The vehicle experienced sudden acceleration. *jb
NHTSA complaint #10016028
Nov 18, 2002vehicle speed control
Speedometer stays at between 15 and 20 MPH when vehicle is not in motion. When driving at about 25 MPH, gauge says speed is 75mph. Other times, gauge stays at 0 and vehicle is in motion. Dt
NHTSA complaint #769838
Nov 13, 2002fuel system, other, vehicle speed control, unknown or other
Car was being driven on highway, accelerated beyond driver's control, with brakes applied driver put car in neutral, guided car off road and shut off engine. Mechanic where car was towed explained that the air filter cover had broken and a piece from air filter cover was sucked into air duct to throttle body causing throttle to be stuck open. Car is bifuel cng. Is this is a… Read more
Car was being driven on highway, accelerated beyond driver's control, with brakes applied driver put car in neutral, guided car off road and shut off engine. Mechanic where car was towed explained that the air filter cover had broken and a piece from air filter cover was sucked into air duct to throttle body causing throttle to be stuck open. Car is bifuel cng. Is this is a factor in air filter cover cracking? Is there parts tracking for replacement of air filter covers and is it known how many of those went to bifuel cars. Why is air filter cover cracking? Or is there a fix to prevent pieces from lodging in throttle? Dt
NHTSA complaint #769654
Jun 19, 2000vehicle speed controlCrash4 injured
Serious accident may be related to this or similar part. Was told car had accelerated quickly, and throttle increased rapidly.please investigate> I have seen several complaints on your web site with this type of problem.this may be a saftey problem. *ak
NHTSA complaint #724235