Jun 1, 2010vehicle speed control, equipment adaptive/mobility
The gas pedal hangs up on the floor carpet (the wear strip integrated into the carpet that is under the gas pedal and wraps up along the side of the transmission tunnel) when the gas pedal is pressed all the way to the floor. The shaft that the gas pedal is attached to has part of it sticking out past the gas pedal and has a sharp edge that snags the edge of the wear strip. … Read more
The gas pedal hangs up on the floor carpet (the wear strip integrated into the carpet that is under the gas pedal and wraps up along the side of the transmission tunnel) when the gas pedal is pressed all the way to the floor. The shaft that the gas pedal is attached to has part of it sticking out past the gas pedal and has a sharp edge that snags the edge of the wear strip. The carpet is not worn, it is in great shape, and is only getting damaged when the gas pedal snags the carpet wear strip. It has happened about a dozen times in the past 5 years. I contacted Chevrolet dealer and they never got back to me five years ago. In april 2010, it happened on a city street when I hit the gas to take evasive action to get away from another car that almost hit me in the side and the gas pedal stuck and I almost hit another car and a building. I contacted the Chevrolet dealer in sallisaw oklahoma, and they referred me to the Chevrolet hot-line for complaints. I contacted them and waited a week for them to get back to me like they said they would, and I contacted them again and they said that they would contact me within two weeks, and it has been another week past that time. I am afraid that maybe next time I wont be able to reach down and yank the pedal up where it is snagged on the carpet. *tr
NHTSA complaint #10334160
Feb 24, 2006steering, suspension, service brakes, hydraulic, vehicle speed control, tires
Front end, both wheel bearings at 60,000 miles, idler arm, replace tires, ABS light. *jb
NHTSA complaint #10151154
Nov 10, 2005engine and engine cooling, vehicle speed control
Dt: the contact stated the check engine light came and the engine started missing. The air reflector on the bottom of the throttle bottle plate disintegrated; the air reflector has gone through the motor. The plate was embedded in the pistons, broke two spark plugs, and bent push rods. He changed the spark plugs. He then pulled the vehicle in and realized the push rods and… Read more
Dt: the contact stated the check engine light came and the engine started missing. The air reflector on the bottom of the throttle bottle plate disintegrated; the air reflector has gone through the motor. The plate was embedded in the pistons, broke two spark plugs, and bent push rods. He changed the spark plugs. He then pulled the vehicle in and realized the push rods and lifters were bad. He contacted the dealer they offered no free remedy.*ak
NHTSA complaint #10142351
Jun 20, 2003vehicle speed control
Consumer stated that when trying to accelerate the pedal will stick in the idle position, causing a distraction to the consumer. Dealer notified. *ak
NHTSA complaint #10024550
Apr 18, 2003vehicle speed control
The vehicle experienced sudden acceleration going up to a speed of 80 MPH. This was an ongoing problem because each time the vehicle was fixed the problem would occur again. (re: odi#10013779) *mr *scc *nlm
NHTSA complaint #10015690
Aug 22, 2001service brakes, hydraulic, vehicle speed controlCrash
While applying brakes to stop vehicle it commenced to accelerate and ran into entrance door of a hotel. No injuries were reported.*ak
NHTSA complaint #894908